EVENT HORIZON 3 - PWE Amplifiers
Contents
1. EVENT HORIZON 3 Front Panel Channels 1 and 2 share the EQ section but have separate bright controls gain and level controls This allows the player to fine tune the sound of each channel despite the shared EQ Channel 3 has its own separate EQ as well as bright control gain and level Channel switching is accomplished via the pushbuttons above the bright controls for all channels Bright switch bypasses highs and adds shimmer to the sound Gain controls the amount of signal going to the next stage Treble Mid Bass EQ section Level adjusts the signal to the phase inverter Please note it is normal to hear a slight pop when switching channels due to the use ofrelays We feel this is best for signal integrity Rear Panel Mains Fuse 2 5 amp slo blo on 50 watt models 5 amp slo blo on 100 watt models Initiate power on switch HT Fuse 0 5 amp slo blo on 50 watt models 1 amp slo blo on 100 watt models Engage turns on the high voltage to the amplifier circuity Decelerator output power control 15w to 50 w or 30w to 100w This is not intended to be a bedroom level control or a substitute for an attenuator The goal is to change the feel ofthe amp similar to using a variac Turning this control down will result in a change in volume and feel The amp will soften up and will give a less immediate attack Presence for more or less high end in the power section Deep gives a boost in the low frequencies in the power section2. Completely counterclockwise it is out of the circuit Feedback controls negative feedback in the power section Counterclockwise results in a tighter sound and feel Turning this control clockwise gives more highs and lows as well as a looser more open sound Footswitch jack 4 pin locking connector for the supplied footswitch connector Effects Loop Transmit output level to the effect Receive level recovery to the power amp Impedance selector switch 4 8 16 ohms Set only to the impedance that matches the speaker cabinet This controls total output impedance When using two cabinets the sum must match the control setting Speaker out jacks use either one or both when connecting two cabinets Warning This amplifier must be connected to a speaker matching the impedance setting at all times when in use Failure to do so may result in serious damage to the amplifier and compromise safety Warning This amplifier must be connected to a properly grounded outlet matching the factory voltage setting and using the supplied power cord Never operate outdoors or in damp or wet environments No user serviceable parts inside do not open under any circumstances Servicing must be performed by a qualified technician Warranty Your Event Horizon 3 comes with a 2 year non transferable warranty for parts and labor Tubes are not included in this warranty Tampering with or modifying this device in any way voids the warranty All units must b
3. e returned to PWE for warranty service unless prior authorization has been given in writing from PWE The user shall be responsible for all shipping costs to and from PWE Amplification No unit will be accepted unless prior arrangements have been made PWE Amplification 5445 de Gaspe suite 310 Montreal QC H2T 3B2 Canada 514 272 7070
Download Pdf Manuals
Related Search