User Manual
Contents
1. press the Play Button and your disc will commence playing from the selected track You may select a track when Pause is engaged In this case the disc will revert to Pause after the procedure is complete and you will have to press Play Button to continue playing the disc REMOTE CONTROL Your CD player is supplied with a Remote Handset The Remote Control Handset is powered by two 1 5V AAA batteries When inserting the batteries observe the correct polarity TROUBLESHOOTING If you suspect yourCD 22 CD Player is not operating properly first check all the connections carefully Pay particular attention to input and output connections Phono plugs should be fully inserted a frequent cause of problems is that Phono plug surrounds do not make proper contact Below are some commonly encountered problems with suggestions for possible cure The list is not exhaustive If you have any unresolved problems please consult your appointed LITE dealer or distributor SYMPTOM LIKELY CAUSE SUGGESTED REMEDY SYMPTOM LIKELY CAUSE SUGGESTED REMEDY Disc inserts display does Disc inserted upside down Re insert disc label side up not show the number of Disc is dirty or scratched Clean disc discard scratched disc tracks and playing time Condensation on the laser lens Let CD player warm up and dry out lens Dirt on the laser lens Refer to appointed dealer or service centre DO NOT use CD lens cleaners Skipping amp mistracking Exce2. LITE CD 22 CD PLAYER USER MANUAL LASER SAFETY CAUTION INVISIBLE LASER RADIATION WHEN POWER IS ON AVOID EXPOSURE TO BEAM Laser Diode Properties Materials Ga Al As Wavelength 755 815 nm 25 C Laser Output Continuous Wave max 0 7mW INTRODUCTION Congratulations on your purchase of the LITE CD 22 CD Player This CD Player is designed and manufactured to the highest specification and rigorously tested to offer you many years of trouble free pleasure Your CD 22 CD Player is at the heart of your hi fi system Its correct installation set up and operation will have a profound influence on the sonic performance of the entire hi fi installation Please read the contents of this manual thoroughly It will help you to understand your hi fi equipment better and enhance your listening pleasure UNPACKING Included in the packing of your CD 22 CD Player you will find e One LITE CD 22 CD player e One CD clamp e One mains lead fitted with the correct mains power plug for your country e One remote control handset e One user manual and warranty card After removing these items please retain all packing materials Correct packing is necessary for transportation of your CD22 CD Player MAINTENANCE After disconnecting the amplifier from the mains supply the cabinet and front panel may be cleaned with a lightly dampened soft cloth or chamois leather Avoid using abrasives or solvents CAUTIONS Your CD 22 CD Player i
3. aded your CD 22 CD Player will briefly spin the disc while it studies the data encoded on it in few seconds The disc will then stop and the display will indicate the number of tracks on the disc and the total play time To commence playing a disc press Play Button 2 once The disc will play from the beginning Press the Pause button 3 to pause the disc whilst it is playing Pressing the Play Button 2 again will resume playback from the point at which Pause mode was entered In Pause mode the disc continues spinning and the laser will still be operational but locked Please keep the CD player in Pause mode no longer than strictly necessary Warped discs should never be played If a disc is not inserted or if the disc is damaged or inserted upside down the CD player will remain inoperative Display will indicate no disc SELECTING A TRACK Press the Track Forward Button 5 to go to the next track on the disc Pressing the Track Back Button 4 will take you to the previous track When the disc is playing press the Track Back Button once to take you to the beginning of the current track and a second time to take you to the start of the previous track In Play mode press the Track Forward Button 5 to take you forward to the start of the next track Once the procedure is complete the disc will commence playing from the selected track When a disc is first loaded you can use these buttons to select your desired track Having done so
4. ith the product specification LITE reserves the right to make a charge for examination and return carriage Unauthorized servicing will void this guarantee SPECIFICATIONS Operating System CD digital audio system CD CD R Frequency Response 20Hz 20kHz 0 2dB Harmonic Distortion lt 0 001 0dB 1kHz Typically 0 0005 lt 0 006 30dB 1kHz lt 0 01 0dB 20kHz Intermodulation Distortion lt 0 001 OdB Typically 0 0005 S N Ratio IHF A Wtd 105 dB Wow amp Flutter Quartz precision Channel Separation gt 100 dB 1kHz gt 80 dB O 20kHz Output Voltage 2 0Vrms Digital Outputs 75 Ohm Coaxial RCA 110 Ohm Balanced AES EBU XLR Optical Toslink D A Conversion AD1853 Advance Segment Balanced Stereo DAC Resolution Sampling 24 bits 192 kHz Oscillation 3ra Overtone Oscillation Crystal Super precision custom made Jitter lt 150 psec Idle Pattern lt 115 dB Stop band Rejection lt 78 dB Power Supply x2 high performance low noise R core transformers Power Source 100V 120V 50Hz 60Hz 220V 240V 50Hz 60Hz Power Consumption lt 15W Dimension 432 x 330 x 70 W x D x H mm 432 x 330 x 80 including feet Weight 9Kg NOTES Purchase Date Year Month Day LITE Retailer Nad sardiine talv ira Location asesi narendani eek
5. s set to operate from a fixed supply voltage which is marked on a label next to the mains input plug Before connecting the mains lead please check that your mains supply corresponds to this label as below 230V Products eee eee eeeeeeeees Voltage Range 220V 240V T15V ProdUCts ci a ico banca he Voltage Range 100V 120V The mains lead supplied with this product has an IEC mains socket which plugs into the IEC connector on the unit s rear panel The other end is normally attached to the appropriate mains plug for your country Please observe correct mains polarity at all times The CD Player mains fuses are located on the rear panel next to the IEC mains connector These must only be replaced by the fuse type and rating as described on the fuse rating label on the rear panel of the unit If the equipment is likely to be unused for some time unplug it from the mains supply GENERAL CAUTIONS FCC WARNING This equipment may generate or use Radio Frequency energy The user may lose the right to operate this equipment if unauthorized modifications are made INTERFERENCE Properly installed this unit should not cause harmful interference to radio communications There is however no guarantee that such interference will not occur in a specific installation If interference arises which you can determine by switching the unit off and on you could try to remedy this problem by the following e Re orient or re loca
6. ssive vibration Ensure player is stable and vibration free Disc is dirty or scratched Clean disc discard scratched disc Excessive hum Connection loose cable faulty Re connect plugs change interconnect One channel inoperative Interconnect or amplifier faulty Change lead try another line input on amp Remote handset operation Batteries weak or wrongly inserted Replace batteries observe polarity erratic or not working Handset signal path is obstructed Remove obstruction move handset Handset transmission angle too wide Operate handset in front of CD Player Room lighting sunlight excessive Darken room GUARANTEE There are no user serviceable parts inside your CD 22 CD Player If a fault should develope refer any servicing to your appointed LITE dealer distributor or LITE approved service agent Your LITE CD 22 CD Player is guaranteed against any defect in materials and workmanship for a period of one year from the date of purchase This guarantee excludes 1 Damage caused due to accident misuse neglect and incorrect installation adjustment or repair 2 Liability for damage or loss during transit from the retailer or purchaser to LITE or its authorized distributor for the purposes of repair or inspection Carriage costs to LITE shall be borne by the consignor All claims under this guarantee must be made through an authorised LITE retailer If equipment returned for repair to LITE is found on inspection to comply w
7. te the receiving antenna e Increase the distance between the CD Player and receiver e Connect the unit to a different mains circuit from that of the receiver e Consult your LITE appointed dealer for help and advice LOCATION Your CD22 CD Player should be located in a well ventilated area and kept away from sources of heat dust humidity and direct sunlight The CD Player may be positioned either as a free standing unit or alongside another audio video product Never place the CD Player on carpet or any surface likely to hinder normal ventilation Never allow liquids or other objects to fall into the unit This unit contains no user serviceable parts Do not remove any panels or attempt to service it yourself Unauthorized servicing will void the warranty CD 22 CD Player Top amp Front Panel View 1 2 3 4 5 6 1 Stop Button 2 Play Button 3 Pause Button 4 Track Back Button 5 Track Forward Button 6 CD drawer amp CD clamp CD 22 CD Player Rear Panel View 2 3 5 1 Analogue Output Balanced XLR Unbalanced RCA 2 Digital Outputs Optical Toslink Balanced AES EBU Coaxial RCA 3 IEC Mains Inlet Socket 4 Voltage Label 5 AC Mains Fuse Holder 6 AC Mains Power Switch SETUP CONNECTING MAINS POWER Please refer to the rear panel view The IEC connector of the supplied mains lead should be plugged into the socket 3 on the rear of the unit first and then plugged into the mains suppl
8. y The Mains power switch 6 is on the rear panel of the CD Player This switch is normally left on If the unit is likely to be unattended for a long period switch it off and unplug the mains lead from the wall SIGNAL CONNECTIONS ANALOGUE OUTPUT The Analogue Output uses Gold plated RCA Phono sockets or XLR connectors and should be connected to the CD or LINE input of your Preamplifier or Amplifier DIGITAL OUTPUT The Digital Output 2 uses a Gold plated RCA Phono socket for Coaxial SPDIF and Toslink for Optical and XLR for Balanced AES EBU output Any of these could be connected to a corresponding input of an amplifier with a digital input or to an outboard Digital to Analogue converter DAC IMPORTANT NOTE For optimum performance it is recommended to use high quality inter connect cables for HI END audio OPERATION Please refer to the rear panel view SWITCHING ON The Mains power switch 6 is located on the rear panel of the CD Player This switch should be left ON for normal operation If unattended for a long period the Mains power should be switched OFF and the lead disconnected from the power supply When switched ON from the rear panel your CD 22 CD Player Display will illuminate in few seconds USING THE CONTROLS Please refer to the top amp front panel view LOADING A DISC Place the disc on the spindle Then place the CD clamp on the spindle The clamp now securely fastens the disc When a disc has been lo
Download Pdf Manuals
Related Search