Home

Manual

1. WIiboox Unpacking Your Wiiboox and Getting Started Please remember that your Wiiboox 3D printer is carefully built and packaged at Wiiboox factory to ensure it arrives at your doorstep safe and sound We hope that you will take your time and read this booklet to get your Wiiboox 3D printer set up successfully If there is any damage because of shipping or the machine does not work normally please contact us without any hesitation 1 Open the box and take your 3D printer out Open the box containing your 3D printer and remove it from protective foam and plastic bag Set your 3D printer on a flat and stable surface 2 Check the outside Check if there is any damage or if any parts of the machine fall off If there is some screws less crowded please locate a hex wrench from the accessory tray and tighten it up 3 Remove zip ties Locate the scissor or diagonal cutting pliers in the accessory tray and use it to cut the zip ties and silicon rubber sheets on the z axis that prevent the build platform from moving during shipping 4 Remove clips Locate 2 5mm allen wrench in the accessory tray and use it to remove the clips holding the x axis and extruder carriage in place Be careful when remove the clips to avoid the belt to come loose xr h yom 5 Check end stop switches End stop switches in normal status are shown as the picture below Please check the springs of 3 motor end stop switches and wheth
2. er there is any deformation or any parts fall off 6 Switch the power on Make sure the power switch at the back of your 3D printer is in the OFF position Locate the power cord and plug it in the power input at the back of Wiiboox One Plug the power cord into an electrical outlet Switch the power on and press the front power switch to start your 3D printer 7 Print a test object Please refer to user manual to install filament spool and load filament to extruder and print your first model 02_thinwallCube x3g from the SD card Me _ Thinwal lCube x39 exit merry 8 Check the test object When the print is finished remove it from the build plate Firstly check the sides of the cube The nozzle is at normal status if the surface is smooth and there is no splitting layers Then check the right angle edges are perpendicular to make sure the x axis and y axis are in normal status Finally check the longitudinal strips of the base part of the test object If the strip is of the same width and the width of the gaps between strips is 3 times of the width of the strip it means the distance between extruder and build plate is normal ee treet ete ee Please refer to the user manual on how to adjust and level the build plate Damage will be caused to nozzle extruder and printer circuit if the distance between nozzle and build plate is too narrow Click here to watch video unboxing guide C
3. ontact Rebecca QIN Email Rebecca wiiboox net Skype wiiboox

Manual

Contents

Download Pdf Manuals

Related Search

Related Contents