User Manual - Heatpressuk
Contents
1. Oftulti mug press User Manual 3 Fig 6 OK button press to select from timer to tem perature press to start counter press to stop Thank you for purchasing the DG5 Multi mug press you are now able to produce high volume mugs in a fraction of the Fig 7 EKON time with the consistency needed Fig5 pyetegee Kye Operating the Digital Control Step 1 Fig 4 ilgtelget h gt Connect all elements that will be used be fore switching ON Always have 1 element plugged into the Master socket fig3 Turn power ON fig 7 The temp led will display press to increase temperature to 185c Fig 3 MWe palette lt a press OK the Time Led will display press to increase time to 60 sec can be increased if needed Press OK OK 0 will appear This means that the elements are now in rest and the control panel has been programmed ready for step 2 Note you will have to repeat this action every time you turn the press on by fig7 Pressing Mugs sequence Step 2 Load Mugs into the Mug presses Always Load Unload the Master Mug Press last and press OK The elements will now heat up to the temperature that you have selected alarm will sound press OK and the countdown will begin when countdown is finished alarm will sound then Press OK for O Rest mode no alarm Reload now Reload We recommend you set your If you are doing continuous mug pressing more that 1 load system up in the same way as T2. hen do the following Always make sure that you have the next load prepared for pressing as rhythm is very important Unload and reload the same press immedi ately with a prepared mug Do this with all mug presses as quick as you can Re peat Step 2 If you do only 1 press then unload the mugs Make sure that you always unload the MAIN Press last Switch OFF the control panel Finish above for easy loading and reloading Adjusting mug press size Remove 8 screws from mug press housing 4 screws either side and remove element install new element in reverse of removal of old The mug press can be adjusted to suite smaller or larger mugs loosen or tighten to nut below to increases or decrease size Remove screws Rotate to adjust The DG5 is most effective when the sequence is followed above This will not only ensure uniform finishing on the mugs in all the presses but will also give your elements a long life Fail ure to follow these steps can result in uneven heating of elements causing the elements to become out of sink with each other and can lead to terminal damage to the elements If at any point you failed to follow the procedure switch OFF the control panel and wait until all the elements have cooled down to room temperature Normally 1 hour with no mugs in the presses To cancel all settings Switch power Off and ON Fig 7
Download Pdf Manuals
Related Search