USER MANUAL - CNET Content Solutions
Contents
1. USER MANUAL 4 r J 3 Lu 2 5 4 r 7 0 HOOVER cigarette ends or other similar items Do not spray with or pick up flammable liquids cleaning fluids aerosols or their vapours Do not run over the power cord when using your appliance or remove the plug by pulling on the power cord Do not continue to use your appliance if it appears faulty Hoover service To ensure the continued safe and efficient operation of this appliance we recommend that any servicing or repairs are only carried out by an authorised Hoover service engineer Do not stand on or wrap the cord around arms or legs when using your appliance Do not use the appliance to clean animals or people When using the cleaning tools ensure to always steady the appliance with your other hand This will ensure that the appliance does not fall while in use WARNING A thermal cut out switches off the appliance to prevent overheating if it is used when full or there is a blockage or dirty filters If this should happen then switch off unplug and correct the fault It will take approximately 45 minutes for the cut out to automatically reset be treated as household waste Instead it must be handed over to the h applicable collection point for the recycling of electrical and electronic equipment Disposal must be carried out in accordance with local ua environmental regulations for waste disposal For2. crevice tool to the end of Rotate the end piece of the Fit the pet hair amp allergen the removable handle crevice tool to use the dusting remover and parquet 22 6 brush IMPORTANT When using cleaning tools the cleaner must be kept in the upright position particularly when cleaning stairs The nozzle height should also be set to tool mode Certain models only 5 To remove the dust container from the EMPTYING THE DUST CONTAINER CLEANING THE PRE MOTOR FILTERS cleaner press the bin release button Rotate the upper part of the Remove the filter assembly Remove the mesh filter from dust bin to open from the upper part the filter assembly Hold the container over the bin and press the bin open button 6 52 0 Gently tap both filters to release any Wash both filters under hand warm water until the excess dust water runs clean Remove excess water by shaking and leave to dry for 24 hours IMPORTANT Ensure the mesh sleeve is When completely dry reassemble and refit filters to The dust container door reassembled to the HEPA filter before use cleaner will open and you can empty with no contact with the dust CLEANING THE EXHAUST FILTER The exhaust filter should be washed every month Press down on the latch to remove the exhaust cover Remove filter and wash with warm water 0 Once emptied gently tap or shake the container to release any excess dust from the filters R
3. more detailed information about treatment recovery and recycling of this appliance please contact your local city office your household and waste disposal service or the shop where you purchased the appliance C HOOVER Limited Pentrebach Merthyr Tydfil Mid Glamorgan CF48 4TU UK The Environment The symbol on this appliance indicates that this appliance may not This appliance complies with the European Directives 2006 95 EC 2004 108 EC and 2011 65 EU IMPORTANT SAFETY REMINDERS This appliance should only be used for domestic cleaning as described in this user guide Please ensure that this guide is fully understood before operating the appliance Do not leave the appliance plugged in Always switch off and remove the plug from the socket after use or before cleaning the appliance or any maintenance task This appliance can be used by children aged from 8 years and above and persons with reduced physical sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved Children shall not play with the appliance Cleaning and user maintenance shall not be made by children without supervision If the power cord is damaged stop using the appliance immediately To avoid a safety hazard an authorised Hoover service engineer must replace the power cord Keep hands feet loose clothing and
4. ability carpet dust pick up ability hard floor and energy efficiency in accord with Commission Regulations EU 665 2013 and EU 666 2013 PREPARING YOUR CLEANER Insert the removable handle into the body of the cleaner Place the power cord in the cord storage clip whilst in use This will prevent any accidental damage to the power cord DO NOT vacuum over the power cord CARPET CARE CONTROL SELECTOR The carpet care control selector raises and lowers the height of the nozzle Certain models only CLEANING TOOLS CLEANING THE STAIRS Removable Handle It is dangerous to place the Fitted onto the flexible hose with the various accessories attached this creates an ideal solution for stairs and cleaner above you when cleaning overhead cleaning stairs Pet Hair amp Allergen Remover ALWAYS work with the cleaner The pet hair amp allergen remover is ideal for removing pets hairs below you Ensure it is positioned DO NOT touch the rotating brush up against the bottom step Parquet Nozzle The parquet nozzle is ideal for cleaning delicate surfaces All accessories can fit onto the end of the flexible hose or end of the removable handle Combine accessories depending on use Q Remove the handle 0 Remove hose from the foot Attach hose to the handle end of the removable handle STORING THE CLEANER Turn the cleaner off and remove the plug Wind the power cord around the cord storage hooks 0 Attach
5. ch side lift cover and remove the blockage Certain models only Certain models only IMPORTANT INFORMATION Hoover Service Should you require service at any time please contact your local Hoover Service Office Hoover spares and Consumables Always replace parts with genuine Hoover spares These are available from your local Hoover dealer or direct from Hoover When ordering parts always quote your model number Quality Hoover s factories have been independently assessed for quality Our products are made using a quality system which meets the requirements of ISO 9001 GUARANTEE STATEMENT The guarantee conditions for this appliance are as defined by our representative in the country in which it is sold Details regarding these conditions can be obtained from the dealer from whom the appliance was purchased The bill of sale or receipt must be produced when making any claim under the terms of this guarantee Subject to change without notice User checklist If your cleaner is not working properly run through the following checklist 1 Is there a working electricity supply to the cleaner Check with another electrical product 2 Is the dust container full or choked with fine dust To empty the dust container see instructions on P6 3 Is the hose blocked To clear a blockage see instructions on P7 4 Is there a blockage in the cleaner base To clear a blockage see the instruction on P7 5 Are the filters block
6. ed To clean filters see the instruction on P6 6 Is the nozzle height set correctly To set the carpet height selector see the instruction on p4 7 Are the brushes rotating correctly To check the brushes see the instructions on p7 8 Has the cleaner overheated If so it will take about 30 minutes to reset If there is any doubt call the Hoover Service Office for advice They may be able to assist you over the telephone A service charge will be made if the cleaner is examined and found to be in working order has not been assembled in accordance with these instructions or has been used incorrectly working order has not been assembled in accordance with these instructions or has been used incorrectly WARNING A thermal cut out switches off the cleaner to prevent overheating if it is used when full or there is a blockage or dirty filters If this should happen switch off unplug and correct the fault It will take about 45 minutes for the cut out to automatically reset IMPORTANT Do not run cleaner over the supply cord as this could damage the supply cord insulation Hoover Limited Pentrebach Merthyr Tydfil Mid Glamorgan CF48 4TU HOOVER CUSTOMER HELPINE 08444 995 599 2014 48011579 y GENERATION FUTURE
7. emove excess water by shaking and leave to dry for 24 hours Refit filters only when completely dry 6 CHANGING THE BELT OR BRUSHES CLEARING A BLOCKAGE If your cleaner is not picking up efficiently the belt or brushes or both may need replacing but first please make sure you have IMPORTANT Switch the cleaner off and remove the plug from the electricity supply IMPORTANT Switch the cleaner off and e before dismantling cleaner remove the plug from the electricity supply Emptied the dust container e Cleaned the filters Checked for blockages e before dismantling cleaner If cleaning tools were in use check the cleaning tool and the Turn the cleaner over and 0 Hold the brush assembly and removable handle remove 6 retaining screws stretch the belt until the brush attaching the brush guard can be slotted back into to the base the cleaner housing Check the hose by removing it from the cleaner stretching it to full length Rotate the brush to ensure movement of the belt Turn the cleaner over and rotate the brushes until they are free to rotate Check for a blockage in the hose socket Use a Remove brush assembly and Refit the brush guard with 6 flexible rod to remove check for wear on the belt retaining screws any obstruction Loop the new belt around the motor and brush channel Removing a blockage from the Pet hair amp allergen remover Open the nozzle at ea
8. hair away from rotating brushes Use only attachments consumables or spares recommended or supplied by Hoover When using cleaning tools ensure that the appliance is kept in the upright parked position This will avoid possible damage to the carpet or floor covering When cleaning stairs do not position the appliance above you Static electricity some carpets can cause a small build up of static electricity Any static discharge is not hazardous to health Do not use your appliance out of doors or on any wet surface or for wet pick up Do not pick up hard or sharp objects matches hot ashes HANDLE RELEASE HOSE CORD STORAGE HOOK POWER CORD CREVICE TOOL DUSTING BRUSH HOSE CONNECTOR CLEANER RELEASE PEDAL ON OFF BUTTON PET HAIR amp ie citiri 2 3 EA I 2 SZ ALLERGEN REMOVER GETTING TO KNOW YOUR CLEANER REMOVABLE HANDLE BIN RELEASE DUST CONTAINER WASHABLE HEPA FILTER EXHAUST FILTER COVER CARPET CARE CONTROL SELECTOR PARQUET NOZZLE CLEANER RELEASE Unlock the cleaner by pressing down on the pedal with your foot POWER SWITCH To switch the cleaner on or off press down on the pedal with your foot CARPET CARE CONTROL SELECTOR Ensure that the cleaner is in the upright parked position and move the se
9. lector to the required setting for the carpet type or floor covering To obtain the best performance and energy efficiency it is recommended that the adjustment setting position 1 is used for the main cleaning operations The other adjustment settings are for ease of use use on longer pile carpets or for specialist cleaning tasks Settings 1 Best performance and energy efficiency short to medium pile carpets hard wooden floors wooden floor boards with crevices ceramic tiles 2 Medium pile carpets delicate floor coverings such as vinyl or linoleum parquet flooring 3 or 4 For longer pile carpets the motion resistance may increase Use these intermediate settings to reduce the force required to push the vacuum cleaner 5 Luxury carpet and Tool mode IMPORTANT Using this cleaner for loop pile carpets with pile greater than 30mm is not recommended Please consult the floorcare carpet manufacturer s recommended cleaning instruction before vacuuming IMPORTANT When cleaning delicate hard floors such as vinyl or linoleum the selector switch must be moved to position 2 Failure to do so may cause damage to the floor surface This vacuum cleaner is supplied with an Energy Label as required by European Regulation EU 665 2013 If the label shows a red prohibition circle on the right covering the hard floor symbol then this indicates that the vacuum cleaner is not suitable for use on hard floors NOTE Dust pick up
Download Pdf Manuals
Related Search