V:\R&D\MANUALS\Magnum 950 Manual.cdr
Contents
1. Mains input Remote input Contents 1 x Smoke Machine 1 x 2 5 Litre Fluid Bottle 1 x IEC Mains Lead 1 x Remote Control Assembly Remove the bottle from its compartment and fill with JEM MARTIN approved fluid Place the bottle back in the compartment as per drawing Place the pipe that is attached to the smoke machine inside the bottle and firmly screw down the cap Safety Always use a JEM MARTIN approved fluid other fluids could be dangerous and can cause damage to the machine Always check the voltage is correct for use with the machine the voltage is printed on the serial label Always read the instructions for use before operating the machine Smoke machines need to be operated carefully to avoid risk of discomfort or injury Never touch the nozzle at the front of the machine the nozzle can stay hot for up to 10 hours Prolonged use of fog machines may result in the build up of a slippery residue on floors and surfaces This should be monitored and cleaned when necessary to avoid injury to persons Mains on off o Fluid Bottle ip li Do not remove the cover or attempt to repair a faulty machine an authorized JEM MARTIN dealer should be contacted in the event of a fault Always use smoke machines in well ventilated areas Over use could affect sufferers of asthma or other serious respiratory disorders Do not use the machine if there is a fa2. ulty mains lead or plug as this could be dangerous Do not spill fluid over the machine if fluid is spilt wipe down with a clean damp cloth An approved JEM MARTIN dealer should be contacted for advice Keep the output of the machine at least 60cm 2 ft away from people and surfaces v Martin Mains Lead Wiring Instructions Brown Live Blue Neutral Green Yellow Earth Always use the correct Fuse in the machine E U 10 amp US 15 amp Note This Appliance Must Be Earthed Instructions for use Connect the two leads into the sockets as indicated Turn the machine on the on off button and the remote control light will illuminate From cold the machine will take approximately six minutes to reach operating temperature When the light on the remote control has gone out the machine is ready to use If this is the first time the machine has been used or the bottle has been changed the pump will require priming Press the button on the remote control until smoke emerges from the output nozzle this will take approximately five seconds When the light on the remote control comes on again it indicates that the machine is reheating this will take approximately 20 seconds Olof Palmes Alle 18 DK 8200 Aarhus N Phone 45 87 40 00 00 Fax 45 87 40 00 10 Internet www martin dk
Download Pdf Manuals
Related Search