DRONIUM - Protocol RC Helicopter
Contents
1. Pull the direction stick left or right the Pull the throttle left to the left or right quad copter turns to the left or right the quad copter banks to the left or right TRIM ADJUSTMENT FORWARD BACKWARD TRIM SIDEWAYS TRIM LEFT RIGHT TRIM Ae BRO EE When the quad copter veers When the quad copter veers to When the quad copter keeps forward backward unintentionally the left or right side unintentionally spinning left or right unintentionally you can correct it by pressing you can correct it by pressing the you can correct it by pressing the the trim button in the opposite trim button in the opposite direction trim button in the opposite direction direction until it evens out until it evens out until it evens out TROUBLESHOOTING Symptom Possible Cause Potential Solution 1 To synchronize turn on controller then 1 Communication between controller and turn on aircraft and place it on level Dronium aircraft was not synchronized during set up ground Move throttle stick all the way does not forward then all the way back respond 2 Battery power depleted on aircraft controller or both 2 Charge aircraft and or replace batteries in controller Response to 1 Controller battery power nearly depleted 1 Replace batteries in controller control inputs intermittent 2 Aircraft antenna is damaged 2 Repair antenna or erratic Symptom Possible Cause Potential Solution The Dronium 1 The aircraft w2. DrONIUM 4 A SY 2 e 4 CHANNEL RADIO CONTROLLED QUAD COPTER FEATURING 1 Four Rotor design allows great speed and maneuverability for both Indoor and Outdoor use 2 Built in 6 axis Gyro ensures excellent stability 3 Modular design for increased ease of maintenance 4 360 degree 3 dimensional stunt and tumbling function The materials and specifications stated in this instruction manual are for reference only PROTOCOL Pilo s Handbook for DRONIUM 4 CHANNEL RC VipEo DRONE Thank you for your purchase of Protocol s Dronium 4 Channel RC Video Drone You are about to experience the best of what remote control flight has to offer We strongly recommend that you take the time to read this N manual thoroughly It contains many tips and instructions on how to get the most out of this aircraft and maintain it for a long life As with any aircraft this is a precision flying machine Treat it well and enjoy all the fun it has to offer flight after flight SCHEMATIC Rotor Guard Canopy Top N l J e i y M AI f y i Al a IS H yk d O oi g Landin Skid Canopy Bottom Camera SAFETY AND PRECAUTIONS Keep small parts out of reach of children to avoid accidents The quad copter is powerful and fast accelerate gently to avoid damage and accidents After flying disconnect the battery Keep the battery away from
3. as not on level ground 1 Re synchronize aircraft and controller will not hover during synchronization or strafe 2 Reset the trim buttons on the controller correctly 2 Trim settings are incorrect and re trim flight controls Restart function In case of flight disorder restore factory default settings by the following methods 1 Press the power switch to turn on the transmitter 2 Press the power switch to turn on the quad copter 3 When the quad copter indicator flashes slowly push the throttle lever to the highest position and then pull it back to the lowest position The quad copter indicator will change from slow flashing to steady mode 4 Place the quad copter on a horizontal position then push both left and right lever on the transmitter to the lowest right corners for 2 3 seconds The indicator on the quad copter will change from normal light to quick flashing light After 2 3 seconds the indicator will change back to the normal light This means the quad copter has restarted reset successfully TIPS ON 3D STUNT amp TUMBLING OPERATION Once you are familiar with the basics of quad copter flight you can try some advanced maneuvers At a height of at least 10 feet press the STUNT button on controller s right side then move the right stick in whichever direction desired to perform a 360 degree flip in that direction TOSS N LAUNCH Thanks to the 6 axis gyro you can toss the quad copter and push the
4. ator will change back to steady green 4 To view and or remove recordings images remove the memory card from the rear of the camera by pushing in the card and then allowing it to spring out enough to remove the card out of the slot 5 Insert the memory card into the slot on the back of the provided USB adapter If your computer features a memory card reader that fits this memory card then you do not need to use the USB adapter 6 Place the USB adapter into the USB port of your computer If you are using Windows the USB will come up as the E drive If you are using OS then the USB will come up as Untitled 7 Open the DCIM folder and then open the DSCIM folder to access the AVI or JPEG files 8 AVI movies can be played in several different formats including Quicktime Windows Media Player and RealPlayer Note 3D rollover function on this aircraft is automatically suspended when camera is installed WARNING Never remove the card from the video camera while the helicopter is turned on NOTES All files on the card can be removed or erased without compromising the video camera Replacement Parts Thank you for your purchase of Protocol s Dronium 4 Channel RC Video Drone We know that accidents can sometimes happen and that is why we offer spare parts kits on our website ProtocolINY com Limited Warranty At Protocol we re dedicated to bringing you innovative and well designed products that make living
5. fun and easy We stand behind all of our products and warrant this to be free from defects in workmanship and materials for 30 days from the date of purchase The warranty does not cover transportation damage misuse crashes accident or similar events Specific legal rights pertaining to this warranty may vary by state For service claims or questions please consult our website ProtocolNY com PROTOCOL
6. heat sources and or fire Keep the quad copter at a distance of at least 2 meters from yourself others and obstacles to prevent damage Children should operate the quad copter only under adult supervision The remote controller batteries can not be recharged Do not mix new batteries with old batteries or mix batteries of different types 8 Always turn off both the transmitter and quad copter when not in use 9 Never attempt to short circuit the battery terminals or the quad copter O AON NO REMOTE CONTROL KEYPAD AND LCD MANUAL Antenna Indicator Light MODE1 High Low Speed ol l mode selector 3D Stunt Power Switch a a Right function lever m m 4 way directional o o Left function lever gt a ld p Throttle Oo m Oo Oo Photo Fine tune a B Video Forward Backward o o Fine tune Mode Switch Turn left right Fine tune y 06 Mode 1 Strafe left right oooooo0o0o0000 ooooo0o000000 Mode 1 rN Fine tune i 03 01 Strafe left right LCD Display Fine tune left right Mode 2 daa DOUDOU OODO DODO OADDTT DOT OLOODTD ODOTETTU Remote Control Keypad and LCD Manual Fine tuning Side to side Strafing defaults to center on start up Fine tuning Forward Backward defaults to center on start up Fine tuning Turn Left Right defaults to center on start up Fine tuning Throttle defaults to center on start up Throttle defaults to zero on start up Directional Display defaults
7. rd impacts or sharp surfaces 5 Do not use any other charger than that which is supplied with this item 6 Do not use or leave battery near a heat source such as fire or space heater exposure to heat may result in reduced performance or in some cases dangerous conditions 7 If battery is left in charging state for an extended period of time after being fully charged the battery may automatically discharge 8 Never leave the battery unattended during charging 4 BATTERY REPAIR amp MAINTENANCE 1 Do not immerse or submerge battery in water store in a cool dry location 2 In order to increase battery longevity avoid repeat charging and excessive discharging 3 Charge battery to approximately 55 capacity prior to long term storage 4 If battery sees no use for extended periods of time it is recommended that battery voltage is kept above 3V Check monthly and recharge as needed 5 Do not disassemble battery INSTALL LANDING SKIDS amp BLADE PROTECTION FRAME FIG 1 FIG 2 1 Install the landing skids to the bottom of the quad copter Figure 1 2 Install the blade protection frame to every corner and tighten the screws Figure 2 NOTE If the quad copter crashes double check to make sure the blade protection frame is not loose If it is re tighten before flying HIGH LOW SPEED MODES The Dronium features 2 speed modes Low speed is for beginners and high speed is for advance users High Low Speed Press
8. the speed mode button to adjust speed mode selector OPERATION MODE 1 Push the throttle up or down the quad Push the direction lever up or down the copter flies upward or downward quad copter flies forward or backward TURNING LEFT AND RIGHT SIDEWAYS FLIGHT Pull the throttle left or right the quad Pull the direction left to the left or right copter turns to the left or right the quad copter banks to the left or right TRIM ADJUSTMENT FORWARD BACKWARD TRIM SIDEWAYS TRIM LEFT RIGHT TRIM When the quad copter veers When the quad copter veers to When the quad copter keeps forward backward unintentionally the left or right side unintentionally spinning left or right unintentionally you can correct it by pressing you can correct it by pressing the you can correct it by pressing the the trim button in the opposite trim button in the opposite direction trim button in the opposite direction direction until it evens out until it evens out until it evens out OPERATION MODE 2 Push the throttle up or down the quad Push the direction lever up or down the copter flies upward or downward quad copter flies forward or backward TURNING LEFT AND RIGHT SIDEWAYS FLIGHT
9. throttle up It will automatically level out and hover smoothly in the sky CAMERA If the camera is not pre installed 1 Push the camera into the hold below the battery cover Figure 1 2 Open the battery cover with camera Figure 2 3 Tighten screws to secure the camera Figure 3 4 Close the battery cover with camera and insert the 3 pin plug to the hold inside Figure 4 PHOTOGRAPHY VIDEO INSTRUCTIONS 1 Make sure the 3 pin plug of camera is inserted into the quad copter 2 Turn the quad copter on The camera is functioning when the red indicator on the camera changes from flashing red to steady green If the red indicator is continuously flashing it means the SD card is not in the camera Please insert the SD card and the indicator will change to green Shooting Photos and Video 1 Turn on the transmitter and pull the throttle up and down to connect the quad copter and transmitter 2 Photo Push the Photo Video Selector up and the camera will take a photo after a beep from the transmitter The green indicator will briefly turn red and flash as it s taking the picture 3 Video Push the Photo Video Selector down and the camera will begin to record after a beep from the transmitter The green indicator will change to red and will continuously flash while recording video Push the Photo Video Selector button back to the center to stop recording The transmitter will beep and the red flashing indic
10. to center on start up Lateral Movement to Right Rearward Movement Lateral movement to Left Right rotational movement defaults to zero on start up Left rotational movement defaults to zero on start up High Speed Mode Active Low Speed Mode Active Controller Battery Level Indicator Flight Mode 1 Active Default To change to Mode 2 press and hold Mode Switch to the right before turning on the transmitter Remote control signal strength Indicates positive communication lock with the Dronium 4X1 5V AA batteries Unscrew and remove battery cover from R C unit insert 4 AA batteries noting polarity indicators Replace battery cover 1 Install batteries carefully A 2 Do not mix old and new batteries 3 Do not mix different types of batteries FLYING THE QUADCOPTER Step 1 Push the ON OFF Step 2 Open the battery Step 3 Close the battery power switch up cover and insert the cover and turn on the battery into the power port quad copter Step 4 Push the throttle lever to the highest position and then pull it back to the lowest position There will be one beep from the transmitter This shows that the quad copter has synced with the remote Tips When syncing your quad copter keep it in a horizontal position for stable flight If the Dronium and the remote do not sync after following the Pre Flight checklist reverse the first t
11. wo steps of the process Turn the remote off and unplug the cable from the Dronium Then turn on the remote first and then plug the cable back into the Dronium to turn it on Follow with Step 4 2 Turn on the controller if after 30 seconds it has not recognized the helicopter turn off controller to retry synchronization 3 If quad copter s LED blinks slowly it means it has not recognized the controller please restart pre flight procedure 4 If the Dronium is unsteady in flight it may not have been able to calibrate horizontally Power down both vehicle and remote and restart pre flight procedure CHARGING THE QUAD COPTER BATTERY 1 Push the on off switch of the 2 Pull out the battery wire from quad copter to OFF and open the power port the battery cover Vera 3 Connect the USB charging 4 Plug the charger into a USB cable to the battery wire port The USB will light up while charging and will turn off once fully charged 5 Reconnect the battery wire to the power port and close the battery cover Charging time approximately 75 minutes Flying time approximately 7 minutes CAUTION WHEN CHARGING 1 When charging place product on a dry well ventilated surface and keep away from heat sources 2 Always use adult supervision while charging 3 As battery temperature is high immediately after flight charge after cooling down for higher efficiency 4 Do not strike or subject battery to ha
Download Pdf Manuals
Related Search