2100 SERIES/GEMINI USER`S MANUAL VER. 1.2 Module
Contents
1. 2100 SERIES GEMINI USER S MANUAL VER 1 2 Module amp Contact Installation Removal Section 1 Twin Access Contact TAC Receiver Wiring Module and ITA Module Installation Removal Instructions P N 510 133 109 380 signal wiring contacts P N 510 134 101 ITA 380 signal wiring contacts P N 510 133 110 228 signal wiring contacts 12 coaxial or power wiring contacts P N 510 134 102 ITA 228 positions 12 coaxial power wiring contacts P N 510 133 111 180 signal wiring contacts 10 coaxial 75 OHM wiring contacts P N 510 134 103 ITA 180 positions 10 coaxial 75 OHM P N 510 133 112 46 coaxial or power wiring contacts P N 510 134 104 ITA 46 positions coaxial or power wiring contacts 7 e PARTS TOOLS REQUIRED eB 5 64 Allen Hex Wrench Pp 3 32 Allen Hex Wrench 7 oa INSTRUCTIONS A Receiver I 1 Place the module on the rear of the Receiver Module aligning the locating bosses on the modules with the appropriate holes in the Receiver Module 2 Install the modules such that the numbers can be read from top to bottom making them right side up 3 Insert the 2 Socket Head Cap Screws 50 length in the module fastening holes 4 Using a 5 64 Allen Hex Wrench tighten the top screw 1 to 2 full revolutions while lightly applying pressure against the face of the gt module 5 Maintain this pressure while tightening the bottom screw 1 to 2 full revolutions 6 Repeat this se2. quence until the module is seated Torque the screw el Screened side of Receiver Wiring until it is 4 to 5 inch pounds Moonie 7 To remove loosen the top screw 1 to 2 full revolutions Loosen bottom screw 1 to 2 full revolutions Repeat this sequence until the module is separated from the Receiver NOTE It is important to alternate the tightening loosening of module screws S ITA NL i A he aes 1 To install Module into ITA place module in the ITA with the screening facing upward Align top of the module with the designated top of the ITA and the locating bosses on the module with the appropriate holes in the ITA 2 The modules should be installed such that the numbers can be read from top to bottom Screened side of 3 Insert the 4 Socket Head Cap Screws 0 50 length in the module fastening fe itd ITA odule holes 4 Using a 3 32 Allen Hex Wrench tighten the top screw 1 to 2 full revolutions while pushing lightly against the face of the module manus 5 Maintain this pressure while tightening the bottom screw 1 t0 2 full revolutions WHI 6 Repeat this sequence until the module is seated Torque the screw until it is 8 od to 10 inch pounds l To remove loosen the screws until the module is separated from the ITA __ 12 VM2100_V1 2 pmd www vpc com Virginia Panel Corporation
Download Pdf Manuals
Related Search