Home

User`s Manual - Primo Water Store

1. dispenser is positioned on a level surface For additional instructions and videos for maintaining and operating your dispenser please visit www primowater com Go to Customer Care and click on FAQs Or please call 866 429 7566 for assistance PN 0 079 2013 Primo Water Corporation
2. door at top Rest probe assembly here to keep it clean when changing bottles Drip Tray amp Grid with Full Indicator Dishwasher safe Slides in and out Red full indicator in tray rises when tray is full indicating it s time to empty Water Bottle Not included Uses 3 4 or 5 gallon bottles Visit www PrimoWater com to find Primo Water at a store near you Convenience Switches Located on back in a panel of 3 switches e Nightlight Blue switch located on the far left of the panel Allows you to choose to have the nightlight ON or OFF e Hot amp Cold Controls Switch red control to OFF to stop heating Switch green control to OFF to stop cooling Activate Cold Switch Notice This unit will not dispense cold water until the switch is activated To activate push top side of the green switch ON in to start cooling water If you do not want cold water leave switch in OFF position bottom side pushed in Activate Hot Switch Notice This unit will not dispense hot water until the switch is activated To activate push top side of the red switch ON in to start heating water If you do not want hot water leave switch in OFF position bottom side pushed in Activate Nightlight To activate push top side of the blue switch ON in The LED bulb behind center spout will light If you do not want a nightlight leave switch in OFF position bottom side pushed in Register at Club Primo While you wait for t
3. IMPORTANT Do Not Return Dispenser to Store If you have questions or issues please contact 1 866 429 7566 for expert assistance O O PRIMO PRIMO i Bottom Loading Water Dispenser Model 601144 FSO ae a NL lt lt x NI l K A WARNING TO REDUCE THE RISK OF INJURY AND PROPERTY DAMAGE USER MUST READ THIS MANUAL BEFORE ASSEMBLING INSTALLING amp OPERATING DISPENSER SAVE THIS MANUAL FOR FUTURE USE ENERGY STAR UL The Energy Star certificate was issued by Intertek Testing Services Shenzhen Ltd SET UP No tools or hardware required Locate Dispenser Notice Do NOT plug power cord into wall outlet until instructed 1 Place dispenser upright 2 Locate dispenser on a hard and level surface in a cool shaded location near a ground fault interrupting receptacle 3 Position dispenser so the back is at least 4 inches from wall and there are at least 4 inches of clearance on both sides Install Drip Tray amp Grid 1 Remove drip tray and grid from protective packaging 2 Slide drip tray assembly into position until it is secure Head A Collar Ei Install Water Bottle da Bottle not included Requires standard 3 4or5 gallon water dispenser bottles Visit www PrimoWater com to find Primo Water at a store near you 1 Clean bottle cap and neck with a cloth and warm soapy water then rinse Open dispenser door Place probe assembly on probe hanger Place fresh bottle outside of ca
4. binet Remove entire plastic cap from top of bottle Clean outside of new bottle with a cloth Place probe into bottle Slide collar down until it clicks in place Push head down until tube hits bottom of bottle Slide bottle into cabinet and close door Notice Water will not pump from bottle unless door is fully closed Head a O o N pa e a y O Provide Electricity Plug cord into a ground fault interrupting receptacle At this time the pump will begin to move water from the bottle to the hot and cold tanks It will take up to 4 minutes to fill the tanks for the first time During this period the pump will run continuously This is normal FEATURES amp FUNCTIONS Function Lights Green light above ON icon indicates the dispenser is plugged in Green light above snowflake indicates the dispenser is cooling water Green light above wavy lines indicates the dispenser is heating water Blinking red light above the bottle icon indicates the bottle is empty Cold Paddle Control Depress paddle with beverage container to dispense Release to stop Hot Paddle Control with Child Safety Feature Push red button and depress paddle with beverage container to dispense Release to stop LED Nightlight Located between the spouts Helps in low light situations Probe Assembly Located inside cabinet Connects to bottle to allow water to be pumped into hot and cold tanks Probe Hanger Located inside
5. ed technician Please contact us at 866 429 7566 for assistance Dispensing Hot Water 176 198 F 80 92 C Tank Capacity 1L Flow Rate 35mL per second 2 1L per minute CAUTION This unit dispenses water at temperatures that can cause severe burns Avoid direct contact with hot water Keep children and pets away from unit while dispensing Never allow children to dispense hot water without proper and direct supervision Unplug unit to prevent unsupervised use by children After setup hot water will be available in 15 20 minutes 1 Position bottle glass pitcher or cooking pot below spout 2 Press and hold red button and depress paddle with container to start flow 3 Release paddle once desired fill level is achieved MAINTENANCE For best taste performance and hygiene 1 Clean your cabinet controls bottle probe and spout each time you change your water bottle Use a clean soft cloth and a food grade sanitizer or bleach 2 Empty and clean drip tray grid and float as needed 3 To minimize mineral deposits which can clog lines and imparts odors and off tastes use only high quality Primo purified bottled water CHANGING BOTTLES A flashing red function light alerts you when your bottle is empty Replace the bottle as soon as possible CAUTION Do not dispense hot cool or cold water if the red light is flashing as you could empty the tanks and cause the dispenser to overheat 1 Open dispenser door and slide empt
6. he water to get to the desired temperatures please register your dispenser This will be helpful should you need customer service assistance in the future Go to www PrimoWater com and click on Club Primo OPERATION This water dispenser has been tested and sanitized prior to packing and shipping During transit dust and odors can accumulate in the tank and lines Dispense and dispose at least one quart of water prior to drinking any water Dispensing Cold Water 37 50 F 3 10 C Tank Capacity 3 6L Flow Rate 35mL per second 2 1L per minute After setup it will take 1 hour to get water to maximum cold temperature During this time the compressor will run continuously This is normal 1 Position bottle glass pitcher or cooking pot below spout 2 Depress cold water paddle with container to start water flow 3 Release paddle once desired fill level is achieved WARNINGS amp SAFETY PRECAUTIONS To reduce risk of injury and property damage user must read this entire guide before assembling installing amp operating dispenser Failure to execute the instructions in this manual can cause personal injury or property damage Models that heat water dispense at very high temperatures Failure to use properly can cause personal injury When operating this dispenser always exercise basic safety precautions including the following e Prior to use this dispenser must be properly assembled and installed in accorda
7. nce with this manual e This dispenser is intended for water dispensing only Do NOT use other liquids Do NOT use for other purposes Never use any other liquid in the dispenser other than known and microbiologically safe bottled water e For indoor use only Keep water dispenser in a dry place away from direct sunlight Do NOT use outdoors e Install and use only on a hard flat and level surface e Do NOT place dispenser into an enclosed space or cabinet e Do NOT operate dispenser in the presence of explosive fumes e Position back of dispenser no closer than 4 inches from wall and permit free airflow between wall and dispenser There must be at least 4 inches clearance on the sides of the dispenser to permit airflow e The dispenser is intended to be plugged into a ground fault interrupting receptacle e Do not use an extension cord with your water dispenser e Always grasp plug and pull straight out from outlet Never unplug by pulling on power cord e Do NOT use dispenser if cord becomes frayed or otherwise damaged e To protect against electric shock do NOT immerse cord plug or any other part of dispenser in water or other liquids e Ensure dispenser is unplugged prior to cleaning e Never allow children to dispense hot water without proper and direct supervision Unplug unit to prevent unsupervised use by children e Do not dispense hot water if water bottle is empty e Service should be performed only by a certifi
8. r specific legal rights a purchaser may have other rights depending upon where he or she lives Some jurisdictions do not allow exclusion or limitation of special incidental or consequential damages or limitations on how long a warranty lasts so the above exclusion and limitations may not apply to you Primo Water Corporation 104 Cambridge Plaza Drive Winston Salem NC 27104 866 429 7566 www PrimoWater com TROUBLESHOOTING Water is leaking Unplug dispenser remove bottle and call 866 429 7566 for assistance No water is coming from the spout Make sure the bottle is not empty If empty replace it Make sure to completely depress the pushbutton controls Cold water is not cold It takes up to one hour after setup to dispense cold water Make sure the power cord is properly connected to a working outlet Make sure the back of the dispenser is at least 4 inches from a wall and there is free airflow on all 4 sides of the dispenser Make sure green switch on back of dispenser is ON If water still isn t cold please call 866 429 7566 for assistance Hot water is not hot It takes 15 20 minutes after setup to dispense hot water Make sure the power cord is properly connected to a working outlet Make sure red switch on back of dispenser is ON Nightlight Isn t Working Make sure the power cord is properly connected to a working outlet Make sure nightlight switch on back of dispenser is ON Dispenser Is Noisy Make sure the
9. rms after examination a defect covered by this Limited Warranty in any returned part and if Vendor approves claim Vendor will replace such defective part without charge If you return defective parts transportation charges must be prepaid by you Vendor will return replacement parts to original purchaser freight or postage prepaid The Limited Warranty does not cover any failures or operating difficulties due to accident abuse misuse alteration misapplication improper installation or improper maintenance or service by you or any third party or failure to perform normal and routine maintenance on the dispenser as set out in the User s Manual In addition the Limited Warranty does not cover damages to the finish such as scratches dents discoloration or rust after purchase The Limited Warranty is in lieu of all other express warranties Vendor disclaims all warranties for products that are purchased from seller other than authorized retailers or distributors AFTER THE PERIOD OF THE ONE 1 YEAR EXPRESS WARRANTY VENDOR DISCLAIMS ANY AND ALL IMPLIED WARRANTIES INCLUDING WITHOUT LIMITATION THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE FURTHER VENDOR SHALL HAVE NO LIABILITY WHATSOEVER TO PURCHASER OR ANY THIRD PARTY FOR ANY SPECIAL INDIRECT PUNITIVE INCIDENTAL OR CONSEQUENTAL DAMAGES Vendor assumes no responsibility for any defects caused by third parties This Limited Warranty gives the purchase
10. y bottle out of cabinet 2 Remove probe assembly from empty bottle Place probe on probe hanger 3 Set empty bottle aside 4 Place fresh bottle outside of cabinet Remove entire plastic cap from top of bottle Clean outside of new bottle with a cloth 5 Place probe into bottle Slide collar down until it clicks in place Push head down until tube hits bottom of bottle 6 Slide bottle into cabinet and close door Please visit www PrimoWater com for more useful information instructional videos tips and special offers ea ee ee a a ala LIMITED WARRANTY Primo Water Corporation Vendor warrants to the original purchaser of this dispenser and to no other person that if this dispenser is assembled and operated in accordance with the printed instructions accompanying it then for a period of one 1 year from the date of purchase all parts in such dispenser shall be free from defects in material and workmanship Vendor may require reasonable proof of your date of purchase from an authorized retailer or distributor Therefore you should retain your sales slip or invoice The Limited Warranty shall be limited to repair or replacement of parts which prove defective under normal use and service and which Vendor shall determine in its reasonable discretion upon examination to be defective Before returning any parts you should contact Vendor s Customer Service Department using the contact information listed below If Vendor confi

User`s Manual - Primo Water Store

Contents

Download Pdf Manuals

Related Search

Related Contents