64 Inputs and Encoders (User Manual - Version 3.0.0)
Contents
1. and Encoders ER Connected to Flight Simulator View Board None O1 O2 The 64 Inputs and Encoders program will be minimised on the taskbar because while you are flying your simulator it is not normally necessary to see this information You can of course bring it back to full size while you are setting up all of the various controls The ON OFF status of each item can be seen from the colour of the description where it will be Green for ON and Red for OFF The values to use for ON and OFF are set up in the 64 Inputs and Encoders Config program Make sure that when you have finished viewing the data that the program is minimised not closed so that the program remains running tee 64 Inputs and Encoders RUSCOOL ELECTRONICS Limiteod Bank 4 1 w o 3 gt N Autopilot Heading Hold Autothrottle TOGA AP Vertical Speed Hold AP Master Switch AP Airspeed Hold Flight Director Act Lights Landing n Lights Navigation ank 5 ank 7 Encoders ank 8 Encoders AP Airspeed Value knots PWN DW ANAM WN AP Altitude Value ONO WNHHD ONAN PWD 1 2 3 4 5 6 7 8 B 1 2 3 4 5 6 7 8 Encoders 1 AP Vertical Speed 2 AP Heading Value Changing the Configuration In order to change any of the configured items it is necessary to close the 64 Inputs and Encoders program before running the 64 Inputs and Encoders Config program and of course pressing save and then restart the 64 I2. RUSCOOL ELECTRONICS LIMITED 64 Inputs and Encoders Version 3 0 0 User Manual Copyright 2010 Ruscool Electronics Limited Table of Contents Prerequisites 64 Inputs and Encoders Installing the FTDI Driver Prerequisites e A registered version of FSUIPC must be installed within the Flight Simulator software e The FTDI driver must be installed to ensure the program can communicate with the hardware The FTDI driver files can be found in the application directory e Ensure the board is connected to a power supply as well as the computer via a USB cable and of course turned on 64 Inputs and Encoders After running the 64 Inputs and Encoders Config program and setting up how you wish to use the various inputs and of course saving your settings the main 64 Inputs and Encoders program is ready to use The 64 Inputs and Encoders program can be running before starting Flight Simulator as it will wait for a connection to the Flight Simulator software before the program continues If more than one board is configured the multiple input board is displayed on startup You can view any detail screen as shown below by selecting the appropriate board number Click on None to hide again To exit the program click on the Quit button on the 64 Inputs and Encoders screen and all boards will be closed If only one board is configured the detail screen will appear minimised and you won t see the screen below H 64 Inputs
3. nputs and Encoders program once the changes have been made Installing the FTDI Driver Only required the first time the hardware is used on this PC Once the 64 Inputs and Encoders software has been installed plug a USB cable between the Ruscool 64 Inputs PCB and the computer then power up the board The Found New Hardware Wizard will automatically start e Connect to Windows Update select No not this time then click Next e Select Install from list or specific location then click Next e Click on the Browse button Select the install application directory FTDI drivers and click Finish A second Found New Hardware Wizard will then start e Connect to Windows Update select No not this time then click Next e Select Install from list or specific location then click Next e Accept the default location and click Finish You should then see a message stating Your new hardware is setup and ready to use The 64 Inputs and Encoders program can now be run You then need to power down the Ruscool 64 Inputs PCB for about ten seconds before turning the power back on and restarting the 64 Inputs and Encoders program
Download Pdf Manuals
Related Search