HM-3 Label
Contents
1. Pea ica the ear tip with a mild soap and water solution to extend the life of the accessory SO N ETI CS ST EA LTH LI G HTWE l G HT To prolong the life of the accessory store the accessory away from high temperature conditions HEARING PROTECTION WARNING H EADS ETS These communications products are designed to produce a specific audio output level at maximum rated power Many countries have regulations defining the amount of noise that an individual can be subjected to during a normal workday The duration of exposure the level of audio output and the level of ambient noise will affect compliance to these regulations Compliance is application dependent and standards vary It is the SOLE RESPONSIBILITY of the end user to determine applicability of and compliance to local hearing protection regulations When purchasing any accessories that use earphone kits it is the SOLE RESPONSIBILITY of the user to determine proper fit Always use caution when inserting any of the products into your ear Parts amp Accessories Sonetics PIN STL 30 STL 50 STL 70 _1140107 00 Xx SpeakerFoam o _1140111 00 X x _ Foam Microphone Windscreen 5 STL 30 30PTT Lightweight Behind Head 114011200 x Foam Earphone Cover 6 STL 50 50PTT Overhead Copyright 2012 Sonetics Corporation All rights reserved The information in this document is subject to change without notice No part of this document may be reproduced in any for2. m without prior written consent of Sonetics Corporation Document number 600 0329 00 Rev A STL 70 70PTT Heavy Duty Behind Head STL 30 30PTT Lightweight Behind Head Designed for less rigorous applications where an adjustable headband would not be necessary When used with a Sonetics belt pack this headset provides high clarity and discreet two way communications while offering the comfort necessary for extended wear and a secure fit in active environments The STL 30 30PTT headsets can be worn under a helmet or cap The STL 30PTT includes an in line Push To Talk PTT switch for easier PTT access Mechanical Specifications e Temple pad axial pull off force 20 lbs e Cable pull from ear cup axial 30 Ibs e Microphone boom flex life 60 bend 4 000 cycles Electrical Specifications e Microphone sensitivity at 94dB SPL 40 typical Environmental Specifications e Operating temperature 20 C to 60 C e Storage temperature 40 C to 80 C STL 50 50PTT Overhead Headset This headset is a single ear model featuring a swivel boom microphone for two way communications and is intended for use in areas with high background noise to provide privacy and noise isolation The STL 50PTT includes an in line Push To Talk PTT switch for easier PTT access STL 70 70PTT Lightweight Behind Head This headset is used for 2 way belt pack communications in areas with moderate background noise to provide privacy and noise i
3. rn the belt pack on and operate it as explained in the belt pack s User Manual e Place the microphone in front of the mouth NO MORE than 1 8 away from the lips e Placement of the microphone is CRITICAL for proper operation If the microphone is positioned incorrectly you may experience a reduction in volume and clarity of intercom and radio communication e STL XXPTT Headsets Microphone is activated by the headset in line push to talk switch AN No more than 1 8 from lips
4. solation Ergonomically designed the STL 70 is a slim rugged single ear unit that performs under harsh conditions such as blowing rain and in hazardous situations such as water rescues The STL 70 is Mil Spec and IS ATEX certified and has a comfortable fit that provides clear and consistent communications for short and long term assignments The STL 70PTT includes an in line Push To Talk PTT switch for easier PTT access These headsets feature e Flexible boom with bi directional noise cancelling microphone e Adjustable headband e Microphone windscreen Mechanical Specifications e Cable pull from PTT module axial 20 Ibs e Cable pull from headset axial 66 Ibs e Flex cycles at cable 10 000 cycles Electrical Specifications e Microphone sensitivity at 94dB SPL 40 min 24 max Environmental Specifications e Operating temperature 20 C to 60 C e Storage temperature 40 C to 80 C e Water wind and dustproof INSTALLATION 2 3 The headset has aclip to secure it to acollar of ashirt jacket etc 4 STL 30 amp STL 70 The headband is worn behind the head with the speaker on the left ear 5 STL 50 The speaker can be located on either right or left ear 6 STL 30 30PTT recommended microphone gain level 10 see belt pack User Manual Programmable Squelch 7 STL 50 50PTT STL 70 70PTT recommended microphone gain level 4 see belt pack User Manual Programmable Squelch OPERATION e Tu
Download Pdf Manuals
Related Search