Rhino-Rack - Fitting Instructions
Contents
1. CONTROLLED RHINO RACK Rhino Rack Paddle Board SUP Tie Down RBAS2 Place these instructions in the vehicle s glove box after installation is complete Important Please read these instructions carefully prior to installation Check the contents of kit before commencing fitment and report any discrepancies Parts List Item Component Name Qty Part No Anchor Strap 4 5m Tie Down with padding pele Important Information Rhino Rack 3 Pike Street Rydalmere Document No R667 NSW 2116 Australia Prepared By Kayle Everett Issue No 01 Ph 02 9638 4744 Fax 02 9638 4822 Authorised By Chris Murty Issue Date 09 02 2015 These instructions remain the property of Rhino Rack Australia Pty Ltd and may not be used or changed for any other purpose than intended When these roof racks are to be used on a vehicle that is driven off sealed roads the manufacturer A T 60kg load rating __ 30kg load rating maximum roof load rating to be Urban road Off road 60kg 2 found in the vehicles User Manual g should be halved Do not forget to subtract 7 5kg from your maximum carrying capacity due to the weight of the crossbars and legs WARNING Important Load Carrying Instructions Paddle Surfboards should be fixed to the front of the With utility vehicles the cabin and the canopy move vehicle independently Roof2. racks and vehicle can be damaged if the item transported is rigidly fixed at points on both the cabin and canopy Instead rigidly fix to either the cabin roofracks or the canopy roofracks Page 2 of 4 Place the Anchor Strap onto the side of the engine bay Suitable positions will vary depending on vehicle model and make Loop the Tie Down Strap through the ankle leash mounting point These fixture points will vary slightly in appearance depending on the board Fix in place with Tie Down straps RTD35P sold separately 4 Close the hood of the vehicle securing the Anchor Strap Slide the Tie Down Strap through the fixture point as shown If the fixture point has a rope loop in place this can be used to secure the Tie Down Strap to the board Page 3 of 4 Twist the strap around itself multiple times This Pull the end of the Tie Down Strap through the will minimise vibration and noise caused while Cam Buckle Pull tight Procedure as per below driving at speed The Neoprene cover should be in contact with the anchor strap The Tie Down Strap can secure the Board by tightening around the fin The neoprene sleeve will protect the board when tightened Note The Tie Down Strap can be cut to length Fuse any fraying with an open flame Check all fixtures are secure before use Page 4 of 4
Download Pdf Manuals
Related Search