Instruction Manual
Contents
1. AL button and hold it for at least three seconds For Tempo Logic cod 8483 RESET The factory settings of the timer can be restored at any given moment by pressing the MANUAL and START buttons simultaneously and holding them for at least 10 seconds SWITCHING OFF THE TIMER If the timer needs to be switched off for example to store it away during winter press the P button once or repeatedly until the OFF symbol appears then press START For Tempo Logic cod 8483 Hades Tempo Logic User manual Pag 5 Rain Sensor The timer can be connected to a Rain Sensor by wire or by radio When the level of water in the Rain Sensor rises above 5 mm the watering programme will be suspended automatically then resumed once the rainwater in the cup has evaporated Installation Remove the protective jumper from the rain sensor contacts no tools are needed If the Rain Sensor is not going to be used the jumper must remain in place across the contacts Wired Rain Sensor Fit the connector of the sensor lead Check that the two core cable enters the timer by way of the slot provided in the rear of the housing cod 8480 For Tempo Logic cod 8483 GlISGER Tempo Logic User manual PROTECTION IN WINTER At the end of the watering season and before winter disconnect the timer from the tap remove the batteries and store the device indoors protected from frost and damp This will ensure that the timer rema2. Habes Tempo Logic User manual CLEANING THE FILTER The timer is protected by a wire mesh filter that ensures long lasting and trouble free operation The filter should be inspected periodically and washed at the beginning of every season Simply remove the filter from the connector and rinse clean under running water Q Washing at start of season For Tempo Logic cod 8483 ITTING REPLACING THE BATTERIES To fit or replace the batteries press the locking tab fully in to release the front part o the timer which can then be detached Fit 2 new batteries in the holder observing the correct polarity As long as the batteries are replaced within 2 minutes the current settings will remain stored Refit the front part of the timer to the back and press ensuring that the locking tab clicks into place Important always replace the batteries at the beginning of each season 1 5V AA Alkaline For Tempo Logic cod 8483 Habes Tempo Logic User manual INSTALLATION Fit the timer to a cold water tap following these simple instructions The spout of the tap should have a 3 4 male thread if not use an adaptor Screw the clamp collar of the 3 4 female fitting onto the tap Cau tion tighten the collar using hand pressure only Do not use wrenches or other tools Connect the watering line to the quick click or threaded fitting using the appropriate connector Remember to turn on the water tap For Tempo Logic cod 8483 SELECTIO
3. N OF WATERING PROGRAMME Press any button once to light up the display Press button P once or repeatedly to select the desired watering programme e g 3 times The selected programme appears in display field C 3 the watering time is displayed in field D 1 min and the watering frequency the interval of time between successive watering cycles is displayed in field E 12h The time and frequency of watering are factory set and cannot be changed by the user Programs available min every min every min every min every min every min every min every min every min every MANURE START min every 2 min every min every min every min every min every min every min every min every min every OUW AOUNAUN WONADAUBWN HOKUBNAUBWN VVVVVVVVVVVVVVVVV VV ee ee h ounwaounn nnN For Tempo Logic cod 8483 Habes Tempo Logic User manual Immediate start Within 10 seconds of selecting the programme press the START button once only Releasing the button the message 0 h blinks 3 times in the display and the automatic watering cycle will start straight away The symbol appears in display field C indicating that watering is in progress together with the time remaining until the end of the cycle At the end of the watering cycle display field C shows the X symbol together with time remaining until the start of the next watering cycle 2 9 Watering in pr
4. ins as good as new for many springs and summers to come R D For Tempo Logic cod 8483 For more information and further details please consult the instruction manual supplied with the product
5. ogress Time until next watering MANUAL START MANUAL START 3 sec ON OFF NNNNN PISCE OBS OONO rbperercrererercsercrererer For Tempo Logic cod 8483 Delayed start Within 10 seconds of selecting the programme press the START button repeatedly until display field C shows the delay between 1 and 23 hours before the start of the automatic watering cycle e g 6 hours Release the button and the number of hours will blink 3 times after which the programme begins the countdown to the auto matic start of the watering cycle shown in display field C above the X symbol Making changes to the watering programme Repeat the programming procedure as indicated in the selection of watering programme section e g changing from program 3 to 5 The new programme will replace the previous one with no further steps required MANUAL START 3 sec a OuUWsOUN uUN COVANAWNFODONAUAWN For Tempo Logic cod 8483 abdes Tempo Logic User manual MANUAL WATERING Press the MANUAL button and hold it for at least 3 seconds the unit goes into manual mode with the valve off OFF blinking Pressing the START button the line will be activated for 5 minutes which cannot be changed by the user confirmed by the symbol To stop watering before 5 minutes have elapsed press the START button a second time To quit the manual function make certain that the valve is OFF then press the MANU
Download Pdf Manuals
Related Search