Home

Untitled

1. INSTALLATION AND OPERATING INSTRUCTIONS 5 AQUWIAPORT C Product Use D Chiller Unit Not Used For Long Periods Always closely supervise children around this appliance If the unit has not been used for a long period of time turn the unit off from the power switch and unplug Disconnect the inlet and outlet pipes and use clean compressed air to blow through the inlet pipe If the supply cord is damaged it must be replaced by the manufacturer its service agent or similarly qualified persons in order to avoid a hazard The Undersink Water Chiller has been rated to provide a limited WARNING excess water may leak when disconnecting number of servings per hour When cleaned reinstall unit according to the installation Based on an ambient water temperature of 23 C the unit should instructions on page 5 and flush unit for 2 3 minutes provide 7lt of cold water per hour under 10 C Use a soft damp cloth to wipe down the unit If a large amount of water has been drawn from the Undersink Do not submerge the unit in water or spray with any substance Water Chiller it will take approximately 2 3 minutes to recover in including water order to provide cool water under 10 C Do not hesitate to contact our Customer Care Service line on 1300 764 325 or aquaport aquaport com au 6 INSTALLATION AND OPERATING INSTRUCTIONS G Trouble Shooting BEFORE YOU CALL FOR SERVICE PLEASE REVIEW THE TROUBLE SHOOTING TIPS FIRST Problem No power
2. Not cooling Water is leaking No water flow from faucet Bad taste from faucet Noise from fan or unit Possible Causes Is the unit plugged into the wall socket Build up of dust maybe clogging fan grill Is the fan and compressor running Loose hose connection Water pressure is too high Internal connection maybe have come loose Inlet and outlet hose connected incorrectly Filters are blocked Filtration shut off valve turned off Unit is freezing Unit is new Filters are old Contaminated water supply Improper installation Damaged during freight What To Do Check connection to wall socket Turn off unit and clean dust from fan grill Check connection to wall socket if ok then call customer service on 1300 764 325 Turn off water supply to unit and ensure all hose connections are secure Check pressure limiting valve is installed and set to 100PSI Call customer service on 1300 764 325 Ensure the outlet and inlet connections are installed correctly Replace filters on filtration system Turn on shut off valve to filter system Cooling pipe inside unit may have frozen Call customer service on 1300 764 325 Flush water from the unit thoroughly for 10 mins to alleviant taste Change filters on filtration system Check with water supplier to ensure water has not been contaminated Turn off unit and ensure the unit is on a solid level surface Call customer service on 1300 764 3
3. Filtered Water Faucet OOOI LIRA RRR RRR RRR PKR RRR KY SOOO X lt x Product A B amp D sold separately Foot Rubber Ring Side Panel Outlet Quick Fitting Compressor Mounting Plate k S b 4X K Aluminium Board PE Tube Thermostat Power Cord Fan Condenser INSTALLATION AND OPERATING INSTRUCTIONS 3 AQUWIAPORT B Chiller Unit Installation The Undersink Water Chiller is an additional item that is to be installed in conjunction with an existing filtration system If you have purchased the Undersink Water Chiller with a separate filtration system the Undersink Water Chiller must be installed last Please follow all instructions relating to the filtration system before installing the Undersink Water Chiller The following installation instructions only apply to the Undersink Water Chiller once a filtration system has been installed by a qualified plumber or technician 1 Close the filtration systems shut off valve and drain any excess water from the faucet 2 Disconnect the outlet hose from the filtration system Note some water may leak from the hose 3 Place the Undersink Water Chiller under the sink or close to your filtration system Ensure the unit is at least 1
4. 00mm away from any obstruction to allow sufficient air ventilation from either side 4 Once the Undersink Water Chiller has been placed correctly measure the distance from the outlet of the filtration system to the inlet of the Undersink Water Chiller Cut a piece of 1 4 hose supplied so that is will reach both outlet and inlet Allow at least 20cm for slack 4 INSTALLATION AND OPERATING INSTRUCTIONS Note The connection hose on the Undersink Water Chiller inlet is permanently attached to the unit 5 Connect the outlet on the filtration system to the inlet on the Undersink Water Chiller Note both outlet and inlet should be supplied with a quick fitting connection the hose must be pushed in and far as possible then pulled back to ensure a tight connection has occurred refer to page 5 for instructions 6 Disconnect the 1 4 hose connected to the faucet and install the 1 4 hose from the outlet of the Undersink Water Chiller unit to the faucet 7 Ensure that the water inlet pressure does not exceed 7 Bar 1OOPSI before turning the unit on A pressure limiting valve maybe required refer to a qualified plumber 8 Open the shut off value to the filtration system and turn on the faucet to allow the water to flow It may take a few minutes for the water to go through the system 9 Ensure all connections are water tight and no leaks occur before plugging the Undersink Water Chiller into the water socket and turning on Not
5. 25 INSTALLATION AND OPERATING INSTRUCTIONS 7 AQUWIAPORT H Your Aquaport 12 Month Replacement Warranty Aquaport warrants this appliance to the first purchaser and subject to the stated conditions Warranty warrants any defect in materials or workmanship in the manufactured product within the first twelve months from the date of purchase will be repaired or the unit will be replaced at our discretion The Undersink Water Chiller has a maximum and minimum water Supply pressure limits The water supply pressure must not exceed the maximum and minimum water supply pressure limits specified in the Systems Specifications on page 4 step 7 Register online now for your chance to win monthly prizes at www aquaport com au 8 INSTALLATION AND OPERATING INSTRUCTIONS Conditions Of This Warranty 1 This product has been fully installed in accordance with the user manual installation instructions and relative plumbing codes and the working pressure does not exceed the limits stated herein Note We recommend a qualified licensed plumber install the system who is prepared to guarantee their workmanship 2 The warranty extends only to repairing or replacing any component that proves to be defective in material or workmanship The warranty does not cover defects occasioned by misuse alterations accidents or used for other than the intended purpose The warranty does not cover use of this product where water is mi
6. Installation amp Operating Instructions II 7 1 117114 2 VILLILLL LLL LA MUMIA a Pz wm se EST AQUWIAPORT Congratulations on your purchase of an Aquaport water chiller unit AQUAPORT SELECT 3 STEP SYSTEM Thank you for purchasing the Aquaport under sink water chiller This unit is easy to install in conjunction with any Aquaport under sink water filtration system and can also be installed with any existing filtration system The unit is designed to provide It of chilled filtered water on tap per hr Note Please read through the instructions carefully before using or installing the product and ensure that the manual is kept in a safe place for future reference The system must be properly installed and located in accordance with the installation instructions before it is used Register your warranty online at www aquaport warranty CUSTOMER HOTLINE 1300 764 325 Aquaport Corporation Pty Ltd PO Box 81 Findon SA 5023 Australia Maxima Water Temperature 3896 Telephone 1300 764 325 Min Operating Temp 5 C 40 F Facsimile 08 8354 0722 Electrical Requirements Australia New Zealand 240V 230V 50Hz Email aguaport aquaport com au i i N 23934 Maximum Pressure 690 KPA 100 psi Web www aquaport com au Climatic Class T IMPORTANT SAFEGUARDS When using electrical appliances basic safety precautions should always be followed Read all instructions carefully Ventilation The air vents
7. This appliances is designed for either household or personal use A Component identification and content check list Each model is designed to supply a certain maximum number of servings per hour Please consult with your sales representative or our Website for the proper Aquaport unit for your specific needs Model AQP UBC Undersink Water Chiller Any servicing other than cleaning and user maintenance will violate Ref Description AY the terms of this WARRANTY 1 Undersink Water Chiller 1 2 3m of 1 4 hose fe 3 3 8 to 1 4 Right Angle Quick Fitting 1 CAUTIONS installed on unit e Do not immerse base in water or try to disassemble e Do not lay unit on its side always keep flat 3 e f the supply cord is damaged it must be replaced by the a Z manufacturer its service agent or similarly qualified persons in q order to avoid a hazard RN ml e Check voltage to be sure that the voltage indicated on the SSS nameplate agrees with your voltage SS r v e Never clean with scouring powders or abrasives N ll e Keep the product away from direct sunlight e A power outlet is required to operate the undersink water chiller e Place the undersink water chiller away from any possible water leaks from filtration systems or dishwashers 2 INSTALLATION AND OPERATING INSTRUCTIONS Typical Installation Diagram A Mains Water Connection B Filtration System C Undersink Water Chiller D
8. crobiologically unsafe or of unknown quality without adequate disinfection before or after the system The warranty does not cover damage to the product caused by accident fire or floods To enable us to register your warranty and provide service should a problem occur we recommend you fill out the section below and return it to us immediately with copy of proof of purchase INSTALLATION AND OPERATING INSTRUCTIONS 9 AQUAPORT water for life CUSTOMER HOTLINE 1300 764 325 Aquaport Corporation Pty Ltd PO Box 81 Findon SA 5023 Australia Telephone 08 8354 0711 Facsimile 08 8354 0722 Email aquaport aquaport com au Web www aquaport com au
9. e Avoid installing unit in a dusty environment If this cannot be avoided you must ensure that the fan for the condenser remains clean and clear from dust If air flow is restricted the temperature of the unit will increase and automatically shut off D Tubing Installation The Undersink Water Chiller has been s lied with quick and eas 3 4 BE a y Correct Cut kK White Collet 19mm to install quick connections Do Not Remove LIKES j l t 1 4 3 4 To install tubing push tubing into connections and give a slight i gt Ee Incorrect Cut H pull to ensure tubing is secure Note Check the end of the tubing to make sure there are no cuts nicks flat spots or sharp edges If any of these are present cut the end with scissors or utility knife 1 Measure 3 4 19 05mm from the end of the tubing provided Lan Push and mark with a pencil Fig 1 3 Pull Tubing 2 Push the 1 4 tubing firmly into each fitting as per step 5 on page 4 until the pencil mark is pushed next to the collet or until tubing is fully seated Fig 1 If tubing is removed re cut the end measure mark and re insert Note To remove tubing push collet against the face of fitting and remove the hose with collet still held against fitting face Fig 2 Tubing must be fully inserted seated to avoid leaks Repeat for all other connections 3 Pull slightly on tubing to ensure tube is secure
10. must not be obstructed at any time air flow is required for unit to operate effectively To protect against fire electric shock and personal injury do not immerse cord plugs or appliance in water or other liquid Close supervision is necessary when any appliance is used by or near children Unplug from outlet when not in use and before cleaning Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been damaged in any manner Return appliance to the nearest authorized service facility for examination repair or adjustment The use of accessory attachments not recommended by the appliance manufacturer may result in fire electric shock or personal injury e Do not use outdoors e Do not let cord hang over edge of table or counter or touch hot surfaces e Do not place on or near a hot gas or electric burner or in a heated oven e Do not use appliance for other than intended use e This appliance should always be used in conjunction with a safety switch e Place unit in a flat well ventilated location at least 100mm from wall or other Appliances e Ensure unit is properly grounded e A power outlet is required to operate the undersink water chiller For best performance do not place the unit near an oven heater direct sunlight or other heat source INSTALLATION AND OPERATING INSTRUCTIONS 1 AQUWIAPORT SPECIAL PRODUCT INSTRUCTIONS INSTALLATION INSTRUCTIONS

Untitled

Contents

Download Pdf Manuals

Related Search

Related Contents