System Operating Manual Operating Manual for ZG-RGB
Contents
1. System Operating Manual Operating Manual for ZG RGB LEDT 16W Mains light source Introduction The ZG RGB LEDT 16W Mains light source is suitable to be used in both domestic and commercial situations Its compact and slim design is complimented by its ultra quiet operation The unit contains LED lamps with a typical lamp life of 50 000hrs which gives the unit an average operating life of 20 years The LED light source generates very little heat hence keeping the working temperature low solving any heat related deterioration on the fibre optics Safety Instructions 1 Please read the manual before use 2 This unit is not water proof and must be kept dry 3 Unit must be operated in a well ventilated environment Not suitable for use in a totally enclosed space Technical data Dimensions Weight Voltage Operating Fibre optic Max fibres in temperature port size port 0 60kg 100V 250V 10 to 40c 20mm 0 75 550 50Hz 60Hz 1 0 350 Front View Fastening Screw t 0000 4s Coupling head _ E if i 0000 X NNN YY Aw 0000 he Rear View Colour Changing Modes There are two colour changing modes 1 Shift Colour Mode Quick instant colour change from one colour to the next 2 Transit Colour Mode Gradual colour change from one colour to the next Operating Instructions Control Panel 1 The unit is supplied with a Mains cable and 3 pin plug to enable it to be connected to mai2. ns power source 2 Switch on the unit with the ON OFF switch situated on the rear panel 3 If the button on the front panel is pressed for longer than 1 second the colour mode will change between Shift and Transit 4 If the button on the front is pressed for less than 1 second it will hold or release a single colour Example If Red is required permanently when the unit is displaying red press the button once to hold that colour 5 To exit fixed colour mode simply press the front button again Note After each Button is pressed the unit should beep once Synchronising Set all for the units that are to be synchronised to the same change mode and the same colour if required Then connect all of the units required to the same mains circuit and make sure the power is off for 2 minutes Turn the mains circuit on and all of the units should now be synchronised CE Mark C This product is CE marked 2010 ZG RGB LEDT 16W MAINS Operating Manual
Download Pdf Manuals
Related Search