USER`S MANUAL
Contents
1. hat you previously determined in step 3 Gently slide the pitarm slightly up and down the region where the pad arm is to sit Continue this until all air pockets are released between the two parts Note If you do not remove the air between the frame and the Pitarm the parts will not adhere properly and may be prone to falling off Too much bond can increase this problem 6 HARDENING and right arms are evenly balanced After several hours the bond will harden and the parts will be affixed This time can be affected by humidity and temperature Before the parts are firmly attached to each other make sure that the left and right pad arms are evenly balanced on the frame Rotate the pad arms ADJUST Once the pad arms are sufficiently affixed to the frames you may rotate the pad arms in and out to accommodate the finer adjustments necessary for a proper fit to customer s face Please be sure to do final fitting only after the bond has had enough time to dry and harden completely KANN JSon Ray C ORPORATION TOMTOM BLDG 5F 1 16 7 KITAHORIE NISHIKU OSAKA 550 0014 JAPAN TEL 81 6 6533 2300 FAX 81 6 6533 2305 E mail noriko sun rayosa co jp2. p o 5 amp Itarm X This product is designed for acetate frames only USER S MANUAL This manual uses the click in type of nose pads Pi 001 for installation QFECT FIT WITH Ase N NOSE p 45 RO Ads Using the special cutters cut the plastic nose pad off the frame Be careful not to damage or scratch the frame during this process Be careful not toscratchhere _ Ln Using an acetate file file any burrs or protrusions that may remain on the cut surface after step 1 Be careful not to file too vigorously as the shape of the frame may be changed or difficult to remove scratches may be produced To prevent scratches on the frame it may be advisable to tape the surrounding areas Buff smooth if necessary ee amp BOND Special Acetate Bond at Clean the frames of any dust or debris Determine the appropriate location for the Pitarm base to be attached to the frame Once you have determined this location apply the special acetate bond to both sides of the frame Be careful not to add too much bond Apply lightly to Ponai in ng surface Apply the special acetate specific bond to the bonding surface of the Pitarm Wait 1 2 minutes This will make the bond extra sticky and very strong Hold Pitarm by metal portion 5 ATTACH Lightly slide Pitarm on frame Holding the pad arm by the metal portion align the pad arm and lightly stick the bonding surface to the location on the frame t
Download Pdf Manuals
Related Search