Note! Before using the Drester 1050, it is importan that you have
Contents
1. Note Before using the Drester 1050 it is importan that you have read and fully understand the Users Manual CLEANING For best cleaning result spray guns should be cleaned immediately after use Disconnect the spray gun from compressed air and empty any remaining paint into a paint waist container To start the pump and activate the flow of cleaning fluid press the foot pedal 10 Clean the cup and the cap using the rinse gun 2 and the brush 1 Clean the paint channel of the spray gun using the rinse gun 2 Clean the outside of the spray gun using the rinse gun 2 and the brush 1 Dry the spray gun cup and cap using the blow gun 5 In addition to the steps above you can connect the blow out air line 11 to your spray gun to blow out any remaining fluid FLOCCULATION AND FILTRATION When the mix of paint and water reaches the level of the working platform 4 it is time to perform the flocculation and filtration It is important that the flocculation is thouroughly carried out If not the filters 7 and 8 will become obstructed and cannot be re used Make sure the filtrate container 9 is empty Maximum one inch of fluid left in the container Remove the working platform 4 Turn the lever 3 to start the agitation While stirring with a measuring stick or similar add flocculation powder as recomended by the paint manufacturer usually approximately five s2. coops for full batch using Drester 9211 flocculation powder When all flocculation powder is thouroughly mixed in let the agitation run for three minutes Let it rest for on minute Turn the agitator on for one more minute h Pov any sludge from the pre filter 7 and open the drain valve 6 to drain the dirty water through the ilters WN CLV am Clean the inside of the sink and close the drain valve 6 Re fit the working platform 4 INSTR 14956 REV 081121 TB GODK SID 1 1
Download Pdf Manuals
Related Search