DC-S2 User Manual
Contents
1. procedure below to change the batteries 1 Open the Door contact cover Remove the old batteries Press the learn button several times to fully discharge Insert the new batteries observing correct polarity ot NN Replace the cover Specification Environmental Condition 10 C to 40 C relative humidity 85 non condensing Radio 433 MHz FCC Statement This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 This device must accept any interference received including interference that may cause undesired operation FCC Caution To assure continued compliance any changes or modifications not expressly approved by the party responsible for compliance may void the user s authority to operate this equipment Example use only shielded interface cables when connecting to computer or peripheral devices FE CE QE G BLAUPUNKT2. Wireless Door Contact DC S2 3 7 i 1 5 U 5 E 4 O eS 6 Parts Description 1 The Door Contact should be mounted on the door window frame while the magnet should be mounted on the 1 LED indicator Inside door window as shown in the picture below The Door Contact has Rib Mark on one side to mark the position of the internal 2 Learn Test Button magnetic switch The Rib Mark must be aligned with the Press the button to transmit a learn test code and enter Test magnet when mounted the gap between the Door Contact and mode for 3 minutes The LED will light up whenever Door Contact the magnet should be no more than 15 mm is triggered under Test mode 2 Drill holes into the wall using the knockouts as template then R fix the Door Contact base onto the wall with the screws and 3 Supervision Enable Disable Jumper Switch plugs provided Alternatively you can also use the double side JP2 adhesive tape provided to glue the Door Contact on the frame 4 Battery Comparment 3 Replace the Door Contact cover onto the base 5 Tamper Switch The Tamper switch protects the Door Contact from unauthorized removal from mounted surface Door 6 Battery Insulator Window 7 Knockouts 8 Rib Mark 9 Magnet Package Content 1 x Door Contact 4 x wall plugs and screws 2 x adhesive pads 2 x 1 5V AAA alkaline batteries pre installed Supervision Enable Disable Jumper Switch JP2 When mounting the Do
3. or Contact please take note of the 7 Jumper On il Jumper Off following points a The jumper link is inserted if the jumper link is removed ia ha connecting the two pins or parked on one pin Mount as high as possible Do not aim a PIR sensor at this window If enabled the PIR sensor will transmit supervision signal to Control Panel periodically for the sensor to monitor PIR sensor condition O j Jumper set to ON supervision function is Disabled Default peration Do not mount on metallic surface Jumper set to OFF supervision function is Enabled Test Mode Learning Press the Test Button to enter Test mode for 3 minutes Under Test mode the LED indicator will light up every time the Door Contact is triggered Put the Control Panel into learning mode then press the learn button to transmit learn code Please refer to Control Panel manual to complete learn in process and device mounting LED Indicator of Installation On 2 seconds When Tamper Switch is triggered Movement detection under low battery The Door Contact has 2 knockouts on the inside of the back tamper triggered or Test mode cover where plastic is thinner for wall mounting FE CE Q HS BLAUPUNKT Battery The Door Contact uses 2 x 1 5V AAA alkaline batteries as its power source It also features low battery detection function to notify the Control Panel when battery voltage is low When the Door Contact is on low battery follow the
Download Pdf Manuals
Related Search