Stainless Steel Counter Top Servery/Prep Refrigerators
Contents
1. C 10 x gastronorm 1 3 Container R134a 1559 435 x 2000 x 380 37 Electrical Wiring The plug is to be connected to a suitable mains socket POLAR appliances are wired as follows e Live wire coloured brown to terminal marked L e Neutral wire coloured blue to terminal marked N e Earth wire coloured green yellow to terminal marked E All POLAR appliances must be earthed using a dedicated earthing circuit If in doubt consult a qualified electrician Electrical isolation points must be kept clear of any obstructions In the event of any emergency disconnection being required they must be readily accessible Compliance The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste To help prevent possible harm to human health and or the environment the product must be disposed of in an approved and environmentally safe recycling process For further information on how to dispose of this product correctly contact the product supplier or the local authority responsible for waste disposal in your area POLAR parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international independent and federal authorities POLAR products have been approved to carry the following symbol Nix All rights reserved No part of these instructions may be produced or transmitted in any form or by any means electronic mechani2. Pov Stainless Steel Counter Top Servery Prep Refrigerators REFRIGERATION i Instruction manual Model e G608 G609 G610 G611 GD875 GD876 GD877 GD878 Safety Tips e Position on a flat stable surface e A service agent qualified technician should carry out installation and any repairs if required Do not remove any components or service panels on this product e Consult Local and National Standards to comply with the following e Health and Safety at Work Legislation e BS EN Codes of Practice e Fire Precautions e IEE Wiring Regulations e Building Regulations e DO NOT use jet pressure washers to clean the appliance e DO NOT use the appliance outside e DO NOT use this appliance to store medical supplies e DO NOT use electrical appliances inside the appliance e g heaters ice cream makers etc e DO NOT stand or support yourself on the base drawers or doors e DO NOT allow oil or fat to come into contact with the plastic components or door seal Clean immediately if contact occurs e Bottles that contain a high percentage of alcohol must be sealed and placed vertically in the refrigerator e Always carry store and handle the appliance in a vertical position and move by holding the base of the appliance e Always switch off and disconnect the power supply to the unit before cleaning e Keep all packaging away from children Dispose of the packaging in accordance with the regulations of local authorities e If th
3. appliance if applicable The discharge outlet is blocked Clear the discharge outlet Movement of water to the drain is obstructed Clear the floor of the appliance if applicable The water container is damaged Call POLAR agent or qualified Technician The drip tray is overflowing Empty the drip tray if applicable The appliance is unusually loud Loose nut screw Check and tighten all nuts and screws The appliance has not been installed in a level or stable position Check installation position and change if necessary Technical Specifications Model Voltage Power Current rn Capacity Refrigerant H SWD boll E 6608 230V50Hz 150W 1A 2 CtoT8 C 5xgastronorm 1 4 Container R134a 1209 435x1200x380 25 G609 230V 50Hz 150W 1A 2 C toT 8 C 7 x gastronorm 1 4 Container R134a 130g 435 x 1500 x 380 29 G610 230V 50Hz 150W 1A 2 C toT 8 C 9 x gastronorm 1 4 Container R134a 145g 435 x 1800 x 380 32 6611 230V50Hz 230w 1 6A 2 CtoT 8 C 10x gastronorm 1 4 Container R134a 1559 435x 2000x380 34 GD875 230V 50Hz 150W 1A 2 C toT 8 C 5 x gastronorm 1 3 Container R134a 120g 435 x 1200 x 380 28 GD876 230V 50Hz 150W 1A 2 C toT 8 C 7 x gastronorm 1 3 Container R134a 130g 435 x 1500 x 380 31 GD877 230V 50Hz 150W 1A 2 C toT 8 C 9 x gastronorm 1 3 Container R134a 145g 435 x 1800 x 380 35 GD878 230V 50Hz 230W 1 6A 2 C toT 8
4. cal photocopying recording or otherwise without the prior written permission of POLAR Every effort is made to ensure all details are correct at the time of going to press however POLAR reserve the right to change specifications without notice DECLARATION OF CONFORMITY Equipment Type Refrigerated Countertop Servers Model GD875 A GD876 A GD877 A Legislation C Tick ASINZ 3820 Essential Safety Requirements for Low Voltage Electrical Equipment Standards ASINZS CISPR 14 1 2010 ASINZS 60335 2 89 2010 Producer Name POLAR Producer Address 15 Badgally Road Campbelltown NSW 2560 I the undersigned hereby declare that the equipment specified above conforms to the above Legislation and Standard s Date 13 11 12 Signature t VI Full Name Richard Cromwell Position Marketing Director e Notes e POLAR REFRIGERATION G608_G611_GD875_GD878_DIX_ML_v2
5. e power cord is damaged it must be replaced by a POLAR agent or a recommended qualified technician in order to avoid a hazard Product Description GD875 A POLAR 5 x 1 3 Container Refrigerated Counter Top Servery Prep GD876 A POLAR 7 x 1 3 Container Refrigerated Counter Top Servery Prep GD877 A POLAR 9 x 1 3 Container Refrigerated Counter Top Servery Prep Introduction Please take a few moments to carefully read through this manual Correct maintenance and operation of this machine will provide the best possible performance from your POLAR product Pack Contents The following is included e POLAR Refrigerator e Brackets x 7 e Top glass panel e Grub screws x 7 e Rear glass panel e Screws x 12 e Side glass panels x 2 e Plugs x 14 e Instruction manual e Gastranorm adaptor bar e Collars x 6 e Adjustable feet x 4 POLAR prides itself on quality and service ensuring that at the time of packaging the contents are supplied fully functional and free of damage Should you find any damage as a result of transit please contact your POLAR dealer immediately Installation A Note If the unit has not been stored or moved in an upright position let it stand upright for approximately 12 hours before operation If in doubt allow to stand I Remove the appliance from the packaging Make sure that all protective plastic film and coatings are thoroughly removed from all surfaces 2 Maintain a distance of 20cm 7 inches between th
6. e unit and walls or other objects for ventilation Increase this distance if the obstacle is a heat source Note Before using the appliance for the first time clean the shelves and interior with soapy water 3 Level the appliance by adjusting the screw feet Fit Glass Panels I Screw the collars to the rim of the appliance Note Ensure the hole in the collar for the grub screw faces inwards 2 Slot the two side panels into the collars with the holes in the glass at the top Note Ensure the screw hole furthest from the edge of the panel goes to the back of the appliance 3 Screwa grub screw into each collar to secure the panels Note Ensure the soft end of the grub screw is the end making contact with the glass 4 Slotthe rear panel into the collars with the holes in the glass at the top 5 Screwa grub screw into each collar to secure the panel 6 Slot the plastic plugs into each of the holes 7 Screw the brackets to the inside of each pane using the bolt assemblies Note Ensure the short end of the bolt assembly is on the outside of the panels 8 Place the top panel onto the brackets ensuring all holes line up 9 Insert the plugs and attach the top panel to the brackets with the bolt assemblies Bracket gt Glass Panel Bolt Assembly gt Operation Storing Food To get the best results from your POLAR appliance follow these instructions e Only store foodstuffs in the appliance w
7. hen it has reached the correct operating temperature e Ensure gastronorm bays are full at all times even if the gastronorms are unused or empty Empty bays will greatly reduce efficiency of the appliance e Do not obstruct the fans inside the appliance Telephone Helpline 0845 146 2887 United Kingdom Turn On I Ensure the power switch is set to O and turn on at the socket 2 Switch on the Power 1 The current temperature within the appliance is displayed Control Panel Set the Operating Temperature I Press the ser button The display will flash 2 Press the or buttons to display the required temperature 3 Press the ser button to store the temperature Manual Defrost Press and hold the defrost button HE kull Cleaning Care amp Maintenance e Switch off and disconnect from the power supply before cleaning e Clean the interior of the appliance as often as possible e Do not use abrasive cleaning agents These can leave harmful residues e Clean the door seal with water only e Always wipe dry after cleaning e Do not allow water used in cleaning to run through the drain hole into the evaporation pan e Take care when cleaning the rear of the appliance Sharp edges can cut e A POLAR agent or qualified technician must carry out repairs if required Cleaning the Condenser Periodically cleaning the condenser can extend the life of the appliance POLAR recommend that a POLAR agent or qualif
8. ied technician clean the condenser Troubleshooting for 2 seconds to begin a manual defrost The defrost light illuminates If your POLAR appliance develops a fault please check the following table before making a call to the Helpline or your POLAR dealer Fault The appliance is not working The appliance turns on but the temperature is too high low Probable Cause The unit is not switched on Plug and lead are damaged Fuse in the plug has blown Power supply Internal wiring fault Too much ice on the evaporator Action Check the unit is plugged in correctly and switched on Call POLAR agent or qualified Technician Replace the fuse Check power supply Call POLAR agent or qualified Technician Defrost the appliance Condenser blocked with dust Doors are not shut properly Appliance is located near a heat source or air flow to the condenser is being interrupted Call POLAR agent or qualified Technician Check doors are shut and seals are not damaged Move the refrigerator to a more suitable location Ambient temperature is too high Increase ventilation or move appliance to a cooler position Unsuitable foodstuffs are being stored in the appliance Remove any excessive hot foodstuffs or blockages to the fan Appliance is overloaded Reduce the amount of food stored in the appliance The appliance is leaking water The appliance is not properly levelled Adjust the screw feet to level the
Download Pdf Manuals
Related Search