Getting the best from your urn • Important safeguards
Contents
1. the cord to hang over the edge of the work surface to touch wet or hot surfaces or become twisted The urn should not be lifted whilst connected to the mains The urn should not be carried whilst it contains water Maintenance other than cleaning should be performed by the manufacturer while this product is within guarantee contact our service help line or otherwise by a qualified service engineer This appliance is not suitable for installations in an area where a water jet could be used This appliance is not to be intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance This appliance must not be cleaned by a water jet This appliance is only to be installed in locations where its use and maintenance is restricted to trained personnel For correct operation this appliance should be operated in an ambient temperature between 22 28 C Installation Preparation e Remove any plastic film from the urn and wipe over all surfaces with a damp cloth e Check that the voltage shown on the rating plate is suitable for your supply e Before general use it is recommended that the urn is used on the maximum setting twice disca2. water If this happens allow the urn to cool down then press the reset button situated under the base If this happens allow the urn to cool drain the water then press the reset button situated on the base In order to ensure correct operation of this cut out it is essential to keep the heating element free from scale Failure to do this will result in the cut out operating before the water has boiled Cleaning WARNING Disconnect from the mains supply before cleaning and allow the urn to cool IMPORTANT Do not immerse the urn in water or any other liquids and take care to keep water away from the mains lead and connections IMPORTANT Do not use any abrasive cleaning fluids or materials e Wash out the urn Use clean water and a soft cloth e Brush any scale or sediment from the element e Rinse thoroughly and buff with a dry cloth 5 e Do not clean with a water jet Descaling In hard water areas scale will form on the element and walls This will adversely affect the operation of the urn if allowed to accumulate Descaling can be simply achieved by using a proprietary descaler Choose one recommended for stainless steel kettles It is important to follow the instructions given on the descaling solution carton Scale build up can also cause the tap to drip even when in its closed position If this should occur disconnect from the mains supply empty the urn allow it to cool and unscrew the top of the tap from the body of the ta
3. 480 300 390 390 335 430 440 Weight in Kg 3 0 empty 4 0 empty 4 4 empty Power rating 3kW 240V 3kW 240V 3kW 240V Customer helpline For spares and after sales service please contact Burco on T 0844 815 3737 F 0844 248 4123 E info gdha com Glen Dimplex Professional Appliances A Division of Glen Dimplex Home Appliances Stoney Lane Prescot Merseyside L35 2XW WWW burco co uk amp GLEN DIMPLEX PROFESSIONAL APPLIANCES
4. User Instruction Manual BURGO Electric Catering Urns Please read and keep these instructions This covers the 10L 20L amp 30L Burco electric catering urns C10STHF C20STHF C30STHF 444448528 444448529 444448530 Getting the best from your urn Remove any plastic film from the urn before use Any water in the urn is due to testing and is normal The urn must be used on a flat level surface Boil and discard the water twice before general use Important safeguards To avoid being scalded when the urn is operating or has just been switched off keep hands away from any steam from the lid Be particularly careful not to touch hot surfaces when opening the lid or filling Do not use the appliance if it has malfunctioned or has been damaged in any way Do not dismantle any part of the urn Responsibility cannot be accepted if this instruction is ignored Do not place the urn on or near hot surfaces Do not use accessories or attachments which are not recommended or sold by Burco Appliances as they can cause hazards This appliance must only be used for heating water Always switch off and disconnect the urn from the mains supply when not in use or when cleaning To prevent any risk of electrocution do not immerse the urn in water or any other liquid when cleaning and do not allow any water or liquid to come into contact with any of the electrical connections or controls Do not allow
5. one of the following positions Approx temp Knob setting 37 C 99 F 1 55 C 131 F 2 68 C 155 F 3 82 C 180 F 4 Up to 100 C 212 F 5 6 If it is necessary to keep the water at an exact temperature use a thermometer to check this Stir the water before taking the temperature and when the desired temperature has been reached turn the control knob slowly to the left until a click from the thermostat is heard The thermostat will cycle on and off to maintain the temperature Serving e The safety tap is locked or unlocked by twisting it so that the closed or opened padlock symbol is lined up with the white dot on the tap body e There are two open positions one self holding so that the tap remains open and the other self closing so that the tap closes as soon as the lever is released To change the tap position turn the tap lever through 180 e Open the tap by depressing the tap lever into the horizontal position e Close the tap by returning the lever to a vertical position After use e Switch off to 0 and disconnect from the mains supply e Water may be left in the urn when it is not in use for short periods but to maintain a supply of fresh water it should be emptied periodically and cleaned out e WARNING Only move when disconnected and empty Protective cut out The heating element is fitted with a thermal cut out which protects the urn from damage if it is allowed to boil dry or is switched on without
6. p Wipe scrape and break the scale away from the rubber flexible seal and also from the sealing surface inside the plastic body of the tap IMPORTANT Failure to de scale will invalidate your guarantee Guarantee This appliance is guaranteed against defective materials or faulty workmanship For length of guarantee please contact your supplier This guarantee is given subject to the urn being used in accordance with the instructions on the supply voltage marked on it and to the usual fair wear and tear conditions The guarantee does not cover consequential damage arising out of any failure acceptable under guarantee nor does it cover damage resulting from misuse accident or unauthorised alterations to the urn In any communication with the supplier or manufacturer it is essential to quote the catalogue number marked on the urn Proof of purchase will be required In any communication with the service department it is essential to quote the model and serial number marked on the rating label This guarantee in no way diminishes the buyer s statutory rights Burco products are intended for commercial use as detailed in these instructions Burco has a policy of continuous improvement in product quality and design The Company therefore reserves the right to change the specification of its models at any time Model C10STHF C20STHF C30STHF SKU Number 444448528 444448529 444448530 Dimensions in mm 380 380
7. rding the water each time Fitting a plug The mains lead of this urn will already be fitted with a BS1363 13A plug In the event of replacing a fuse a 13 amp fuse approved by ASTA or BSI must be used If the plug is not suitable for your socket then the plug must be cut off and disposed of safely An appropriate plug should be fitted as follows IMPORTANT The wires in the mains lead are coloured in accordance with the following code Green and Yellow Earth Blue Neutral Brown Live The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or the earth symbol 4 or coloured green or green and yellow The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black or blue The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red or brown Make sure that the connections are tight and that there are no loose strands of wire and no insulation trapped under the terminals Tighten the clamp in the plug making sure that it grips the outer covering of the cord In a 13A BS 1363 fused plug fit a 13A fuse Tighten the plug cover securely If you are in any doubt consult a qualified electrician IMPORTANT If the supply cord is damaged it must be replaced by the manufacturer service agent or similar qualified person in order to avoid a hazard The suppl
8. y cord may become warm when the appliance is in use WARNING This appliance must be earthed Location e More than 100mm from any combustible surface e Ona flat level surface e This appliance is for indoor use only Using IMPORTANT Always put water in the urn before switching on Lift the lid and fill the urn with the desired amount of water e Do not fill above the MAX capacity mark WARNING If the urn is over filled there is a risk that hot or boiling water may be ejected e Under filling will cause the boil dry cut out to operate and may shorten the life of the element e The urn is not suitable for boiling liquids other than water or for boiling water containing small solid particles e If the water is being boiled for tea making it is best to make the tea in another container However if it is necessary to make the tea in the urn it should be suspended dear of the urn bottom and heating elements in a muslin bag e fitis intended to boil large items such as puddings or hams in the urn they should be suspended clear of the urn bottom and heating element Thermostat control e The green light will glow to show power is connected to the urn e Turn the control knob to 6 e When the water reaches temperature turn the control knob to approximately setting 5 to keep it simmering An exact setting will be found by experience e To maintain the water at any other temperature set the control knob to approximately
Download Pdf Manuals
Related Search