Standard Operating Procedure Title:_SOP
Contents
1. Standard Operating Procedure Title SOP 013 UV Curing Station PI Art Erdman Lab Location Mayo G217 Issue Date 7 9 13 Revision Date 5 1 14 Prepared by __ Marlina Komarek Approved by Rich Oliphant Hazard Identification Physical Danger Exposure Assessment Light Lighting Elements The UV Carrying Station emits a large amount of UV light which can cause serious harm to the eyes Control Plan Read and become familiar with machine s operating procedures before operating Never look straight at the UV light for any reason Wear the UV filter safety glasses provided Always know where the light is pointing when operating this machine o Never point the light near someone s eyes while operating this machine o Keep the light pointing away from the general lab space where others may be Always know where the power off switch is located in case of emergency Always turn switch to off position when not operating machine Always disconnect the machine from the power source before servicing repairing or making any adjustments Do not wear gloves necktie jewelry or loose clothing as they could get caught in the rotating elements of the fans on the handheld device Tie up long hair or wear protective hair covering to prevent hair from getting caught in the rotating elements of the fans on the handheld device Always hold the handheld light source firmly Stop use including powering down the device and notify a Lab Supervisor if the faul2. t light turns on Experimental Procedures Put on all safety eguipment and tie back loose hair or clothing before operating Check to make sure all parts of machine are working and functioning properly Make sure handheld light is held firmly and is not pointing near anyone s face Set up work piece for operation with UV carrying station Put on UV filter safety glasses Turn on UV light on Controller station When finished turn off UV light immediately Unplug the machine and put it and other eguipment in the appropriate location Clean workspace as needed For other inguiries see the User Manual in Appendix Waste Management Procedures When finished with this machine always clean the area if necessary Paper towels and cleaning solution can be found in G217 11 Place all materials back in the appropriate place Spill and Accident Procedures If an accident occurs report immediately to the lab supervisor G217 05 or other appropriate staff member If no one is around dial 911 on the landline phone near the door of G217 11 to reach the campus police The lab first aid kit is located on the wall near the sink A first aid pamphlet from DEHS is located in all of the MDC s first aid kits Appendix LOCTITE EQUIPMENT Operation Manual Loctite Cure Jet LED System For Use With Part Number 976419 LED Controller Part Number 976420 Cure Jet 405 Part Number 976418 Cure Jet Indigo
Download Pdf Manuals
Related Search