Chordette scamp manual
Contents
1. Bridging Switch The Scamp features an internal bridging function which can be activated with this switch Gain Control Use this to adjust the volume level when an external preamplitier is not being used Using USB digital Connect your personal computer via an A to B type USB cable The Scamp will automatically be recognised by the computer as a USB DAC Using the sound options on the computer you can select the USB DAC sound device to output audio to the Scamp Using the Bridging Function When the bridging switch is pressed the Scamp becomes a high power mono amplifier VVhen using this mode the connections need to be made differently Only one input is required this can be left or right depending on which speaker you want to connect to The speaker then connects to the red terminals only The positive speaker connection should go to the right red terminal and the negative speaker connection should go to the left red terminal Do not connect to the black binding posts Repeat this procedure for the other amplifier You will now have two bridged mono block amplifiers with an 8OW output Automatic Overload shutdown If the Scamp is overdriven or the volume is turned up too high then the amplifier will go into shutdown mode where the music will sound quieter and distorted This is to protect both the amplifier and speakers Simply reduce the volume until you can hear the music clearly again Specifications Pre Amp Section Unbalanced Inp2. Instruction Manual Chordette 9 CAMP Stereo Power Amplifier Thank you for purchasing the Chordette Scamp In order to get the most from your product please take a few moments to read these instructions Connections The Scamp can be connected to an analogue source via the RCA phono connectors or fo a computer via the USB connection In these cases the built in volume control can be used to adjust the volume The Scamp can also be connected to a preamplifier such as the Chordette Prime via the RCA phono connectors but in this case the Scamp gain control should be set to maximum The speakers connect to the gold plated binding posts red for positive and black for negative There is a 12V power output socket that can be used to power other items in the Chordette range from the one Scamp power supply The high current Scamp power supply should be connected to the 4 pin power connector last once all other connections are made y USB Audio input 6 Connect to a computer 4 12V DC 8A power input Connect to the Scamp power supply 12V DC power output connector Use to power other items in Chordette range Bridging switch Inout select switch Gain control Left speaker output Right speaker output Input Selection The input switch allows you to change between the analogue RCA phono input switch out and the USB input switch in Set this switch according to which input you would like to listen to Chordette
3. ut Digital Input Gain Power Amp Section Output Power Frequency Response Signal To Noise Ratio Channel Separation Output Impedance Output Inductance Output Connections Slew rate Stability Power Supply Dimensions Weight 1 pair RCA phono USB 44 48KHz USB 2 0 Compliant Variable manual volume control 2 x AOW rms per channel 0 05 distortion into 4 Ohms 1 x 80W rms bridged mono 0 05 distortion into 4 Ohms 1dB 0 8Hz to 46kHz 8 Ohms 3dB 0 8Hz to 77ZkHz 8 Ohms 1dB 0 8Hz to 39kHz 4 Ohms 3dB 0 8Hz to 75kHz 4 Ohms Better than 103dB A weighted two thirds 80qB ORONO inks 2 6mH 4 x gold binding posts ZOV per pS 1kHz 20V square wave Unconditional 12V 8A 160 x 70 x 40mm Width x Height x Depth ORANG Made in England by Chord Electronics Ltd CHORD O Chord Electronics Limited www chordelectronics co uk
Download Pdf Manuals
Related Search