Getting Started with the WC02
Contents
1. gt 7 J wy vo N C wy fi N D T A N wI 2015 Augustine Temperature HotDoa Patient Warmina Svstem LRAT ATAS E ALICIIL IVAT ITT g YYOLC I I GETTING STARTED WCO2 Controller Press the switch on the back of the controller to the on position Connect the controller to the blan p ket with the yellow cable The red dots on the cable tip should face up When releasing the cable pull back on metal tip as shown do not twist to disconnect Select the desired temperature setting by pressing the single but ton on the face of the controller Remember e Make sure the sensor is touch ing the patient shown Use a thin barrier between pa tient and blanket i e pt gown e Place black side of the blanket toward patient Don t fold black sides together while in use Quick Troubleshooting guide e Is unit plugged into power outlet If alarm sounds ensure sensor contact and restart e See other side for full troubleshooting guide janagement LLC www hotdog usa com 952 746 1720 TROUBLESHOOTING Refer to User Manual for Complete Instructions for Use Primary over temp When the temperature exceeds one degree above nominal audible and visual alarms are initiated and power is removed from the output The alarm will reset when e Temperature is within acceptable limits 1 C e Cable connecting Warming Blanket to Controller is disconnected or e Power i2. ct temperature If alarm contin ues contact manufacturer 6 hour time out If a warming device is left operating for 6 hours with no changes to set point power timer will be removed three short audible chirps will sound and the alarm indicators will flash continuously Pressing the temperature select button will clear the alarm and re start normal operation Immediate Alarm If controller alarms on initial start up prior to selecting a temperature an electrical failure may be detected Swap out cables and blankets to isolate the problem and contact the manufacturer Customer Service 952 465 3500 www hotdog usa com PN 2763
3. s removed at mains To resume warming check sensor location and reselect temperature If alarm contin ues contact manufacturer Secondary over temp When the temperature exceeds 46 C audible and visual alarms are initiated The alarm will reset when e Cable connecting Warming Blanket to Controller is disconnected or e Power is removed at mains To resume warming check sensor location and reselect temperature If alarm contin ues contact manufacturer Failure to reach temp When the system does not achieve selected temperature within 10 minutes audible and visual alarms are initiated The alarm will reset when e Cable connecting Warming Blanket to Controller is disconnected or e Power is removed at mains To resume warming check sensor location and reselect temperature If alarm con tinues within 10 minutes lay the blanket out flat face down on an insulated surface such as the OR mattress Reselect temperature If temperature in range light doesn t activate within 10 minutes the blanket is at the end of its service life Fold Detect If the Warming Blanket is folded on itself such as black on black such that a local over temperature condition occurs audible and visual alarms are initiated The alarm will reset when e Temperature in folded area has cooled and e Cable connecting Warming Blanket to Controller is disconnected or e Power is removed at mains To resume warming fix the fold condition and resele
Download Pdf Manuals
Related Search