T4837 - Mattel
Contents
1. 2010 Mattel Inc All Rights Reserved and designate U S trademarks of Mattel Inc PRINTED IN CHINA IMPRIME EN CHINE T4837pr 0920 Features Features ad Power Button Nightlight press to turn on a soft glow 3 Channel Switch Microphone 9 Power Volume Dial 6 Power L E D D Sound Lights on front and back of receiver watch the light to see baby s sounds Range Indicator lights when power is on and receiver is in range of the transmitter Flashing light indicates the receiver is out of range 9 Low Battery Indicator flashing light indicates batteries need to be replaced or use the AC adaptor Channel Switch a Speaker D Night Light Timer Switch use timer to automatically shut off the night light after 30 minutes Clip backside of receiver Fasten to your clothes to stay in touch with baby around the house or yard Assembly Antenna Antenna Fit each antenna into the socket in the receiver and the transmitter Turn the antennas to secure in place IMPORTANT This product is designed to operate properly with the antennas provided To reduce the chance of potential radio interference to other users assemble and use only the antennas provided Receiver Battery Installation Optional 1 5 x3 AAA LRO3 J e Locate the battery compartment door on the back of the receiver e Loosen the screw in the battery compartment door with a Phillips screwdriver Remove th2. Protect the environment by not disposing of this product with household waste 2002 96 EC Check your local authority for recycling advice and facilities Europe only Setup Night Light Timer Switch Back Side of Transmitter Vu 6 2 Channel Switch Channel Switch Night Light Button e Set the transmitter channel switch to the same channel as the receiver s Place the transmitter in the same room with child Point the microphone towards the crib or play area Unwrap and fully extend the AC adaptor for best transmission Insert the AC adaptor pin into the DC input jack on the transmitter and plug the power cord into a standard wall outlet Use the power cord only in a wall outlet Do not plug into a ceiling outlet Press the transmitter power button to turn the power ON the button lights up Press the night light button for a soft glowing light Press again to turn off the night light Slide the night light timer switch to turn the timer y 0n When the timer is on the night light will automatically shut off after 30 minutes 10 Testing Sound Reception Test transmitter and receiver reception each time you change location of use Power Button Place the transmitter in the room where you intend to use it Press the transmitter power button to turn the power ON the button lights up Set the transmitter channel switch to the same channel as the receiver Turn on a radio 11 Testing Sou
3. Qe D ss www fisher price com IMPORTANT A1 DANGER To prevent electric shock do not immerse in water wipe clean with damp cloth Zi WARNING To prevent strangulation with power cord never place transmitter within reach of child AN CAUTION This product cannot replace responsible adult supervision Consumer Information For proper setup and use please read these instructions Please keep this instruction sheet for future reference as it contains important information e Transmitter operates on AC current use enclosed AC adaptor Receiver operates on AC current use enclosed AC adaptors or DC current three AAA LRO3 alkaline batteries not included e Adult assembly is required Tool needed for receiver battery installation Phillips screwdriver not included e This product is not intended to be used as a medical monitor and its use should not replace adult supervision Test sound reception of receiver before first time use and whenever you change location of the transmitter To prevent entanglement Never place transmitter in a crib or playpen Keep transmitter and receiver out of baby s reach Never use extension cords with the AC adaptors Adults Note Periodically examine the AC adaptors for damage to the cord housing or other parts that may result in the risk of fire electric shock or injury If an AC adaptor is damaged do not use it Never use transmitter or
4. sidentielle Cet quipement g n re utilise et peut mettre de l nergie radiofr quence S il n est pas install et utilis conform ment aux instructions il peut provoquer des interf rences sur les communications radio Cependant il n est pas garanti que des interf rences ne se produiront pas dans certaines installations Si cet quipement cause des interf rences la r ception radio ou t l vis e ce qui peut tre v rifi en teignant l appareil puis en le remettant sous tension l utilisateur peut tenter de les r soudre en suivant une ou plusieurs des mesures ci apr s R orienter ou d placer l antenne r ceptrice Augmenter l espace entre l appareil et le r cepteur Brancher l appareil une prise de courant diff rente de celle sur laquelle le r cepteur est branch Pour obtenir de l aide contacter le vendeur ou un technicien radio t l vision exp riment REMARQUE Toute modification non autoris e express ment par le fabricant responsable de la conformit peut annuler le droit de l utilisateur faire fonctionner le produit Moniteur Num ro de produit T4837 Cet appareil est conforme l article 15 de la r glementation de la FCC L utilisation de ce dispositif est autoris e seulement aux deux conditions suivantes 1 il ne doit pas produire de brouillage nuisible et 2 l utilisateur du dispositif doit tre pr t accepter tout brouillage radio lectrique re u m me si ce brouillage est suscept
5. the receiver is out of range 13 Problems amp Solutions Problem Solution Transmitter range indicator light flashes Receiver power indicator does not light Receiver low battery indicator light flashes Transmitter power L E D does not light at all You can hear conversations or sounds from other homes Receiver is out of range of transmitter Move receiver closer to transmitter Note Range varies depending on surrounding conditions such as noise levels physical obstructions and signal interference Transmitter power is off Turn transmitter power on Channel switches are on different channels Make sure channel switches on both transmitter and receiver are set to same channel Loose power cord connection and transmitter power is off Check transmitter power cord plug to outlet connection No power to wall outlet and transmitter power is off Make sure light Switch that controls power flow to wall outlet is on Power is off because circuit breaker for room is off Make sure house fuses and circuit breakers are on Receiver power is off Turn receiver power on Batteries in receiver are weak or dead Replace all batteries with three AAA LRO3 alkaline batteries or use the AC adaptor as a power source Power is off because circuit breaker for room is off Make sure house fuses and circuit breakers are on No power to wall outlet and power is off Make sure light switch that control
6. dispositif doit tre pr amp t accepter tout brouillage radio lectrique recu m me si ce brouillage est susceptible de compromettre le fonctionnement du dispositif
7. e battery compartment door e Insert three AAA LR03 alkaline batteries into the battery compartment Hint We recommend using alkaline batteries for longer battery life e Replace the battery compartment door Tighten the screw with a Phillips screwdriver Do not over tighten Battery Safety Information In exceptional circumstances batteries may leak fluids that can cause a chemical burn injury or ruin your product To avoid battery leakage Do not mix old and new batteries or batteries of different types alkaline standard carbon zinc or rechargeable nickel cadmium Insert batteries as indicated inside the battery compartment Remove batteries during long periods of non use Always remove exhausted batteries from the product Dispose of batteries safely Do not dispose of this product in a fire The batteries inside may explode or leak Never short circuit the battery terminals Use only batteries of the same or equivalent type as recommended Do not charge non rechargeable batteries Remove rechargeable batteries from the product before charging e f removable rechargeable batteries are used they are only to be charged under adult supervision Care e Excess dirt in the transmitter microphone will hamper transmission of sound Clean the outer surface of the transmitter and the receiver with a cloth lightly dampened with a mild cleaning solution e Never immerse the transmitter receiver or AC adaptor
8. erence will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help Note Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user s authority to operate the equipment Monitor Model Number 14837 This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation Monitor Consumer Relations Department 636 Girard Avenue East Aurora New York 14052 U S A Enonc de la FCC Etats Unis seulement Cet quipement a t test et jug conforme aux limites de Classe B pour un appareil num rique en vertu de l article 15 de la r glementation de la FCC Ces limites ont t instaur es pour fournir une protection raisonnable contre toute interf rence nuisible dans une installation r
9. ible de compromettre le fonctionnement du dispositif Moniteur Service la client le 636 Girard Avenue East Aurora New York 14052 tats Unis 15 RSS 310 This Category Il radio communication device complies with Industry Canada Standard RSS 310 Operation is subject to the following two conditions 1 this device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation ICES 003 This Class B digital apparatus complies with Canadian ICES 003 Operation is subject to the following two conditions 1 this device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation CNR 310 Ce dispositif de radiocommunication de cat gorie Il respecte la norme CNR 310 d Industrie Canada L utilisation de ce dispositif est autoris e seulement aux conditions suivantes 1 il ne doit pas produire de brouillage et 2 l utilisateur du dispositif doit amp tre pr amp t accepter tout brouillage radio lectrique recu m me si ce brouillage est susceptible de compromettre le fonctionnement du dispositif NMB 003 Cet appareil num rique de la classe B est conforme la norme NMB 003 du Canada L utilisation de ce dispositif est autoris e seulement aux conditions suivantes 1 il ne doit pas produire de brouillage et 2 l utilisateur du
10. nd Reception ausa diez tr PowarVolina Dial Place the receiver in the room where you intend to use it Rotate the power volume dial to turn the power ON Wait a few seconds to see if you have a good signal If the range indicator light turns on you are out of range First try switching to a different channel on both the receiver and transmitter If the range indicator stays on move the receiver closer to the transmitter 12 Place the receiver where you can see and hear it Unwrap and fully extend the AC adaptor cord for best reception Insert the AC adaptor pin into the DC input jack on the receiver and plug into a standard wall outlet Note To use battery power refer to the Receiver Battery Installation section Turn the power volume dial up to turn the power ON The power light will light up Adjust the volume as needed Hint If you are using battery power and the battery power is low the low battery indicator will flash Replace the batteries with three new alkaline AAA LRO3 batteries or use the AC adaptor as a power source When sound is picked up by the receiver the sound lights turn on One or two lights indicate quieter sounds Three or more lights indicate louder sounds Clip the receiver onto your clothes to stay in touch with baby around your house or yard Hint The receiver s range is up to 500 feet 152 m away from the transmitter The range indicator will turn on and you will hear a tone when
11. receiver near water i e bathtub sink wet basement etc Always use the transmitter and receiver where there is adequate ventilation To prevent overheating keep the transmitter and receiver away from heat sources such as radiators heat registers direct sunlight stoves amplifiers or other appliances which produce heat Do not connect the transmitter or the receiver if AC adaptor is used to more than the recommended number of power supplies e The AC adaptor is not a toy Disconnect the AC adaptor from the receiver before cleaning e Fisher Price does not recommend the use of two monitors in one house e Always remember that you are using public airwaves when using your monitor Conversations even from rooms near your transmitter may broadcast to other nursery monitors radios cordless telephones or scanners outside your home To protect the privacy of your home always turn off the transmitter when not in use e Carrier Frequency 49 8 MHz e Product features and decoration may vary from photos CONSUMER ASSISTANCE AYUDA AL CONSUMIDOR SERVICE A LA CLIENTELE 1 800 432 5437 US amp Canada service fisher price com Fisher Price Inc 636 Girard Avenue East Aurora NY 14052 Hearing impaired consumers Clientes con problemas auditivos Pour les malentendants 1 800 382 7470 En M xico 59 05 51 00 Ext 5205 6 01 800 463 59 89 Fisher Price Inc a subsidiary of Mattel Inc East Aurora NY 14052 U S A
12. s power flow to wall outlet is on Batteries in receiver are weak or dead Replace all batteries with three AAA LRO3 alkaline batteries or use the AC adaptor as a power source Transmitter power is off Turn transmitter power on Loose power cord connection and transmitter power is off Check transmitter power cord plug to outlet connection No power to wall outlet and transmitter power is off Make sure light Switch that controls power flow to wall outlet is on Power is off because circuit breaker for baby s room is off Make sure house fuses and circuit breakers are on There is signal interference due to other nursery monitors on same channel or cordless telephone use Change channel switches on both transmitter and receiver to eliminate source of interference Hint If after checking all of these solutions you believe that your transmitter power cord or AC adaptor are damaged please contact Fisher Price FCC Statement united states only This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interf
Download Pdf Manuals
Related Search