to – 700 Series User Manual
Contents
1. CONNEC Professional a Le PROCONNECT GAS SHOCK Gute UR SERIES USER M ANUAL PC700 Series Thank you for purchasing our professional table top connecting panel CAUTION e Only connect the power connection to a voltage feed of 240 Volt 50Hz single phase with protective earth e There is a 10A fuse built in to the IEC 60320 rubber connector which may not be replaced by a fuse with a higher ampere value A spare fuse can be found in the fuse drawer of the IEC Plug e Do not wet the unit and keep in a dry well ventilated area INSTALLATION e The ProCONNECT should be installed by a professional technician e Feed the selected plates with their respective cables through the unit from the underside Take care not to damage the cable or plate Use the screws to tighten the plate in position e Please check and confirm the supplied template with the size of the unit avEFEKTs or its registered dealer cannot be held responsible for damages due to incorrect cut outs e Define the point of installation accurately and mark out the area to be cut with the template or attach the template directly onto the table surface e The area to be cut should be made with the appropriate tools depending on the material of the plate Make the cut out e Insert the ProCONNECT through the opening and position correctly e Attach the fasteners to the appropriate notches underneath the unit The area with the insert nut must be parallel to the2. plate and the screw head must point away from the plate Adjust the unit to the desired position and tighten with screws e Mount the cables using appropriate mounting material M ake sure that the cables will not get broken jammed or distended when the unit is opened or closed The centerpiece must be able to move freely and the cables must have sufficient slack for when the unit is opened Connect the Audio Visual cable ends to the respective cables sockets Please also connect the 240V Power to a Wall Plug e Ensure that the power outlet and the signal connectors are only being used with the maximum allowable voltage and current NOTE M aximum total load is 10A 2400W across the entire unit INSTRUCTIONS FOR USE e Open Press on the centerpiece of the lid until the latch audibly disengages Release and the lid will pop open showing the available connections e Close Press down on the centre of the lid until the latch audibly engages Release and the lid will be closed e Cleaning Switch off the system or pull the plug before cleaning Do NOT use any cleaning agents or water on the unit Only use a soft and lightly moisturized cloth 1 YEAR WARRANTY ON ALL PROCONNECT SERIES
Download Pdf Manuals
Related Search