USER MANUAL
Contents
1. TEAM SAVE THESE INSTRUCTIONS www xm42 com 1 of 5 XM42 User Manual DO NOT DISCARD The lon Productions Team LLC IMPORTANT SAFETY WARNINGS AND INSTRUCTIONS When the XM42 is turned on and the trigger is pressed the XM42 sends out a stream of fuel that s ignited The stream may extend beyond 25 feet The XM42 is intended for proper use by legally competent persons over the age of 18 The lon Productions Team LLC and its members managers agents and representatives shall not be liable for any damages that result from improper or unauthorized use TO REDUCE RISK OF INJURY e Read all instructions before operating product Failure to follow all instructions listed below may result in burns unintentional fires and or serious injury or death Save these instructions and review frequently before use and when instructing others e KEEP OUT OF REACH OF CHILDREN e Inspect for leaks before operation Check all visible fittings and ensure there is no fuel leaking anywhere on or inside the device If you suspect or notice any leakage through sight smell or otherwise discontinue use immediately and contact support xm42 com for technical support Never aim in any unsafe direction e Nozzle area becomes hot and aflame during use DO NOT TOUCH NOZZLE AREA e Pilot torch becomes hot and aflame during use DO NOT TOUCH PILOT TORCH BURNER TUBE e Do not handle or untwist remove butane canister while any flame is present e Keep all parts of body as2. far away as possible from nozzle during use e Do not aim towards anything you do not intend to ignite e Do not refill fuel tank while pilot flame is ignited e Do not use in windy conditions The fuel stream and droplets of fuel can travel toward the operator or other unintended areas Do not drop or impact in any way If the XM42 is dropped or dented it may not function properly Contact the manufacturer for repairs and do not attempt to use e Do not expose to or use in temperatures higher than 110F or lower than OF e Fuel has the ability to drip from the nozzle of the device at any time Always be sure the XM42 is directed safely away from people and flammable surfaces and that all parts of the operator s body are as far away from the nozzle as possible Never aim XM42 higher than 45 degrees risk of fuel drip onto operator e When the pilot torch is lighted or the nozzle area is aflame do not point the XM42 nozzle towards the operator s feet fuel can drip at any time e Portions of the XM42 may become very hot to the touch during use Do not touch any portion of the nozzle while the XM42 is lit or within 20 minutes after extinguishing e Ensure pilot torch gas valve is fully closed after use and XM42 power button is off e Use in upright position only DO NOT DISASSEMBLE IN ANY WAY BE SMART BE SAFE LITHIUM BATTERY WARNINGS CHECK VOLTAGE BEFORE AND AFTER EVERY USE e Do not allow overall battery pack voltage to
3. XM42 User Manual DO NOT DISCARD The lon Productions Team LLC WARNING READ AND UNDERSTAND THIS MANUAL IN ITS ENTIRETY BEFORE USE A XM42 USER MANUAL Updated Nov 3 2015 For video instructions visit https youtu be JeeLGgrPV s Required standard foodservice 8 oz 227g butane fuel canister e fuel see page 4 for approved fuels SPECIAL THANKS TO OUR SUPPORTERS Aaron Overton Adam Gentile Adam Mclarty Adam Mishcon Adonis Storm Alexander Nowell Alexander Pushkov Alexander Schaller Andrew Bader Andrew Boley Andrew Hudson Andrew Vincent Andy Rusk Anthony J Rodrigues Arthur Murphy Barry Nelson Bjarki Gunnarsson Brandon Lewing Brian Alexander Brian Foutch Bubba Harmon Chad Debeaumont Chad South Chris Farris Chris Gunn Chris Hill Christian Zabbal Cody Mohler Colin Evans Constantine Fotopoulos Craig Border Craig Lawson Dan Colosimo Dan Roche Daniel Cannon Daniel Hershman Darwin Pinder David Crowder David Koonce David Petty David Roberts David Terry David Waldron Don White Donald Curtis Donald Woolridge Edward Avila Elijah Sweat Erandy Ramly Eric Becker Eric Madden Fleming Lyles Florio Tiramani Fred Von Graf Glen Thompson Gustav Haglund Heath Williams Hunter Windham lan O Brien J Neil Jednoralski James Whitemore Jarid Perry Jason Jones Jason Seleno Jeff Piuma Jeffrey Swain Jeremy Hutchinson Jerome Thielen Joel Zaruba Johan Chamucero John Anderson John Appleby John Cap
4. al apply a small amount of oil to the threads and work the cap back and forth some to help Although lithium polymer batteries are designed to be safe as long as there is no physical damage or overcharging done to them we like to err on the safe side and recommend battery replacement every 3 years with a quality 2200mAh 3S 12 6 volt XT60 connector lithium polymer battery We offer free battery replacement for only the cost of shipping For safety liability reasons we do not encourage the user to perform their own service The main goal in maintenance is to prevent moisture from accumulating and damaging the fuel pump It likes to stay lubricated and water free For long term storage we advise operating the XM42 with a gasoline or gasoline diesel mixture along with a small amount of motor oil to ensure a coating of oil on any corrosion prone pump components For repairs battery replacement or other services contact us at support xm42 com ABOUT Founded in 2004 and officially registered in 2015 The lon Productions Team is a small company located near Detroit Michigan that focuses on bringing exciting and unique products to the world We are dedicated to providing the highest quality products for our customers Between high grade materials technical expertise and pride in craftsmanship we are confident in producing the most efficient reliable and safe products possible Thank you for your purchase we hope you enjoy owning your own flamethrowe
5. are overcharged or short circuited or if they have become submerged in water even if they have been dried out or if their cases have become damaged e Only charge your battery for the recommended time Remove from the charging source as soon as the indicator shows that charging is complete e NEVER leave the device charging unattended Transportation shipping and or use of the XM42 may be regulated by federal state and or local law Verify applicable laws before using transporting or shipping The lon Productions Team LLC and its members managers agents and representatives shall not be liable for any special or consequential damages that result from the use of the products offered even if The lon Productions Team LLC has been advised of the possibility of such damages Applicable law may not allow the limitation or exclusion of liability or incidental or consequential damages DISCLAIMER Although the contents of this manual are believed to be accurate The lon Productions Team LLC does not assume responsibility as to the accuracy correctness completeness reliability and up to dateness of information made available through the manual The contents of the manual are provided as is and without any expressed or implied warranties of any kind The lon Productions Team LLC disclaims liability for any damages that arise as a result of the direct or indirect use of its manual and or websites The lon Productions Team LLC reserves the right t
6. drop below 10 0 volts nor any individual cell to drop below 3 3 volts e Do not charge with any charger other than the one provided Lithium polymer batteries are volatile Failure to read and follow the below instructions may result in fire personal injury and damage to property if charged or used improperly e Li Polymer battery packs may explode and cause fire if misused or defective DO NOT PUNCTURE THE BATTERY DO NOT SHORT CIRCUIT THE BATTERY DO NOT INCINERATE THE BATTERY DO NOT EXPOSE TO WATER OR EXCESSIVE MOISTURE OR ANY LIQUID e When charging the battery place XM42 on a fire proof surface Do not leave unit and charger on wood carpet or other flammable materials and unattended e Keep away from children e If you notice any damaged or frayed wiring discontinue use immediately place in a safe area and contact manufacturer e Use only a balance charger designed for lithium polymer batteries in a 3S 3 cell configuration such as the charger provided The purpose is to keep each battery pack balanced Never make a wrong polarity connection when charging and discharging battery packs e Always double check polarity of battery s connector to make sure connectors mate properly e Replace battery with a new one at least every 3 years e NEVER leave the XM42 where it is subjected to extremes in temperatures This includes low levels as well as high e DO NOT leave unit in direct sunlight e There are fire risks when batteries
7. not to spill any onto the product exterior APPROVED FUELS Gasoline unleaded gasoline diesel mixture or alcohol fuel Use only approved fuels for longevity and warranty The XM42 uses aluminum stainless steel brass and fluoroelastomer internals Unapproved fuels have not been tested and usage is at your own risk DO NOT OVER TIGHTEN Reinstall fuel tank cap by turning it clockwise until hand tight Do not over tighten It s not under pressure just want the o ring to seal for spills Move to a safe outdoor area free from objects that could be inadvertently ignited 9 Open the pilot torch gas valve counterclockwise until you hear a hiss due to gas flow and push the red igniter button on the rear of the XM42 to generate a spark inside the pilot torch to ignite the flame If it does not ignite you may need to adjust the gas flow valve and try again 10 Once the pilot torch has a flame adjust the valve to the desired size recommend against excessive flame due to fuel consumption and inefficiency 11 Push the latching power button on the side of the XM42 and it should illuminate to indicate the device is ready to operate SAVE THESE INSTRUCTIONS www xm42 com 4of5 XM42 User Manual DO NOT DISCARD The lon Productions Team LLC 12 13 14 Aim the product in a safe direction and press the black momentary button on the rear handle to emit fuel and subsequently a flaming stream up to and beyond 25 feet in distance Stop
8. o modify amend delete suspend or discontinue its manuals and or websites which it controls without prior notice SAVE THESE INSTRUCTIONS www xm42 com 2 of 5 XM42 User Manual DO NOT DISCARD The lon Productions Team LLC INSTRUCTIONS FOR USE 1 Charge battery before use Charging cable is tucked into rear handle Gently pull out to reveal connector ENSURE POWER BUTTON IS OFF ON XM42 2 Plug the charger in to the wall outlet and the XM42 s connector into the leftmost port on the charger The LEDs will glow constant red during charging When all LEDs turn green the battery is fully charged Disconnect cable unplug the charger from the wall and tuck the charging cable back into the handle 3 Before each use check voltage using supplied voltage tester Insert the charge cable connector into the tester as shown it will beep and display the overall voltage and then tell you individual cell voltages Voltage should be 12 6 when fully charged DO NOT ALLOW TO DROP BELOW 10 0 VOLTS 4 Ensure the pilot torch gas valve is closed turn clockwise SAVE THESE INSTRUCTIONS www xm42 com 30f 5 XM42 User Manual DO NOT DISCARD The lon Productions Team LLC 5 Install a high quality 8 oz butane canister by gently pressing the canister into the torch supply connection and rotating the canister clockwise until it stops 6 Remove the XM42 fuel tank cap by turning it counterclockwise and pour fuel into tank until full taking care
9. r Contact us if you have any questions support xm42 com The lon Productions Team LLC 318 John R Rd Suite 322 Troy MI 48083 SAVE THESE INSTRUCTIONS www xm42 com 5 of 5
10. refoli John Castillo John Delinocci John Giddens Jordan Hale Joshua Magady Justin Beurie Justin Reed Keith Bolton Ken Miyamoto Kenneth Ellenberg Kenneth Gabel Kris Petter Larry Vickers Lathier Brown Lou Driever Marc Blackson Marc Cavicchioli Marcus Beaman Mark Laderman Mark Pulver Mark Siorek Marshall Royce Matt Burger Matt Montgomery Matthew King Matthew Laplant Matthew Mcfarland Matthew Swope Max Venom Product Group Miao Wang Michael Lea Michael Moyer Michael Myhal Michael Proscia Michael Ransdell Michael Sisk Michael Wann Mike Crow Mike Stokke Nate Wentworth Nicholas Gianfortune Nick Schexsnayder Patrick Owen Patrick Stewart Paul Goggin Peter Dillon Peyton Lucas Randall Gicker Raymond E Ramirez Rick Medina Rob Moser Rob Smith Rob Wadley Robert Anderson Robert Balyszak Robert Edwards Robert Sobieski Robin Schwarz Ryan Ballard Ryan Brush Ryan Jones Ryan Murphy Ryan Peters Ryan Schell Ryan Stock Ryan Wilsey Samuel Miller Scott Sharer Scott Smith Shane Graham Shireen Karolia Stefan Stone Stephen Orcutt Steve Lawrence Steven Shuff Summer Fleming Ted Newlander Thomas Obrey Thomas Shumaker Thomas Williams Tim Mcfeaters Timur Kadyrov Todd Wagner Tom Buckley Tom Reynders Troy Pleinis Tyler Sharp Vito Rocco William Craft William Hockett and William O Brien If you have a question or experience a problem with your XM42 contact us at support xm42 com HE m I e iON PRODUCTIONS
11. use at first sign of low fuel sputtering etc Do not run unit when fuel tank is empty Refill before continuing HOT SURFACES DO NOT TOUCH When you are finished using the XM42 turn off the pilot torch by turning the gas valve clockwise until fully closed Blow out the remaining flame at the end of the XM42 or wait until the remaining fuel inside the plumbing burns off Turn off the illuminated power button by pressing it again Ensure the switch is off when not in use to prevent any inadvertent fuel emission TO PREVENT MOISTURE FROM ACCUMULATING AND DAMAGING THE FUEL PUMP DO ONE OF THE FOLLOWING KEEP YOUR XM42 FILLED WITH FUEL USE GASOLINE DIESEL MIXTURE ROUGHLY 30 DIESEL BEFORE STORAGE USE CHOICE OF FUEL ALONG WITH A SMALL AMOUNT OF MOTOR OIL ABOUT 50 1 RATIO OF FUEL OIL BEFORE STORAGE MAINTENANCE REPAIR The XM42 is designed to generally be maintenance free All components are constructed for industrial use The intermittent operation seen by the XM42 should not degrade any component Nevertheless failures can occur in any mechanical device The internals utilize hard plumbing with high quality thread sealant along with a short fluoroelastomer hose You must inspect for leakage before every use General maintenance Keep fuel tank cap o ring lubricated with a very small amount of automotive engine oil SAE 30 or similar to ensure smooth seating of the fuel cap If the fuel tank cap seems gritty in its installation remov
Download Pdf Manuals
Related Search