User Manual - Lion Precision
Contents
1. exert extra force when adjustment stops LRD6110 with Integral Cable Wire Connection Notes Color Req 11 to 28VDC Red Vin 11 28VDC 50mA max Black Ground Connected to Green iit rete body Bi mA max sensor ue PNP Output Green NPN Output 150mA max 150mA max BI PNP Output 150mA seni ue utpu mA max pie l oe Brown Output Polarity V Dark l i light dark Switching NC Polarity Invert switching Ground Light Switching NO Warning Brown wire must be connected to V or Ground for reliable operation LRD6110C with M12 Connector Wire Connection Notes 1 Brown Color 11 to 28VDC 1 Brown Vin 11 28VDC 50mA max deur ae 2 White NPN Output 150mA max 150mA max 3 Blue Ground Connected to gas sensor body PNP Load 4 Black PNP Output 150mA max l Giound 5 Gray Output Polarity V Dark Polarin light dark Switching NC 5 switching Ground Light Switching NO x 1 Warning Gray wire pin 5 must be connected to oo V or Ground for reliable operation o gt g Setup Procedure Web must remain in contact with the mounting plate Label must pass under the SENSOR indicator Small labels should be centered under the SENSOR indicator Feel When properly setup the lights will move between wEB and LABEL The lights in the X r2. Output and Mechanical Detail Dark Switching Output Polarity V fe 1 lt Outputs Light Switching 4 4 Outputs Output Polarity GND 5 50 pE Ma lt 140mm amp 20 gt lt gt 1 20 30 5 0 60 ae Sonn lt gt lt 15 2mm i af np a E Gap 0 03 s5 on 0 76mm TN Specifications Voltage 11 28 VDC reverse polarity protected Power supply Current 50mA On or Off 20us max Response time i Switching Frequency 10kHz max Ditoit Output Current sinking or sourcing 150mA max overload protected utpu j Switching output PNP or NPN dark or light switching Temperature Operating Range 40 F to 140 F 4 C to 60 C Supply Inverse Polarity Protection Protections Switching output Short Circuit and Overload Protection User s Guide for the LRD6110 and LRD6110C Label Sensors from Lion Precision Lion Precision 563 Shoreview Park Road St Paul MN 55126 651 484 6544 www lionprecision com Document Number M015 3380 018 Connecting to the Sensor Warnings Sensor body is connected to Ground Unused wires must be insulated from contact with other objects All power must be off when installing the sensor Brown wire Output Polarity must be connected to V or Ground for reliable operation Shift adjustment will be damaged if over turned Do not
3. egion should only light briefly during the transition between Wes and LABEL regions Sensor Setup 1 Turn Span at least four turns counter clockwise then two turns clockwise this is the mid point of the adjustment range The adjustment can be over turned without damage Place web liner only in sensor Adjust Shift until LED 2 is on then adjust Shift just to the point where LED 1 is on WARNING The Shift adjustment will break if turned too far Do NOT exert extra force when adjustment stops turning 4 Slowly move a label gap through the sensor and verify that the indicator lights LED 1 as the gap passes through the sensor If it does not adjust Shift as necessary until it does 5 Setup complete If the setup does not give reliable results usually for labels less than 1 turn Span four turns clockwise maximum gain and repeat steps 2 5 It is important that the indicator only cross the X region during transition from web to label See the LRD6110 setup video at www labelsensors com Notes 1 The LRD6110 may not work reliably with solid foil labels For solid foil labels use the LRD8200 Two Year Warranty details at www lionprecision com warranty html
Download Pdf Manuals
Related Search