here
Contents
1. INSTRUCTIONS MANUAL Controls 1 Motion Sensor 2 Siren 3 Infrared Remote Receiver 4 Battery Low Indicator LED 5 External Power Socket 6 Mounting Plate 7 Battery Compartment 8 Arm Button 9 LED 10 Disarm Button 11 Battery Compartment 12 Programmable Switch 13 Battery Cover Battery installation Alarm unit 1 The battery compartment is accessed from the rear of the alarm unit by removing the screws from the side and lifting the mounting plate C 2 Insert four 4 C size batteries not included following the polarity C 3 When the last battery is inserted the alarm will beep very loudly to indicate that the batteries are installed properly 4 Replace the back cover and fix with screw The Battery Low LED will Light when the batteries need replacing XA601 CEILING MOUNTED INTRUDER ALARM with remote control Remote control The remote control uses 3 LR44 batteries included If the red light on the remote control does not come on when either the ARM or DISARM buttons are pressed then the batteries need to be replaced Diagram B shows where the batteries are located Simply remove and replace with fresh batteries Programming the alarm 1 To set or change the security code of the remote control simply set the programmable switches 12 to the desired code and remove the batteries from the alarm unit Then wait at least 30 seconds for the alarm to reset Immediat2. ely after inserting the batteries point the Remote Control at the alarm and press the ARM button the Alarm LED will flash once to indicate that it has learnt the code of the remote control NOTE The alarm must be re programmed with the remote control each time the batteries are removed or replaced NS Installation 1 Place the alarm in the desired location preferably on the ceiling in the center of the area needing to be protected Remove the mounting plate and fix it to the ceiling using the screws and rawplugs supplied D 3 The alarm body can then secured using the screws at the sides NS Operation When exiting from the protected area Point the remote control at the alarm unit and press the ARM button A confirmation tone will indicate that the alarm is armed and you have 30 seconds in which to vacate the area After this time if motion is detected then the alarm will sound When entering the protected area Simply point the remote control at the alarm unit and press the DISARM button Please note that on entering the area there is a short beep to indicate that motion has been detected and a 4 second delay before the alarm will sound to allow it to be disarmed Detection range The motion detector of the alarm unit has a detection range of 360 Detection Area Tested at 25 C range may vary at higher temperature Care and maintenance To clean the case simply use a
3. harge batteries not intended to be recharged as they can overheat and rupture Always follow the manufacturer s directions KEO www xenasecurity com 061107
4. soft slightly damp cloth with water and wipe dry immediately CAUTION Never use chemicals to clean the case as they may cause damage to the plastic and cause the alarm not to function XENA X INTELLIGENT SECURITY Troubleshooting The unit does not sound when the batteries are installed Ensure that the batteries are connected correctly according to the diagram in the battery compartment The alarm does not arm Ensure that the back plate of the alarm unit is secure to hold the batteries in place and that the red light comes on when the ARM or DISARM buttons are pressed The red light on the base of the alarm unit is on This is the Battery Low Indicator The batteries need replacing The red light on the remote control does not light up when the buttons are pressed Remove the battery cover of the remote control and replace the batteries as per the instructions listed above Battery precautions When using this product follow these precautions at all times e Use only the appropriate size batteries e Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment Incorrect polarity may cause damage to the alarm e Do not mix different types of battery such as Alkaline and Carbon zinc or old batteries with new o f the alarm is not used for long periods of time remove the batteries to prevent damage or injury from possible battery leakage e Do not rec
Download Pdf Manuals
Related Search
here hereditary heretic heresy herein hereditary meaning here comes the sun heredity heretic movie heresy definition hereby here lies love here\u0027s johnny heretic definition hereditary movie hereditary hemochromatosis hereditary spherocytosis hereditary angioedema herencia de patrones here movie hereditary spastic paraplegia hereditary hemorrhagic telangiectasia here wego hereby meaning hereditariedade heredia costa rica