User Manual - Comkit Online
Contents
1. 5 Turn off gas taps Pilot tap 6 Clear tray underneath burners NOTICE PLEASE RETURN YOUR WARRANTY CARD FAILURE TO DO SO WILL VOID WARRANTY ON THE EQUIPMENT IM051B1 p6 Goldstein 5 MAINTENANCE MAINTENANCE PROCEDURE USE PROTECTIVE CLOTHING FOR CLEANING TO AVOID DANGEROUS CONTACT WITH HOT SURFACES 1 CAST IRON TRIVET Wash in WARM soapy water use Plastic Scourer if necessary Dry with soft cloth or paper towel STEEL PLATES To clean steel plates wash with cold water and cleanser while the plate is not Hot Use wire brush to remove accumulations or hardened grease around splash and gutter A Burner should be turned on low for the initial breaking in Gradually increase the heat until maximum temperature for heavy duty cooking has been reached B Care of top plate should be limited to periodic wiping off with rough cloth or burlap C Do not use water either hot or cold to clean plates STAINLESS STEEL Using a liquid cleaner indicated especially for this tyve metal can clean the stainless steel finish NEVER attempt to clean stainless steel with steel wool abrasive cloth or powders PERIODIC CLEANING Keep grease spillovers and other accumulations out of both top and oven burner boxes or areas The exterior painted surface of all appliances can be cleaned with warm water and soap or a mild detergent Removable drip or grease pans are easily cleaned with warm water and soap or a mild deterge2. Governor adjustment Remedy Replace Remedy Replace Remedy Refer to servicing instructions and clean Remedy Refer to Servicing instructions And adjust Remedy Check gas pressure and Jet orifice Remedy Adjust Remedy Adjust Goldstein 8 DRAWINGS MODEL SP 1855 WITH FLAME FAILURE DEVICE 7 H N 29 L 9 2 D SE J 229 NZ 15 14 4 16 ODE ARIATION PARTS 10 11 12 13 X EN Via N ad yW XM J IM051B1 p10 9 SPARE PARTS ITEM No oh gt IM051B1 p11 CODE SP185P07 MLEPLBF1 GP100001 MKNPLM21 GCKPF001 GIJCW105 GIJCW180 GBNCWOOO PFPTA002 PFPTAOO1 GIJCW170 GIJCW285 GCKCWOOO MKNSSCK1 GCKCWPO2 GPI000A4 GTC00450 GCKGRO001 GPI00002 Goldstein MODEL SP 1855 DESCRIPTION DRIP TRAY FEET PLASTIC BULLET 2D PILOT PFB BURNER SINGLE KNOB GASCOCK GCKPF001 GCKGROO1 PF BOIL GASCOCK BOILING TOP BURNER INJECTOR SP1855 INNER RING 1 05mm L P INJECTOR SP1855 INNER RING 1 80mm BURNER CW 52 75 ALUMINIUM REAR PILOT TUBE ALUMINIUM FRONT PILOT TUBE INJECTOR SP1855 OUTER RING 1 70mm L P INJECTOR SP1855 OUTER RING 2 85mm GASCOCK CW KB135B KNOB CHROME METAL CW CHD GASCOCK GCKC GASCOCK PILOT TOP PT42 PILOT ASSY WOK RANGE THERMOCOUPLE L 450mm GASCOC
3. K PEL21S 2 WAY PILOT ASSEMBLY Goldstein 10 WARRANTY Installation must be carried out according to local regulations by qualified trade persons Isolating switch es shut off valves etc must be within easy reach of the machine for future service and maintenance requirements If in doubt call GOLDSTEIN ESWOOD or their representative for further information No responsibility will be accepted for defects or damages by improper installation for changes to the product not authorised by GOLDSTEIN ESWOOD or for operation outside the technical specifications GOLDSTEIN ESWOOD warrants their products to be free from defects in material and workmanship under normal use and service This does not include normal wear and tear of parts GOLDSTEIN ESWOOD will repair or replace any parts which in GOLDSTEIN ESWOOD s sole judgement are defective in material or workmanship in accordance with the warranty offered This undertaking covers the provision of labour and parts for 12 months from the date of delivery to the purchaser This undertaking applies only to state capitals Remote areas are not covered by this commitment and special enquiries should be made Note Travel time not covered by warranty To the maximum extent permitted by law any liability on Goldstein Eswood s part or on the part of its servants or agents for loss or damage of any kind whatsoever in connection with the products including liability for or in respect o
4. STOCK POT BOILING TABLE MODEL PROUDLY AUSTRALIAN MADE INSTALLATION PROCEDURE USER MANUAL SERVICE INSTRUCTION MODEL SP1855 SP 1855 G ol dste n 1911 The Cooking Equipment Professionals www goldsteineswood com au Goldstein TABLE OF CONTENTS Loo E 1 INTRODUCTION Page 3 2 INSTALLATION Page 4 3 COMMISSIONING Page 5 4 OPERATING INSTRUCTIONS Page 6 5 MAINTENANCE Page 7 6 TECHNICAL DATA Page 8 7 PROBLEM SOLVING Page 9 8 DRAWINGS Page 10 9 SPARE PARTS Page 11 10 WARRANTY Page 12 11 BRANCHES Page 13 IM051B1 p2 Goldstein Congratulations for purchasing your Goldstein commercial cooking appliance J Goldstein amp Co is a wholly owned Australian company and has been operating since 1911 building high quality products The information in this manual will assist your installer and ensure correct location and connection Thoroughly read the user instructions and the user maintenance sections as understanding your products its operation and its cleaning and service requirements will provide you with long and satisfactory service Failure to do so could shorten the life of the product and decrease its efficiency Please ensure only authorised service technicians are called to any difficulties that may arise INTRODUCTION GOLDSTEIN STOCK POT BOILING TABLE MODEL MODEL SP1855 GOLDSTEIN STOCK POTS are designed to give long and satisfactory service and incorporate the best possible materials and
5. dance with the regulations of the local Gas Authority AS5601 AG601 and any other authority having jurisdiction The appliance has been tested and preset before leaving our Factory but small adjustments may be necessary to suit pressure supply Correct operation of the appliance must be tested as part of the installation procedure Have a licensed gas fitter or your Gas Company connect the appliance to the Gas Supply INSTALLATION All equipment must be sitting level for proper operation and combustion where plinth type installation is made plinth height and front overhang must be 50 mm minimum Levelling can be made by the use of metal shims For performer series where adjustable legs are provided levelling can be made easily due to the threaded construction of the legs 25mm 50mm level left to right Connection to main gas line should be made by licensed Gasftiier Install a hand shut off valve in gas line to the appliance manifold GOVERNOR The governor is supplied as a separate item and must be connected into the supply to the appliance by a licensed gas plumber It should be fitted as close as possible to the appliance inlet NOTE Models operating on LP Gas will be supplied with a regulator as from 1 January 2005 as new standard AS4563 AG300 LIGHTING INSTRUCTIONS Turn the pilot tap on Light the pilot Pilot is now left in the on position Check gas tap to check safety turn the knob to the left to the on posit
6. f any claim arising out of contract negligence or statute shall not in any event exceed 100 Labour under warranty is supplied free of charge during normal working hours Monday to Friday Should warranty work be requested outside of our normal working hours a labour charge will be applied equivalent to a normal hour rate without out of hours penalty rates Refer to last page of this manual for your closest branch for warranty repair services IM051B1 p12 10 J GOLDSTEIN amp CO PTY LTD BRANCHES Goldstein For inquiries please call your nearest state branch Head Office 211 213 Woodpark Road New South Wales 2564 Phone 02 9604 7333 Fax 02 9604 5420 Victoria Queensland Unit 13 Unit 3 260 264 Wickham Road 49 Logan Road Moorabbin Woolloongabba Victoria 3189 Queensland 4102 Phone 03 9553 1488 Phone 07 3891 1466 Fax 03 9553 0785 Fax 07 3393 1333 South Australia Suite 26 283 287 Sir Donald Bradman Drive Brooklyn Park South Australia 5032 Phone 08 8238 3423 Fax 08 8238 3400 IM051B1 p13 Western Australia 10 Wittenberg Drive Canning Vale Western Australia 6155 Phone 08 9456 0559 Fax 08 9456 0554
7. ion and burner will ignite Fs IM051B1 p4 Goldstein 3 COMMISSIONING COMMISSIONING APPLIANCE DETAILS TESTING CHECKING PRESSURE ETC COMMISSIONING CHECK LIST 1 _ CHECK FOR DAMAGE AND MISSING PARTS 2 REMOVE ALL PLASTIC COATING FROM S STEEL PANELS 3 MAKE SURE ALL PARTS ARE IN THEIR CORRECT POSITION E G TRAYS BURNERS KNOBS 4 MAKE SURE ALL ELECTRIC AND GAS CONNECTIONS ARE CORRECT AND TIGHT 5 LEVEL OFF UNIT LEFT TO RIGHT AND ALSO MAKE SURE THAT FRONT IS JUST 3 4 MM LOWER TO ALLOW FOR FLUING 6 TURN ON GAS OR ELECTRICITY 7 ADJUST GAS PRESSURE WITH THREE QUARTERS OF THE UNIT RUNNING ADJUST GAS PRESSYRE NATURAL GAS 1 00 KPA LPG 2 75 KPA 8 TURN ON ONE AT A TIME TO MAKE SURE ALL IS WORKING E G BURNER RADIANT GRIDDLE AND OVEN 9 SHOW CUSTOMER A HOW TO WORK EQUIPMENT B HOW TO CLEAN C HOW TO PULL IT APART E G TRAYS TRIVETS BURNERS D ALSO WHAT NOT TO DO E G WATER WITH ELECTRICAL GREASE AND OIL IN CONTROLS 10 CHECK TO MAKE SURE MANUALS AND WARRANTY CARDS ARE THERE ALSO GO THROUGH MANUAL WITH CUSTOMER E G LIGHTING CLEANING CHECK LOOSE ITEMS ON THE BACK OF WARRANTY CARD NOTE WASH HOSES SHOULD NEVER BE USED ON THE APPLIANCE USE OF HOSES WILL VOID WARRANTY IM051B1 p5 Goldstein See ZZ 1 Turn on pilot knob manually light Pilot 2 Pilot can stay on all day 3 Turn inside or outside or both taps on burners will ignite 4 Turn down to required flame flow
8. nt OPERATIONAL PROBLEMS AND SERVICE No service is anticipated However should the occasion arise that service is required call a qualified gas service organisation or your local gas utility service department DO NOT USE STEEL WOOL ABRASIVE CLOTHS CLEANSERS OR POWDERS If it is necessary to scrape stainless steel to remove encrusted materials soak the area with hot cloths to loosen the material and then use a wood or nylon scraper DO NOT USE a metal knife spatula or any other metal tool to scrape stainless Steel Scratches are almost impossible to remove IM051B1 p7 Goldstein Stee NOMINAL HOURLY GAS CONSUMPTION GAS TYPE BURNER _ INJECTOR MJ kPa Outer Ring 2 83 Inner Ring 1 03 Outer Ring 1 75 IM051B1 p8 Goldstein 7 PROBLEM SOLVING 1 Pilot outage a b or Cause Fluctuating pressure Cause Contamination of pilot orifice Cause Extreme over gassing of main Burner Cause Defective thermocouple Cause Defective safety shut off valve Cause Poor connection between thermocouple lead and valve 2 Burner goes out and flashes back a Cause Excessive aeration 3 Yellow Flame a burner b Cause Too much gas to burner Cause Insufficient aeration 4 Harsh noisy flame a IM051B1 p9 Cause Excessive aeration Remedy Fit or adjust governor Remedy Clean pilot orifice Remedy Check burner jet orifice size
9. workmanship Proper installation adjustment and preventative maintenance are vitally important if efficiency and appearance are to be maintained Read these instructions carefully as they contain important safety information regarding the installation use and maintenance of the appliance RECEIVING INSPECTION Please follow these instructions carefully e Remove cartons from unit and check for any damages e Report any damages to the transport company or your dealer e Remove check all loose items from unit and check contents as found on back of warranty cards Lift off base and screw the adjustable legs on the unit Set unit into correct position Check type and capacity of gas supply The type of gas for which this SP 1855 is factory adjusted can be seen on the rating plate located on the bottom front panel of the Stock Pot IM051B1 p3 Goldstein RECEIVING INSPECTION PRE INSTALLATION e Adjust feet till they are touching the floor and using a spirit level level from left to right e Also adjust front to back with a fall of about 2 3mm to the front to help fluing of the unit e This operation is important as variation of 25mm to 76mm in a floor level is found to be common e Make sure unit is under an exhaust hood that provides adequate ventilation e Check data plate to ensure appliance is suitable to the gas that it is being connected to e Note The appliance must be installed by an Authorised person and in accor
Download Pdf Manuals
Related Search