instruction manual
Contents
1. No 2464 Power Dome LT User s Manual Power Dome LT by Wagan Tech Thank you for purchasing the Power Dome LT by Wagan Tech With normal care and proper treatment it will provide years of reliable service IMPORTANT INFORMATION Please read and understand all warnings cautions and notes included in this manual before using the Power Dome LT Follow instructions provided by your vehicle manufacturer and other devices intended to be used with this unit Keep these instructions for future reference Make sure the Power Dome is fully charged before first use We recommend 48 hours for initial charge GENERAL WARNINGS g HIGH VOLTAGE The inverter output can be lethal Improper use may result in property damage personal injury or loss of life e This appliance is NOT intended for use by persons with reduced physical sensory mental capabilities Children or persons lacking in experience and knowledge also should NOT operate this appliance unless he she has been given supervision or instruction concerning the proper usage and warnings of the appliance by a person responsible for their safety For proper and safe operation of any accessory outlet do not place anything in it except the plug of the accessory to be used e Use only the chargers cables and clamps provided Unauthorized parts may damage the unit Do not attempt to remove or replace the battery used in this d2. Inverter Peak Power 400 watts peak surge for a max of 0 3 seconds Inverter Low Voltage Alarm 10 5V 0 5V Low Voltage Shut off 10 0V 0 5V Fuse 25 Amps AC Outlet 115 volts DC Sockets 12 volt 10 Amps max USB Power Port 5V 500 mA Work Light 3x LEDs Charging Time AC 48 hours Charging Time DC with engine running 12 hours 2015 Wagan Corporation All Rights Reserved Wagan Tech and wagan com are trademarks used by Wagan Corporation Power Dome LT by Wagan Tech FRONT VIEW H E T c www wagan com User s Manual Read before using this equipment REAR VIEW 8 9 Voltmeter AC Outlet Pressure Gauge 2 3 4 5 6 7 Ventilation Hole Air Compressor Switch Master Switch Indicator Inverter USB Switch Inverter Power Indicator DC Socket 0 Air Compressor Hose 11 LED Worklight 12 Charging Indicator 13 USB Power Port 14 Charging Jack 15 Worklight Switch 16 DC Socket 17 Jumper Cable negative 18 Master Switch 19 Fuse 20 Jumper Cable positive 2015 Wagan Corporation All Rights Reserved Wagan Tech and wagan com are trademarks used by Wagan Corporation Power Dome LT by Wagan Tech BATTERY STATUS The voltmeter provides the current state of charge on the internal battery It is the user s responsibility to periodically monitor th
3. al may not operate properly with this type of inverter Some motorized devices may operate at excessively elevated temperature when used with this inverter During first use with this inverter check for excessive motor temperature Abnormally elevated temperature of the device is an indication that they should not be used together Operation 1 Check the required current draw of the appliance device to be powered and make sure it does not exceed the Power Dome s maximum wattage 2 Prior to plugging in your device turn your power tool or appliance off mobile devices are fine to keep on Open the AC outlet dust cover Connect the electrical plug of the device to the AC outlet Turn the Master Switch on Set the Inverter USB Switch to the position If the Inverter Power Indicator light stays green the inverter is operating Turn on your AC device appliance After use remove the appliance plug and close the dust cover 10 Recharge the Power Dome as soon as it is convenient 2015 Wagan Corporation All Rights Reserved Wagan Tech and wagan com are trademarks used by Wagan Corporation Power Dome LT by Wagan Tech DC OUTPUT SOCKET The DC accessory socket can power a DC load up to 10 Amps Overloading the socket will result in tripping a self resetting circuit breaker Removing the overload automatically restores power to the DC socket 1 N N Check the req
4. e battery s status and recharge at least every 3 to 6 months in addition to recharging after each use 1 Disconnect any input or output power cords and turn off all switches 2 Turn the Master Switch on 3 Read the voltmeter to determine battery status e gt 12 5V Battery is fully charged e 12V Battery should be charged before jumpstarting a vehicle lt 12V Battery is discharged charge immediately CHARGING THE POWER DOME Charge your Power Dome for a full 48 hours before initial use The Power Dome can be charged continuously via AC adapter without damaging the internal battery In order to prolong the life of the Power Dome as with all lead acid batteries be sure to fully recharge the unit every 3 to 6 months even if the Power Dome has not been used AC Charging Make sure the supplied AC DC charging adapter is to be powered by the correct voltage 110V AC or 220V AC depending on your country region Only use the AC charging adapter supplied with this unit Make sure all Power Dome switches are off including the Master Switch Open the dust cover on the charging jack Plug the DC end of the AC DC charging adapter into the Power Dome s charging jack Connect the AC end of the AC DC charging adapter the wall outlet The charging indicator will light up during the charging process After charging the battery disconnect the adapter from the AC outlet first then from the charging jack 7 Replac
5. e immediately Excessive current drawn by appliance being operated Reduce load to maximum wattage 1 Turn off the device and inverter 2 Disconnect device 3 Turn the inverter on and let it run for a minimum of 2 minutes 4 Turn inverter off 5 Quickly plug device into inverter 6 Turn on both the inverter and the device Inverter fuse blown Check and replace if necessary Be sure replacement fuse is the same type and rating Television power tool will not start Required wattage exceeds Power Dome peak surge for start up Toggle the Inverter USB Switch on and off in quick succession for 5 times If the device does not start the device is not compatible with this type of inverter Television Interference Picture breaking up static Place the Power Dome as far as possible from the TV antenna and coaxial cable TV station may be out of range Static noise interference in audio system Sound system has weak alternating current shielding Do not use the Power Dome s inverter with low quality audio AC filtering system Replace audio system with high quality noise filtering 2015 Wagan Corporation All Rights Reserved Wagan Tech and wagan com are trademarks used by Wagan Corporation WAGAN Corp Limited Warranty The WAGAN Corporation warranty is limited to products sold only in the United States Warranty Duration Product is warra
6. e the dust cover on the charging jack DC Charging in Your Vehicle or Boat Only use the DC charging adapter supplied with this unit Note that the engine must be running while charging the Power Dome and do NOT exceed 12 hours of charging time Make sure all Power Dome switches are off including the Master Switch Open the dust cover on the charging jack Plug the small end of the DC power cord into the Power Dome s charging jack Plug the large end of the DC power cord into an accessory cigarette lighter socket a gt The charging indicator will light up during the charging process Do NOT charge for more than 12 hours at one time www wagan com User s Manual Read before using this equipment 6 After the battery is charged disconnect the power cord from the accessory socket first then from the unit s charging jack 7 Replace the dust cover on the charging jack JUMPSTARTER Warnings e lead acid batteries can release explosive gasses Failure to follow instructions may cause property damage explosion hazard and or personal injury Do not smoke while jumpstarting Jumpstart a vehicle or boat in a well ventilated area e Do not attempt to jumpstart a frozen battery e This product is not intended for use in the rain or temperatures above 130 F Do not let the jumper cables or other attached appliances get wet Do not wear vinyl clothing when jumpstarting frictio
7. evice When the battery has reached the end of its lifetime please take the entire unit to a battery recycling facility PROPER DISPOSAL Appliance accessories and packaging should be recycled in an environmentally friendly manner Plastic parts are coded for purposes of separation when recycling e Accumulators and battery powered electrical appliances contain materials which harmful to the environment Do not dispose of batteries and or electric electronic appliances in normal household refuse J www wagan com User s Manual Read before using this equipment FEATURES e Powerful jumpstarter with heavy duty cables and clamps e Jumpstart cable power switch safety protection Voltmeter for checking battery status High pressure air flow compressor for inflating tires and sports equipment with easy read analog pressure gauge e Built in power inverter providing one 115 volt AC outlet e Additional DC accessory outlets for powering DC appliances One USB power port for charging cell phones digital cameras and MP3 players e Bright long lasting LED area light AC DC recharging adapter amp DC recharging cable fused included SPECIFICATIONS Battery AGM Sealed lead acid 12 volt 12Ah Peak Amps 300A Jumper Cables 6 AWG 24 inches long Air Compressor 260 PSI analog gauge Inverter Continuous Output Power 200 watts modified sine wave
8. n can cause static electricity sparks e Remove all metal jewelry to avoid short circuits Always use safety glasses when jumpstarting battery acid can cause blindness and or severe burns Never allow red and black clamps touch this can cause power arcing and or explosion Make sure someone is available to give assistance if needed Keep out of reach of children Procedure CAUTION If the engine fails to start after three attempts discontinue jumpstart procedure Excessive engine cranking can damage the vehicle s starter motor Look for other problems that may need to be corrected or call for professional service gt Review the Jumpstarter warnings Put the vehicle s gear is in park position and make sure the brake is set Turn off all vehicle appliances lights radio etc Turn off all Power Dome switches and disconnect all accessories Determine the ground system of your vehicle e If vehicle to be started has the positive battery terminal connected to chassis this is rare and usually found in older car models from 1950s or earlier i Connect the black clamp first to vehicle battery s negative black terminal ii Connect red clamp to vehicle chassis or solid non moving metal vehicle component or body part DO NOT clamp directly to positive battery terminal or a moving part 2015 Wagan Corporation All Rights Reserved Wagan Tech and wagan com are trademarks u
9. nted to the original purchaser for a period of one 1 year from the original purchase date to be free of defects in material and workmanship WAGAN Corporation disclaims any liability for consequential damages In no event will WAGAN Corporation be responsible for any amount of damages beyond the amount paid for the product at retail Warranty Performance During the warranty period a product with a defect will be replaced with a comparable model when the product is returned to WAGAN Corporation with an original store receipt WAGAN Corporation will at its discretion replace or repair the defective part The replacement product will be warranted for the balance of the original warranty period This warranty does not extend to any units which have been used in violation of written instructions furnished Warranty Disclaimers This warranty is in lieu of all warranties expressed or implied and no representative or person is authorized to assume any other liability in connection with the sale of our products There shall be no claims for defects or failure of performance or product failure under any theory of tort contract or commercial law including but not limited to negligence gross negligence strict liability breach of warranty and breach of contract Returns Please contact customer service by phone email or visiting our website under Customer Care page for instructions on how to process a warranty claim WAGAN Corporation is not
10. responsible for any shipping charges incurred in returning the item s back to the company for repair or replacement nor is WAGAN responsible for any item s returned without an official Return Authorization number RA Register your product online at http tinyurl com wagan registration to be added to our email list You will receive previews on our upcoming products promotions and events 2015 31088 San Clemente Street Hayward CA 94544 U S A Tel 1 510 471 9221 U S amp Canada Toll Free 1 800 231 5806 customerservice wagan com www wagan com 2015 Wagan Corporation All Rights Reserved Wagan Tech and wagan com are trademarks used by Wagan Corporation REV20150506 E
11. sed by Wagan Corporation Power Dome LT by Wagan Tech e If vehicle to be started has a negative ground system i Connect red cable clamp first to the vehicle s positive red battery terminal ii Next connect the black clamp to the vehicle chassis 6 Inside the vehicle turn on the ignition switch and attempt to start the engine N Crank a maximum of 3 seconds If the engine does not start wait 3 minutes before the next attempt After the engine starts turn off the Master Switch Disconnect the black clamp first and then disconnect the red clamp Be sure that the cables and clamps are securely stored 0 Recharge the Power Dome as soon as convenient AIR COMPRESSOR This Power Dome is equipped with an air compressor that can provide up to 260 PSI pounds per square inch of pressure for a variety of uses such as vehicle tires and sports equipment CAUTION Be careful not to over inflate monitor the compressor gauge while inflating Never connect or disconnect the nozzle with the compressor operating To avoid overheating do not operate the air compressor for more than 10 minutes at a time After 10 minutes allow the compressor to cool for 15 minutes before using again 1 Before any tire inflation look for the recommended inflation pressure information on the sidewall of the tire Open the compartment door on the side of the Power Dome and extend the air hose Position the Power Dome so
12. that you can see the pressure gauge Make sure the chuck lever is positioned up away from the chuck opening Remove the valve cap from the valve stem of the tire Attach the chuck to the tire s valve stem Move the chuck lever down to secure the chuck to the valve stem Turn the Master Switch on oO DONO PWN Set the Air Compressor Switch on to the I position The blue indicator will light up 10 Monitor the pressure gauge while inflating the tire 11 When recommended tire pressure has been reached turn off the air compressor 12 Disconnect the hose and replace valve cap 13 Return the hose back to its compartment for storage 14 Turn the Master Switch off The indicator light will gradually dim until it is off 15 Recharge the Power Dome as soon as it is convenient J www wagan com User s Manual Read before using this equipment POWER INVERTER The Power Dome LT can run most AC appliances or a combination of appliances up to 200 watts Operating time is dependant on the AC load required wattage and the current charge condition of Power Dome s internal battery Reduced AC loads and or having a full charge on the internal battery will result in longer operating time Caution Some rechargeable devices are equipped with a separate AC charger These devices are likely to operate properly with this inverter Rechargeable devices that have built in chargers see device owner s manu
13. uired current draw of the appliance device to be powered and make sure it does not exceed the Power Dome s maximum wattage Make sure all Power Dome switches are off including the Master Switch Remove the dust cover from the DC socket Insert the 12V DC accessory plug into the socket Turn the Master Switch on Operate the appliance as usual After use disconnect the accessory plug from the DC socket and store the accessory Replace the dust cover Recharge the Power Dome as soon as convenient USB POWER PORT 1 Prior to connecting your mobile device make sure that the Master Switch is turned off 2 Connect the USB cable to the USB power port on the Power Dome 3 Turn the Master Switch on 4 Set the Inverter USB Switch to I position You may operate the USB and the inverter at the same time by setting the Inverter USB Switch to the II position or just operate the USB only in the I position WORK LIGHT 1 Turn the Master Switch on 2 Turn the work light switch on 3 The 3 LEDs will illuminate A Turn the light off when it is not in use J WAGAN T H www wagan com User s Manual Read before using this equipment TROUBLESHOOTING Problem Cause Solution Air compressor shut off High temperature protection Allow the Power Dome cool for about 10 minutes Lack of power output Power Dome battery voltage is below 10 volts Recharge the Power Dom
Download Pdf Manuals
Related Search