tp 2000 quick start up procedure
Contents
1. TP 2000 QUICK START UP PROCEDURE For Detailed Instructions See User s Manual Cut remove and properly dispose of all straps Remove and dispose of main carton top and packing materials Retain carton containing accessories Move the printer off the skid and to the location for operation At least two people should be used to lift and move the printer Follow all proper lifting techniques to prevent injury as printer weighs approximately 100 lbs Dispose of carton tray and skid Open carton containing accessory items remove contents and dispose of carton Install Paper Stack Rack and Anti static paper guide with Phillips screwdriver Install the ribbon using instructions below or page 43 in Operator s Manual if _ lt f a Raise the printer access cover and locate the green knob on right side of chassis Turn knob counter clockwise until it stops b Remove the ribbon from package and elastic band from ribbon guide c Move the print head to center of printer by hand Place the ribbon guide in roughly the center of ribbon loop Turn the ribbon advance knob to tighten loop 2 2 f Place the cartridge in printer engaging pins in rear and pivot down under spring retention clips The ribbon loop must go in front of platen g Place the guide on the nose of the print head and snap down into position h Route ribbon behind pins to the le2. ft and right of print head i Remove any ribbon slack by slightly turning the ribbon advance knob Make certain that the power switch is in the OFF 0 position The host computer system should also be off or manually switched off line Connect the communications cable to the RS 232C port on the rear of printer and the host computer Adjust the serial interface settings under Menu 5 if required oe gg png Verify that voltage setting is correct U S A 115V Verify power receptacle is properly grounded Attach power cord and turn power on 9 Run aprinter self test to verify proper 8 Load paper using instructions below operation or page 32 in Operator s Manual a Press the SETUP key b Press FEATURE key once The LCD displays RUN SELF TEST c Press ENTER the self test starts rr HAAA d Press ENTER again to stop test a j e Press the LINE LOCAL key to place Jle printer on line B LF a Press the LINE LOCAL key to take printer off line b Place and align supply of forms directly below tractor guides oo re PAPER EDGE sf ALIGNMENT LEFT TRA D c Unlock both tractors and position left tractor with alignment mark on printer allow ri
3. ght to float d Open doors on both tractors e Load top three holes of both sides of form min width 8 5 in on the bottom three tractor pins on both wheels f Close doors on both tractors g Lock right side tractor h Press the LOCAL FF LOAD key i Load profile that matches the current document 7a a o N PUES Sry l io Part No 109610
Download Pdf Manuals
Related Search