Home
        The all-in-one field sync tester
         Contents
1.                                                                                              ep yg M erue  FDD LTE   3G  PRC  The  a  e e 9 6e e  o          e    1 Seay PMP ES  gt   e     EPC RNC eme X or Ethernet    es ES  k 1 Core    e  e    o     J                                                                                                                                               IP MPLS  or Ethernet  Backhaul    jentine         IP MPLS  or Ethernet    Backhaul        Macro eNodeB          a  1    Small Cells                    PTP Slave    PTP  SyncE    E1 T1 10 MHz  1pps    eranl    vee0e 0 0e 0   006006000000009009    GPS         Validate 1 5us phase accuracy    requirement for LTE A          Macro Cell    Small Cells  e _      Slave e    PTP   E1 T1 10 MHz     NTP  lt  1pps  s SyncE i  GPS      Check whether  PTP NTP delivers    Sync within specs    Clock Module Specifications    Predefined Signal Clock Types   1pps  PTP slave recovered clock      8 kHz  frame clock      64 kHz  64 kbit s  EO   DSO   1 544 MHz 1 544 Mbit s  T1 DS1 clock data   2 048 MHz 2 048 Mbit s  E1 clock data   5 MHz 10 MHz  Freq  reference   25 MHz 125 MHz 156 25 MHz  SyncE clock rate   34 Mbit s  E3   45 Mbits s  DS3      155 52 MHz 155 Mbit s  STM 1 STS 3 clock data     User defined Clock Types User defined signal types from 0 5 Hz to 200 MHz in 1 Hz steps  Note   symmetrical  unipolar clock signals     Measurement Ports Number of Ports  2 per module  Connector  BNC  Impedance  75 ohm  
2.   4 Cal  Ref  Freq  Uncertainty    GPS disciplining    Built in GPS Module 12 channels  TRAIM GPS receiver  high sensitivity   Time Accuracy to UTC   25 ns at 10 after 24 hours lock   Frequency Accuracy 2x107  averaged over 24 hours   GPS Disciplining Modes Always disciplining  always in holdover  disciplining only between measurements    External References    Frequency Reference Input  std  Input Frequency  10 MHz  5 MHz or 1 MHz  Voltage Range  0 1 Vrms to 5 Vrms  Impedance  approx  50 ohm    External 1pps Timing Input Voltage Range  OV to 0 8V  Low   2V to 3 3V  High  into 50 ohm  Required Accuracy    100 ns to UTC    GPS Timing Reference Antenna Input  N type connector  DC feed  45V on center pin to active GPS antenna    Output References    Reference Frequency Output Ref  Frequency  10 MHz sine wave  Output Levels  1Vrms in 50 ohm  Impedance  approx  50 ohm    1PPS Output Source  Internal Rubidium oscillator  Output Logic Levels  TTL levels in 50 ohm    E1 T1 Output Module Connector  Clock  BNC  Data  Isolated BNC  Frequency  2 048 1 544 MHz  Output Level  Acc  to G703 10    1 2 V  10  in 75 ohm    Interfaces   USB Device Port Connector  Std USB type B  USB Version  2 0   USB Host Port Connector  Std USB type A    Max Supply Current  400 mA  USB Version  2 0    Ethernet Communication Port  RJ45  10 100 Base T  Protocol  DHCP  HTTP  FTP  VNC    Remote Operation Remote operation via VNC  open browser and enter IP address     Event Log  On screen log of measurement start s
3.  and        4x ToD display measurements analysis        Measure Time of Day  ToD   Phase  and Frequency    Calnex Solutions is a global leader in Test and Measurement solutions  for next generation telecom networks  Our products help to prove new  technologies for Mobile Backhaul and Carrier Ethernet networks     For more information on the Calnex product family  and to take WWW calnexsol com  advantage of Calnex   s extensive experience in Packet Sync and OAM  testing technologies  contact Calnex Solutions today     tel   44  0  1506 671 416 2    email  info calnexsol com  Calnex       Calnex Solutions Ltd  2013  Insight and Innovation    
4. Insight and Innovation    The all in one field sync tester       Lab quality performance in an  easy to use  portable package    Just two steps to run the test   1  Run Signal Check to auto discover signals  2  Start all measurements at the same time    No need to carry a truck  load of equipment   it s  now all in one            Small enough to  take on flights as  hand luggage    Remote operation  and monitoring from  NOC Office    Big touchscreen  and user friendly  interface       Train Rb in the  lab then switch  off  drive to the  test site and  start testing    Pass Fail ITU T  and Vendor limits  for easy analysis    Capture and Replay   send  measurement files back to  Vendor Labs to fix issues    Detailed measurement  report in pdf format    Applications                                                                                                                                            TDM  VN    STM 1  STM 1  E    SONET SDH Sa  WDM OTN oS  STM 1  E Up to 6  Le    measurements  Jj at the same time    100 al  l  bservation Window  s   Show Li abels    0 01 0 1 1 10  Obs al  opopo    Resolution    LTE A   TDD LTE    PRTC     gt  i  wu Py    x           IP MPLS  z   wu PS   or Ethernet  Core       T BC    T BC    e   e  e EPC  o   e       e e     9  Copo    lt     x             RR pull       SERE iil ij  mM    ia 4 al                                                                                                                                                      
5. VSWR   2 1 or 1M ohm  Voltage Range   5 00 V  Sensitivity  60 mVpp  Signal Type  Symmetrical pulse  Clock signal   Unsymmetrical repetitive pulse  Clock signal    HDB3 coded data  Data signal   AMI B8ZS  B3ZS  Data signal     Test Modes Masks can be applied for TIE  MTIE and TDEV graphs    MTIE and TDEV Masks  1pps  Time Error limit  e g    1 5 us   PRC SSU SEC  Masks for G811 G812 G813 clocks  ETSI 300 462 3   Networks  According to G 823 6 824 6 8261 6G 8261 1  SyncE  According to G 8261  G8262  ANSI standard  DS1 and OC N masks  User defined  Defined by the user    Graph Display Display Modes  TIE  MTIE  TDEV  ADEV  FDEV  RTIE  MRTIE  Update Rate  approx  once second  Number of Graphs  Up to 6 graphs of the same type can be over laid on screen  Color coded   Masks on Screen  Up to 6 MTIE  MRTIE and TDEV masks according to selected test mode  Pass Fail result  available for each mask       Ethernet Module Specifications    Synchronous Ethernet    SyncE clock measurement    Conformance to G 8261 and G 8262 masks  MTIE TDEV      Additional metrics display  FDEV  ADEV  MRTIE    Extract and display ESMC message  SSM      Generate and change ESMC    IEEE1588v2 PTP    Forward  Sync  PDV  Reverse  DelReq  PDV and Network Delay     Raw PDV  vs time and distribution graphs   a Selected Packet PDV  vs time and distribution graphs       luster band packet selection     Pseudo Slave or Monitor Mode     Layer 3  IPv4 UDP  Multicast Unicast    5nsresolution timestamp  better than 1 ns ac
6. curacy    Captured PDVs can be replayed on Calnex Paragon X for troubleshooting    NTP    Forward  Server  PDV in Monitor mode     Raw PDV  vs time and distribution graphs      5ns resolution timestamp  better than 1 ns accuracy     Captured PDVs can be replayed on Calnex Paragon X for troubleshooting    Measurement Ports Number of Ports  1 per module  Connector  RJ45 for 10 100 1000 bT  SFP  SFPs not supplied  100M 1GbE       Platform Specifications    Reference Clock Built in Rubidium reference or external reference input 1 5 or 10 MHz   Resolution 200 ps rms   Sample Rate Up to 100 Sa s depending on number of parallel measurements   Internal Data Storage Up to 5M TIE values   External Data Storage On USB memory stick   Start Stop Via START STOP key   Signal Check Parameters Signal type  Clock  Data or Unknown   Frequency  for clock signals   Pulse width  for data signals      Voltage peak peak  min  120 mVp p   Display Color TFT  8 4   800x600 pixels  resistive touchscreen    Specification is subject to change without notice     Platform Specifications  continued     Internal Time Base Stability  holdover     Stability Versus Temperature  20   to 26  C  lt 1x10    typ    07 to 50  C  lt 1x10     Ageing Rate  24h    5x10 per month  Warm up Stability  12 min to  lt 1x10      Calibration Principle  Closed Case Calibration with automatic adjustment of the Rubidium timebase   using Cs based  or GPS controlled Rb based  or built in GPS reference    Calibration Uncertainty   2x10
7. net module  PTP NTP SyncE   Includes SyncE ESMC testing 100M and 1GbE  up to 3 per unit      Option 620  IEEE1588v2 and NTP PDV measurement software  one license per main unit       Option 630  Internal battery backup for Rubidium     Optional Accessories        Option 802  One year warranty extension      Option 803  Two years warranty extension      Option 75  120 ohms balanced RJ45 to 75 ohms unbalanced BNC impedance converter  balun      Related Products      66666Sos P        du       um AA g 8  E MN M M MM     Calnex Paragon X    Calnex Paragon t    Calnex Paragon m      All Capture and Measure features  of Paragon X     amp  1588v2 and NIP PDV and  Standards and Vendor Metrics   Pass Fail evaluation       Speed up test time and reduce  test complexity with multi clock  Measurements    e Test 1588v2 PTP  SyncE  NTP  CES  and OAM up to 10G    a Stress test equipment with real   network profiles from field tests  to debug network issues        Measure multiple outputs from  a chain of Boundary Clocks  BCs     and Slave Clocks a Sync E Wander measurement to      Prove 1588v2  PTP   Sync E  CES  ITU T limits    Pseudowire  NTP  etc  implemen   tations to ITU T G 8261 etc         4 x Frequency  SyncE E1   1T1 2 048M 10M Wander       Clock measurements     1pps  ToD   measurements    E1 T1  including MTIE TDEV to    m Test 1588v2 Ordinary Clocks  ITU T limits    Boundary Clocks and Transparent  Clocks        4x Phase  1pps accuracy     measurements a Thru mode Network capture
8. top  duration  alarms  loss of data  loss of communication  link  etc  Log can be saved as text file    Report Generation  Printable  custom designed measurement report in pdf format   Security  Password secured access to STA 61    Environmental Data    Temperature Operating  0  C to 40  C   30 C when charging Rb backup battery   Safety EN 61010 1  2011  CAT II  Pollution degree 2  Measuring category I  CSA C22 2 No 61010 1 04  UL 6010 1 2004  EMC EN61326  1997    A1  1998   CE  Power Supply Line Voltage  100 to 240 Vrms  10   47 Hz to 63 Hz    60 W  Optional Battery Backup 5 hours autonomy for rubidium only  to maintain internal timebase accuracy during transport    Mechanical Data    The chassis is suitable for field use  and can be operated on a bench  lying down  or on a floor  standing up    The cabinet is shock resistant using bumpers    Dimensions  w x h x d  320 x 388 x 126 mm  12 6  x 15 3  x 5    Weight Net   6 kg  13 Ib   Shipping   7 kg  15 Ib   with transport case   9kg  20 Ib     Specification is subject to change without notice     Ordering Information  Calnex Sentinel Sync Analyzer with built in GPS receiver  Needs one or more input modules  Option 610  Option 611      Included with shipment  User manual on CD  line power cord  GPS antenna  antenna cable  20m   hard transport case   calibration certificate  1 year warranty and support     Built in Options     Option 610  Clock module 1PPS E1 T1  any clock up to 200 MHz  up to 3 per unit     m Option 611  Ether
    
Download Pdf Manuals
 
 
    
Related Search
    
Related Contents
学校用備品購入仕様書  Projet Socket Calculatrice - Ingénierie des Réseaux - std-svn-uppa  Operating Instructions/Bedienungsanleitung/ Mode d'emploi  Clair-TD1866 Manual  Turbosound TCS COMPACT SERIES Portable Speaker User Manual  OM, Automower, 305, 308, 2015-01  MANUAL DE INSTRUÇÕES  TA-Nr. 011251 02/06 Änd.  User Manual - TAF MiFID v1.2 Interface via www.bourse.lu - e  arva Evo3 1213モデルの取扱説明書 (日本語 2MB)PDFファイル    Copyright © All rights reserved. 
   Failed to retrieve file