Volta Barrel Vacuum Cleaner UMO1540 User Manual
Contents
1. MobiONE Instruction Manual UMO1540 IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE When using an electrical appliance basic precautions should always be followed including the following Before connecting the cleaner to an electrical supply outlet ensure that the voltage marked on the rating plate on the underside of the cleaner is correct for your electrical supply If it does not comply do not use the cleaner prior to contacting the manufacturer WARNING To reduce the risk of fire electric shock or injury 1 Do not leave vacuum cleaner when plugged in Unplug from outlet when not in use and before servicing 2 To reduce the risk of electric shock do not use outdoors or on wet surfaces 3 This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance 4 Use only as described in this manual Use only manufactures recommended attachments 5 Do not use with damaged cord or plug If vacuum cleaner is not working as it should has been dropped damaged left outdoors or dropped in water take it to a service centre before using 6 Do not pull or carry on cord or use a2. can help prevent potential negative consequences for the environment and human health For more detailed information about recycling please contact your local city council MAINTENANCE TROUBLESHOOTING You can perform your own troubleshooting at home based on the checklist given in this section However if the problem persists please contact Electrolux on 1300 366 366 AUS or 0508 730 730 NZ PROBLEM POSSIBLE CAUSES CORRECTIONS Vacuum cleaner Plug is not properly connected to Check the plug connection or try another does not start the socket socket Thermal protector activated due Press the On Off button and wait 20 30 to high temperature minutes for the motor to cool down Filter indicator light Dust container is full Empty the dust container Stays on e ssns Filters are clogged Clean or replace filters Reduction of Suction hose is blocked Clean the hose suction capacity 2 A epi spt ee A eta eee at ee pines eed ones Nozzle is blocked Clean the nozzle Dust container is full Empty the dust container Filters are clogged Clean or replace filters Hose is damaged or broken Change the hose Over heating Dust container is full Empty the dust container Filters are clogged M Clean or replace filters KEEP THIS FOR YOUR RECORDS To be completed by the Purchaser Retailers Name Retailers Address Attach Your Purchase Receipt Here Electrolux Home Product
3. nozzle For corners between cushions and difficult to reach places Upholstery nozzle For upholstered furniture and curtains Combination floor nozzle Can be set for hard floors or carpets The combination floor nozzle can be set for hard floors or carpets Press the foot operated toggle lever on the floor nozzle to select the desired setting When the floor nozzle is set for hard floors the bristles will extend beyond the base of the floor nozzle When the floor nozzle is set for carpets the bristles will be retracted Maintenance EMPTYING THE DUST CONTAINER Note Before removing the dust container switch off the appliance and disconnect the flexible hose e Remove the dust cup by pushing the open buttons on the dust container handle Remove the content of the dust cup by pushing the opening button The dust container is a detachable unit Hold the base of the dust cup with one hand and open the dust container by pushing the opening button with the other hand e Empty the dust container DA To close the dust container ensure that hinge is securely fasten before you locked the cover Replace the dust container always operate the appliance with the dust container properly installed REPLACING AND CLEANING THE MOTOR FILTER AND EXHAUST FILTER Filter for air inlet should be cleaned at least twice a year or when it becomes visible solid Always operate the cleaner wit
4. acing insulation barriers between the electrical and mechanical components making it unnecessary for the cleaner to be earthed WARNING On collection of proprietary carpet conditioning powder it is recommended that the dust container is emptied and the cartridge filter is cleaned after each use Some of the preparations contain substances which if left in the vacuum cleaner for extended periods could cause damage Many air fresheners household deodorants sprays and polishes contain highly inflammable gas propellants because of this it is particularly important that these products are used strictly in accordance with the relevant manufacturers instructions it is essential that none of the above products are sprayed directly into the vacuum cleaner or any of the filters hose assembly or dust chamber PARTS IDENTIFICATION Parts and Accessories ASSEMBLING THE VACUUM CLEANER Quick Guide BEFORE STARTING e On first removing the product from its packaging check for any damages e Check that the dust container and the filters are in place Never operate the cleaner without the dust container installed e Always remove the plug from the power supply before fitting or removing any accessories ASSEMBLING THE VACUUM CLEANER Fitting or removing the flexible hose Fitting extension tubes and accessories 1 Handle 2 On Off Switch 3 Cord Winder 4 Wheel Extension Tube 5 Dust Cup Floor Nozzl
5. e L 7 6 Remote Control as 7 Flexible Hose ER 8 Extension Tube Ei E E m dels wiihielses leiubes e Insert the hose until the catch e Attach the extension tubes or a clicks to engage press the catch to telescopic tube only on certain 9 Telescopic Tube release the hose models to the hose handle 10 11 10 Floor Nozzle 11 Hard Floor Nozzle e Fit the extension tube to the floor noozle 12 Combined Crevice and Brush 12 Nozzle and Upholstery Nozzle Certain models only Line drawings are solely for illustration purposes and may vary from actual product Line drawings are solely for illustration purposes and may vary from actual product 2 3 INSTRUCTION FOR USE INSTRUCTION FOR USE MAINTENANCE Instruction for Use SWITCHING ON Extend the cord and plug it into the wall socket A yellow mark on the power cable shows the ideal cable length Don t extend the cable beyond the red mark e Press the On Off button to switch the unit on lo stop press the button again R On Off switch 7 Yellow Mark Red Mark e To retract the cord switch off the appliance and unplug it from the wall socket The vacuum cleaners has an integrated cord winder To rewind the cable press the foot pedal gently and guide the cord by one hand this will prevent it striking you or damaging the cleaner ACCESSORIES Use the appropriate accessory according to the object s to be cleaned Crevice
6. h filters To avoid reduced suction or motor damage Remove the dust container as described in the previous section There are two pre motor filters in this vacuum cleaner a spongy grey protection filter and the framed filter Remove the filter frame from the container by pulling on the release tab on the top right side of the filter frame Remove the grey protection filter by simply pulling it loose from the container MAINTENANCE Tap the filter face down on a flat surface covered with a sheet of paper This will dislodge excessive residue from the filter Dispose of the cover sheet with the dust residue Gently beat the grey protection filter in an open air space to properly dislodge any dust If necessary both the HEPA filter and grey protection filter can be washed under a tap with cold water Always wash the filter from the underside do not scrub of use cleaning agents on the filter Do not use a washing machine to wash the filter Air dry both the filters for 24 hours to ensure it is completely dry before reusing Avoid direct sunlight or extreme drying conditions Do not use hair dryer to dry the filters e Refit the grey protection filter by aligning it with the dust container and sitting it in place then fit the filter in frame by aligning the frame with the dust container and simply sliding it into place e When fitted correctly a safety device will allow the dust container to f
7. it back into the dust container only if the filter is properly installed If dust container do nat fit into the dust compartment do nat force it and check if filter is properly installed e lf either of the filters appear damaged do not re use them CHANGING THE EXHAUST FILTER e Open the filter grill Remove the exhaust filter Rinse it under tap water and dry it completely Put the filter back into the cleaner Close the filter grill How To Store Your Vacuum 1 Choose a storage location that is both safe and dry 2 Depending on the space available you can choose to store it in an upright or horizontal position using the parking slots 3 Be careful not to trap twist or tie the electrical cord Wind it 4 Keep the extension tubes nozzles and hose together to avoid misplacing them Disposing Your Vacuum PACKAGING MATERIAL The packaging materials are environmentally friendly and can be recycled The plastic components are identified by markings e g gt PE lt gt PS lt Please dispose of the packaging materials in the appropriate container at the community waste disposal facilities OLD APPLIANCE The symbol E on the appliance or its packaging indicates that this product may not be treated as household waste Instead it should be handed over to the applicable collection point for the recycling of electrical and electronic equipment By ensuring that this product is disposed of correctly you
8. s Pty Ltd ABN 51 004 762 341 163 O Riordan Street Mascot NSW 2020 Australia Customer Service Ph 1300 366 366 www electrolux com Electrolux Small Appliances A division of Electrolux NZ Limited 3 5 Niall Burgess Road Mt Wellington Auckland New Zealand Ph 09 9573 2220 Customer Service Ph 0508 730 730 www electrolux com Some models may be limited in availability or be available from certain stores only Not all models and specifications are available at time of printing and not all models are available in Australia amp New Zealand See your local Electrolux retailer or call the above phone numbers for further information if required Due to the Electrolux policy of continual product development specifications colours and details of our products and those mentioned in this manual are subject to change without notice 2 From the Electrolux Group
9. s a handle Do not close door on cord or pull around sharp edges or corners Do not run vacuum cleaner over cord Keep cord away from heated surfaces 7 Do not unplug by pulling on the cord To unplug grasp the plug not the cord 8 Do not handle the plug or vacuum cleaner with wet hands 9 Keep hair loose clothing fingers and all parts of body away from openings and moving parts 10 Turn all controls off before unplugging 11 Do not use to pick up flammable or combustible liquids Such as gasoline or use in areas where they may be present 12 Do not pick up anything that is burning or smoking such as cigarettes matches or hot ashes 13 Do not use without dust container and or filter in place 14 Do not use extension cords or outlets with inadequate current carrying capacity 15 We recommend you do not use your vacuum on carpet cleaning foams sharp or heavy building materials or plaster dust They could damage or clog the filters and cause failures to other key parts in your vacuum cleaner and render your warranty invalid 16 Store your cleaner indoors in a cool dry area 17 Unplug electrical appliances before vacuuming them 18 Please remove the plug from the socket outlet before cleaning or maintaining this appliance ELECTRICAL CABLE PRECAUTIONS e f the supply cord is damaged it must be replaced by the manufacturer its service agent or similarly qualified person in order to avoid a hazard Damage
10. to the cleaner cable will not be covered by the warranty e Never pull or lift the vacuum cleaner by the cable e Disconnect the plug from the wall socket before cleaning or maintaining the vacuum cleaner e Regularly check that the cable is not damaged Never use the vacuum cleaner if the cable is damaged All service and repairs must be carried out by an authorised Electrolux service centre Always keep the vacuum cleaner in a dry place SERVICE amp REPAIR It is dangerous to alter the specifications or modify the product in any way Under no circumstances should you attempt to repair the cleaner yourself NEVER VACUUM e In wet areas e Close to flammable gases combustible substances etc e Without a cartridge filter this maydamage the cleaner and without the dust container A safety device is fitted which prevents the cover to close without the filter Do not attempt to force to close the cover e Sharp objects e Fluids this can cause serious damage to the machine e Hot or cold cinders lit cigarette butts etc e Fine dust from plaster concrete or ash for example The above can cause serious damage to the motor damage which is not covered by the warranty Products in aerosol may be flammable Do not spray these products on or near the vacuum cleaner DOUBLE INSULATION Your vacuum cleaner is double insulated This means that all external parts are electrically insulated from the mains This is done by pl
Download Pdf Manuals
Related Search