Manual - Virginia Panel Corporation
Contents
1. 50 OHM COAXIAL CONTACTS AND MODULES USER S MANUAL SECTION 3 VIRGINIA PANEL CORPORATION 50 OHM COAXIAL RECEIVER CONTACT INSTALLATION AND REMOVAL PART 610 104 101 610 104 129 610 104 131 TOOLS REQUIRED Power Coaxial Receiver Extraction Tool Part 910 112 101 CONTACT INSTALLATION INSTRUCTIONS 1 Assemble the contact to the respective wire NOTE For more information concerning the process of crimping the contact please see contact assembly instructions in Section of this User s Manual 2 Insert the terminated contact into the back wiring side of the assembled module The contact can only go into one side Once in place pull the wire slightly to ensure that the contact is seated CONTACT REMOVAL INSTRUCTIONS 1 Remove the module from the receiver frame NOTE For more information concerning the process of removing the module from the receiver frame see module installation and removal instructions in Section 4 of this User s Manual 2 Place the Power Coaxial Receiver Extraction Tool Part 910 112 101 Figure A over the contact to be removed replaced Use care to keep the tool perpendicular to the surface of the Figure A Power Coaxial Receiver Extraction Tool Part module otherwise the tool or the contact could be bent 910 112 101 3 Once the extraction tool is seated and the retaining ring tabs on the contact are compressed push the tool into the module Figure B The contact will be2. pushed out of the rear of the module RETAINING RING TAB PRESS DOWN TO EXTRACT CONTACT DO NOT PUSH THE TOOL INTO THE MODULE UNTIL THE TIP OF THE EXTRACTION TOOL HAS BEEN FULLY SEATED INTO THE MODULE AND COMPRESSED THE RETAINING RING TABS ON THE CONTACT EXTRACTION TOOL NOTE The process shown here uses standard 90 series modules The same process is used for modules from other series PRESS GOWN UNTIL FULLY SEATED DETAIL A SCALE 2 1 NOTE If you are using a hybrid module you may need to reference the User s Manual for the other contact type for extraction instructions 50 OHM COAXIAL CONTACTS Figure B Take care to keep the tool perpendicular to prevent bent pins 3 For more information visit voc com 10 4 13
Download Pdf Manuals
Related Search