Manual
Contents
1. SMART for You SMART for the Planet Infrared Fireplace Heater OWNERS INSTALLATION AND OPERATING MANUAL Model LS IF1500 DOFP Safety Notice Please read this entire Installation and Operating Manual BEFORE installing and using your new Infrared Fireplace Heater Failure to fully understand and follow instructions may result in property damage bodily injury or even death If your Infrared fireplace heater is not used properly a house fire may result For everyone s safety FOLLOW all Installation and Operating Directions Infrared fireplace heaters have been designed for use in the US and are suitable for mobile homes Save These Instructions TABLE OF CONTENTS Topic Page s Introduction 3 Specifications 3 Safety Information 4 5 Fireplace Placement 6 Fireplace Operation F Troubleshooting and Fireplace Maintenance 8 Warranty 9 10 Warranty Claim Contact Information 11 Contents in the box 1 Infrared Fireplace heater 2 Instruction manual 3 Remote control 2 AAA batteries not included 2 INTRODUCTION Thank you for choosing one of the best Infrared absorption fireplace heaters available in the market today By using this infrared fireplace heater you can efficiently heat up to 1500 square feet You can even turn down the main thermostat in your home and let this heater carry some of the home heating duty This fireplace heater is NOT intended to replace your homes furnace rather it is designed to be a suppleme2. and or owner transfer unless otherwise authorized by LIFESMART as the manufacturer Any extended warranties warranties that cover above and beyond this manufacturer warranty that are sold through a retailer or third party are not directly correlated with this LIFESMART limited warranty and may be redirected to said retailer or third party for coverage Extent of Warranty This warranty extends through the manufacturer of the product and covers functional parts only Cosmetics are not covered unless unequivocally determined it is a manufacturer workmanship defect Note that surface cracks are not considered defects in material or workmanship as they are normal characteristics of all wood Unless LIFESMART was the direct shipper shipping damage should be addressed with the shipping company retailer or place of purchase prior to making a claim to LIFESMART as the manufacturer The manufacturer s sole obligation under this warranty shall be limited to furnishing the original purchaser replacement parts for units deemed repairable by the LIFESMART warranty department The purchaser may also opt to ship the product to LIFESMART to have it repaired The purchaser will be responsible to prepay any shipping charges both ways export taxes custom duties and taxes or any other charges associated with the transportation of the unit In addition the purchaser is responsible for insuring any parts shipped or returned if desired For products the
3. or re locatable power tap outlet power strip This heater has a self protection function If the heater does not operate normally check cord and heater placement then UNPLUG IT FROM THE OUTLET amp PLUG IT BACK TO OUTLET TO RESET Grounding This heater is for use on 120 volts The cord has a plug with three blades for proper grounding DO NOT attempt to modify the plug in any way or use adaptors to defeat the purpose of the grounding feature Plug ONLY into a receptacle that accepts three blade plug FIREPLACE PLACEMENT Our Infrared fireplace heater is a very safe and effective room heater It produces safe clean and economical heat by utilizing quartz infrared heating elements and heat exchangers The heating process of the Infrared fireplace heater is similar to the way the sun warms the earth The infrared elements warm the heat exchangers and the whisper quiet fan distributes the accumulated warmth This process is unique among heaters in that it minimizes wasteful heat collection at the ceiling height of rooms and targets it toward the living space instead To achieve maximum efficiency of your Model LS IF1500 DOFP Infrared fireplace heater please consider the following recommendations 1 Locate your Infrared fireplace heater close to an inside wall of the room in which it will be used Face the exhaust vents of the heater toward the cooler outside walls of the house This positioning will allow the heat to be moved across
4. the room toward the outside walls to provide more even warmth throughout the room Make sure that windows and doors are not allowing a high rate of airflow into the room where you will locate your room heater High airflow will minimize the effectiveness of your Infrared fireplace heater as it would any conventional type heater For best results always try to maintain a minimum of 40 relative humidity in the environment to be heated lt is recommended that the Infrared fireplace heater be used in rooms that are insulated according to code You can use your heater in a room whether insulated or not but a non insulated room will cause greater and faster heat loss which is counterproductive to the efficiency of the heater Keep the area around the heater clear of clutter and obstacles so that there is free airflow to and from the heater Be mindful to keep your heater out of the main traffic thoroughfares of the room in which it is located it should be a welcome addition to the room rather than an obstacle to be stepped over or stepped around FIREPLACE OPERATION Plug your Infrared fireplace heater power cord into a 120V 15amp or 20amp three bladed receptacle To Turn the Fireplace On Press the Power button Jon the control panel or on the remote control Default Set Temperature The default set temperature every time the heater is powered on is l j typically 72 this cannot be changed L Ambient Temperature To view
5. S Quantity of 2 clear chandelier or candelabra bulbs with an E 12 small socket base rating voltage 120 volts rating power 40 watts CAUTION Do not exceed 40 watts per bulb CHANGING LIGHT BULBS Unplug the unit first 1 Open the light bulb area Hold left and right side of the cover of the light bulbs at the bottom of your firebox and pull straight out You can see two bulbs in the firebox 2 Examine the bulbs to determine which bulbs require replacement 3 Remove old bulb and replace with a new one Hold the socket while unscrewing or screwing bulbs 4 Replace the cover of light bulbs Limited Manufacturer Warranty 3 Year Limited Warranty LIFESMART warrants this heater against defects in materials and workmanship on functional parts for a period of 3 years from the original date of purchase Your sales receipt showing the date of purchase of the product is your proof of purchase Keep it in a safe place for future reference Manufacturer Warranty All LIFESMART products are manufactured with the highest quality materials and are warranted to be free from defects in material and workmanship at the time of purchase This limited warranty applies to products manufactured or distributed by the LIFESMART brand name are delivered in the continental United States and extends to the original purchaser or gift recipient This warranty becomes valid at the time of purchase and terminates either by the specified time frame listed above
6. he brightness of the flame and ember Press once the brightness will start and keep changing Press again to set the desired level TROUBLESHOOTING If your heater unit shuts off unexpectedly 1 Be sure the power cord is plugged into a working electrical outlet 2 Check for any obstructions If you find one turn the hearting unit OFF and unplug it Wait at least 10 minutes to allow the heating unit to cool completely before removing any obstruction When done plug in the heating unit and follow the Operation Instructions If your heater unit tips over 1 Set the unit back in its upright position and check for any damage is detected unplug unit and contact customer service for further assistance 2 If no damage is detected push the power button to turn the unit back on If your fireplace does not illuminate properly 1 The light bulbs may have vibrated loose and need to be tightened 2 The light bulbs may be damaged and need to be replaced FIREPLACE MAINTENANCE WARNING Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire electric shock to persons or damage LIGHT BULB REPLACEMENT Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity and detail of the log exterior disappears There are two bulbs under the log set WARNING Allow at least 5 minutes for light bulbs to cool off before touching bulbs to avoid burning of skin BULB REQUIREMENT
7. me phone number and possibly a copy of your receipt Be Patient Clear and Concise Describe the issue and symptoms you have for and about the product A certified LIFESMART Technical Support agent will give you an evaluation of your issue and your resolution options If the answer is not available at that time you will be referred to the appropriate channels or given a call e mail back within 72 hours with an answer or resolution E Mail is the Preferred Method of Communication 11 LSIF1500DOFP Printed in China
8. nt to it It is not an instant heater it can take up to 24 hours for a room to reach the desired temperature Our Infrared fireplace heaters have been tested and listed for installation in residential and mobile homes by UL LISTED 44YD E325948 SPECIFICATIONS Electrical Voltage 120V 60Hz Power consumption 1000 1500 Watts Thermostat range 50 90 Fahrenheit Coverage Up to 1 500 square feet Dimensions 25 2 Tall x 31 5 Wide x 11 5 Deep 55 Ibs Safety Features Overheat shut off Features Remote control Vivid Log Flame Effect Eco Friendly Wood IMPORTANT SAFETY INSTRUCTIONS READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE USING THE HEATER B ere POTENTIAL FOR ELECTRICAL HAZARD When using electrical appliances basic precautions should always be followed to reduce the risk of fire electric shock and injury to persons including the following 1 2 9 Read all instructions before using this heater This heater is hot when in use To avoid burns do not let bare skin touch hot surfaces If provided use handles when moving this heater Keep combustible materials such as furniture pillows bedding papers clothes and curtains at least 3 feet from the front of the heater and keep them away from the sides and rear Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended Always unplug heater when n
9. nts in and around the e Outdoor applications heaters e Normal wear tear weathering e Heater placed on non approved surfaces e Pet Consumer accidents e Electrical requirement deficiencies 15 20 e Purchases from dealers unauthorized by amp dedicated outlet LIFESMART Authorization in writing e Use on Extension Cords Timers Surge Protectors GFCI Disclaimers LIFESMART shall not be liable for any loss due to use or misuse of the heater or other LIFESMART products or other incidental or consequential costs expense or damages without irrefutable foundations Under no circumstances shall LIFESMART or any of its representatives be held liable for injury to any person or damage to any property however arising Any implied warranty shall have duration equal of the applicable warranty stated above Specifications are subject to change without notice or obligation Legal Remedies This limited warranty gives the original purchaser specific legal rights Other rights may vary from State to state 10 Customer Service and Support To Obtain Warranty Support or Advice Please Complete These Two Easy Steps Contact LIFESMART PRODUCTS Technical Support E mail Warranty lifesmartproducts com Phone 1 866 484 2066 or 1 214 614 2509 Visit us www lifesmartproducts com You will need to provide the unit s model number serial number located on the heater s front panel rear panel or on the box date of purchase retailer of purchase a dayti
10. ot in use Do not operate any heater with a damaged cord or plug or after the heater malfunctions has been dropped or damaged in any manner Return heater to authorized service facility for examination electrical or mechanical adjustment or repair Do not use outdoors This heater is not intended for use in bathrooms laundry areas and similar indoor locations Never locate heater where it may fall into a bathtub or other water container Do not run cord under carpeting Do not cover cord with throw rugs runners or similar coverings Arrange cord away from traffic area and where it will not be tripped over To disconnect heater turn controls to off then remove plug from outlet 10 Connect to properly grounded outlets only 11 Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire or damage the heater 12 To prevent a possible fire do not block air intakes or exhaust in any manner Do not use on soft surfaces like a bed where openings may become blocked 13 A heater has hot and arcing or sparking parts inside Do not use it in areas where gasoline paint or flammable liquids are used or stored 14 Use this heater only as described in this manual Any other use not recommended by the manufacturer may cause fire electric shock or injury to persons 4 15 Always plug heaters directly into a wall outlet receptacle Never use with an extension cord
11. the ambient room temperature press and hold the Temp up ti KOKEN Dimmer Haale vale button for a few seconds the room temperature will display for a short period of time then return to the desired set temperature Control Panel To Set Desired Temperature Press the UP or DOWN button on the control panel or on the remote control When the desired set temperature is reached by the heater s internal thermostat the heater will stop heating automatically but the fan will continue to run for approximately 5 minutes 3 minutes when powered off so that unit s chamber can cool When the ambient temperature drops below the set desired lt temperature the heater will cycle on again Remote Comino To Set Heat Level Press the H L button KSJ on the control panel or remote control to switch between High and Low heat The corresponding High H or Low L light will switch on In the High mode the fan will not change speeds Rather the heating elements will allow for higher heat output The High level uses 1500 watts while Low heat level uses approximately 1000 watts Celsius and Fahrenheit The heater displays temperature in Fahrenheit as the default but has the capability to display it in Celsius as well To change between Celsius and Fahrenheit Press To Set Flame Brightness Use the Dimmer button z on the control panel or remote control The flame brightness control button is used to increase or decrease t
12. warranty department deems un repairable or discontinued LIFESMART reserves the right to issue a refurbished product or product similar in size and functionality as a replacement for the defective unit if available All exchanged parts and products replaced under this warranty will become the property of LIFESMART LIFESMART reserves the right to change manufacturers of replacement parts or products for use in order to cover any existing warranty Any parts determined defective may asked to be returned to LIFESMART or its representatives to validate a claim Non Warranty replacement parts will be warranted 30 days from the time the purchaser receives them The purchaser must present LIFESMART with proof of purchase documents including the date of purchase if requested Any evidence of alteration erasing or forgery of proof of purchase documents will be just cause to VOID this limited warranty Products in which the serial number has been defaced or removed are not eligible for warranty coverage Continued Warranty Limitations This warranty does not apply if the unit has been subject to negligence fabrication misuse abuse or repairs unless authorized verbally or in writing by an Authorized LIFESMART Representative alteration by non LIFESMART authorized personnel inappropriate installations or any case beyond the control of LIFESMART Examples of warranty invalidation may also include but are not limited to e Use of lacquer or pai
Download Pdf Manuals
Related Search