WCH-250X Operation Manual V1
Contents
1. SETUP key Signal In Out socket a DC 5V In Z E LCM screen LCD screen Power Switch 1 WCH 250X Wireless Camera Hunter Operation Manual Yull Mi A8 wH TY eo Law Enforcement Products Manufacturer LawMate V1 0 Mi Installing the battery Remove battery cover on back of the unit Slide the supplied battery at about 15 degree angle to the battery compartment Please be aware of direction Connect the supplied power adaptor to an AC wall outlet and attached the other end of the cord to the DC 5V In socket EPower indication When charging the battery a red color LED light will illuminate Once the battery is fully charged the LED light will turn off The charging time is approximately 3 4 hours depending on the battery remaining power Please charge the battery for 8 hours on the first time use Antenna connector Plug antenna 1 to port 1 and antenna 2 to port 2 You can find the indication printed on the antennas as well as on the ports Turn the antenna s base clockwise until it locks S into place 2 EPower switch The power switch is on the side of the device When the unit is turned on it starts scanning the signal automatically Make sure the antenna is screwed tightly to its allocated position to avoid poor reception E Frequency scanning Whenever a wireless A V signal is detected the image will be displayed on2. LCM Operation Interface H Enter setting Slide the POWER key on side of the unit to turn on the device press and hold the SETUP key for 3 seconds then release it The icon will be blinking on the LCM the smaller screen scroll the SETUP key upward or downward to change setting E Change setting Press the SETUP key once to confirm change and to move on next setting H Exit setting Press and hold the SETUP key again for 3 seconds The device will return to scanning mode Receiver Sensitivity Scanning Signal Dwell Mode Time Audio amp Vibration Alert Setting W Mi Yal ji Yul Ol Moes wH TY M30 8 wH TY M30 8 YullUH TY il M ll Til 4 Yul M30 8 YuwlWJH TY M30 2 WH eT Ea Ea UH Ultra High Alert on Vibrate Off 75dBm woo e T M30 8 mH TY ELL H High 60dBm M30 2 wH BI q 3 Wis al MEX 8 YilH TY moes mH TIY EXT AV input mode 8 seconds i m M30 8 mH 4 IY SS 30 Sec interval mode 4 seconds ll YW T Yul 4 mos wH 4 TY MEROE an ey SS 60 sec interval mode 2 seconds MH Medium High Yih m 50dBm Moms WH TY Y l y TM M30 s YulM TY SS Standard scanning mode M Medium 40dBm Alert Off Vibrate On Yi T M30 8 YulML ry ELL ML Medium Low 30 dBm Yul og 1 meoo Ms Yl TY mm L Low 20dBm Names and Parts 2 4 amp 5 8GHz ant mount 1 2GHz ant mount
3. the screen and stays for few seconds The length of time depends on your setting You have the option to lock the channel by scroll upward or downward the SETUP key on side of the device to lock the channel or else it will pass on and continue scanning E Manual scanning Scroll upward or downward the SETUP key to scan manually Low battery alert When the battery gets low the battery icon will blink Charge your battery immediately E External video input To connect external video to the device change the setting to EX mode Make sure the connector is plugged properly to the Signal In Out socket on side of the device otherwise it will result non signal input 2
Download Pdf Manuals
Related Search