Quick Start: 10 Steps to Connect Bridge-IT
Contents
1. 8 Press the down V navigation button to select FEC forward error correction and press to view selection options Use the navigation buttons to choose the FEC percentage you want to use and press nr 16 22 IP ConfiafPt to Pti eee Loco Rem Off A Dir IFVE Disabled he 9 When programming is complete press the RETURN button to navigate backwards to the Connect IP screen that the IP address was entered into 3 Important Note At this point navigate to Save on the Connect IP screen and press OK to save the settings as a custom program for subsequent recall Use the KEYPAD to name the program and press OK to save it Note A confirmation message should appear 10 Press the DIAL button to make a connection The Wait Connecting screen appears during the connection process After successfully connecting the codec will display connection details Use the down V navigation button to view connection Status and press to view connection statistics for IP packets being sent over the connection To negotiate higher bit rates press D then 3 on the numeric KEYPAD for lower bit rates press D then 9 For more info visit www tieline com support or contact Tieline at support tieline com Tieline Pty Ltd 20112. Quick Start 10 Steps to Connect Bridge IT 1 Quick Start 10 Steps to Connect Bridge IT i 7 Important Note The following information pertains to connecting Bridge IT point to point for the very first time without using the Toolbox web GuUI If you want to connect using the PC web GUI download the codec user manual from www tieline com bridge it 1 Press the amp D button and right gt navigation button to open the Input Audio level adjustment screen and adjust audio levels e Press G on the numeric KEYPAD to toggle channel 1 on and off and press to toggle channel 2 on and off e Use the up A and down V navigation buttons to select Gang 1 2 and press the button to toggle ganging on off e Use the up and down V navigation buttons to select a single channel or ganged channels Note A channel is highlighted when selected e Use the left lt and right gt navigation buttons to adjust the input levels up or down i 7 Important Note 15 volt phantom power is not supplied to input 1 by default To adjust this select Config gt Audio gt Phantom Press OK to toggle between Disabled and Enabled 16 m Inout Audia i CC 3 Select the IP mode you are using to connect in this case Point to Point see also WebGUI Configuration of Multi Unicast Programs and Configuring Multicast Programs in the codec user manual 16 IF iode Point to Poin RuN eagen Multicast Clien 4 Use the RETURN button to delete number
3. s already entered then use the numeric KEYPAD to enter the IP address of the codec you want to dial using the amp or buttons to enter the periods in the IP address Next press the down V navigation button to select Config and press nr 16 22 ConnectiPrPt to Pti Tieline 192 166 0 9 3 Important Note The codec remembers recently connected IP Fi 22 iine addresses just like a cell phone To view these IP addresses navigate to the Connect IP screen and press the OK button Navigate up and down and press OK to select a highlighted address 192 1660 254 jale 5 Select Alg algorithm and press C Tieline Pty Ltd 2011 16 IF Confia fPt to P ti PEM WPS tone 2k 6 kbp JitBut Auto Best Compromise Loc Off Rem Off 6 Use the navigation buttons to select an algorithm profile or manually enter algorithm settings then press 16l Alaornthm MP2 tone If you decide to manually program the algorithm use the navigation buttons to select your preferred algorithm sample rate if displayed and bit rate pressing after each option is selected 16 22 _ Bitrate Tieline 96 Kbps 7 Press the down V navigation button to select Jitt jitter buffer delay and press to select a new auto jitter buffer setting or to enter a fixed buffer setting in milliseconds maximum 999 ms The default Auto Best Compromise setting is a good starting point for most internet connections
Download Pdf Manuals
Related Search