Assembly & User Instructions 4kW Table Top Patio Heater Assemb
Contents
1. Assembly amp User Instructions 4kW Table Top Patio Heater These instructions are for your safety Please read them thoroughly before use and retain them for future reference Parts Supplied mae pone ano Base Weight 7 Upper Lantern Guard 3 Decorative Support Pole Cup 5 Lantern Guard j H Lantern and Gas Hose Fixings Supplied Ret Deser Description ustration ty ema bait x 32 M6 3 Bolt Washer C M6 Nut E M4 x6 3 Screw M6 Dome Spring Head Nut Washer Tools required Not supplied e Spanner Philips Head Screwdriver Before You Start e Check the contents of the box and make sure you have all the parts and fittings listed If not contact your the Helpline 00 353 1 2873797 who will be able to help you e When you are ready to start make sure that you have the right tools at hand plenty of space and a clean dry area for assembly Assembly e Please lay out all nuts and bolts and check lengths before assembly It is recommended that the carton is cut open and spread out on the floor and used as a protective surface during assembly Refer to the assembly diagrams as necessary e Important while every precaution has been made in the manufacture of this product care must be taken during assembly in case sharp edges are present Assembly step 1 O Spring i Washer F Base Weighted Support M6 x32 M6 Nut Base Plate Pole Bolt A B Wes D Hold weight int2. ces of heat or ignition Do not let children tamper with the bottle Service If your heater needs maintenance or is not working properly please contact your local authorized agent for service It is a necessity to contact an authorized source for replacement of parts and or servicing This work must be carried out by a qualified gas technician Spare parts may be obtained by using the helpline stated in this manual WARNINGS e This product is for OUTDOOR USE ONLY NEVER use indoors in an enclosed area or below ground level e This appliance is intended for use with LPG bottled gas only A regulator of 37mbar for Propane gas must be used e This appliance has been supplied with a PROPANE REGULATOR only use with Propane gas NEVER use an adjustable regulator with this appliance e This appliance features a flame failure and tilt device In the event of a wind blowing the flame out or the unit being tipped over the gas supply will be cut off from the cylinder In this event the knobs should be set to off and you should wait 3 minutes before re lighting Failure to read and follow these instructions could result in serious injury or damage to property This product will become hot when in use take care when touching Keep children and pets at a safe distance from the unit when in use DO NOT move this product when in use Any modification of this appliance may be dangerous DO NOT use heater where the reflector i
3. e and try again Do not continuously hold the dial in as you may cause a build up of gas In windy conditions shield from wind to ensure easy lighting Turn control dial to high or low flame position as required Correct operation of the burner is indicated by a predominantly blue quiet flame To Turn Off Push dial in and turn to position O Turn the gas off and disconnect at the cylinder when not in use NOTE It is normal for the heater to smoke during the first few minutes of use Care and Maintenance e Regularly clean your patio heater between uses and especially after extended periods of storage e Ensure the heater control is turned fully to the off position the gas supply is shut off at the regulator or bottle cylinder valve and the heater and its components are sufficiently cool before cleaning Never douse the heater with water when its surfaces are hot We recommend that servicing of this appliance should be performed either after every 100 hours of use or annually which ever is achieved soonest Fixings All screws and bolts etc should be checked and tightened on a regular basis Storage Do not leave the patio heater exposed to outside weather conditions or stored in damp moist conditions The heater should never be operated without the reflector in place If the heater is to be stored indoors the gas bottle must be disconnected and left outside in a dry well ventilated area away from any sour
4. eater is not suitable for use with plastic tables In the interest of safety we recommend that this table top heater should only be used with tables having a minimum diameter or width of 90cm For use outdoors and in amply ventilated areas An amply ventilated area must have a minimum of 25 of the surface area open The surface area is the sum of the walls surface e The appliance must be installed in accordance with instructions and local regulations e The use of this appliance in an enclosed area can be dangerous and is prohibited Gas category I3p Technical Data CE Approval 0086 Specifications are subject to change without prior notice Manufactured by Universal Innovations Kilcoole Ind Est Kilcoole Co Wicklow Ireland Keep these instructions for future reference
5. esigned to be used with patio heaters e Ensure the heater is at a safe distance from glass and PVC doors and windows to stop damage from any heat build up Read the warning and instructions use before operation The table surface may get very warm take care with glass and fine wood tables We recommend the use of table cloth or similar to protect such surfaces e The guard on this appliance is there to reduce the risk of a fire or injury only use the heater with the guarding in place Take care when in use as the guard will get hot DO NOT leave your patio heater uncovered when not in use Store your appliance in a shed or garage when not in use to protect against the effects of extreme weather conditions particularly if you live near coastal areas Prolonged exposure to sunlight standing water sea air saltwater can all cause damage to your appliance A cover may not be sufficient to protect your appliance in some of these situations CAUTION e Regularly clean your patio heater after every use If you smell gas turn off the appliance and extinguish all flames If the odour continues immediately contact your gas supplier In the event of an uncontrollable fire immediately disconnect the gas cylinder moving it away from fire and contact the fire services DO NOT PUT YOURSELF AT RISK Ensure aerosols are not used near this unit when in use Ensure all packaging and plastic bags are disposed of safely This table top h
6. o position from under side of base as shown Fix support pole to Secure bolt base and weight using with nut and 3 fixing bolts nuts and washers as washers provided illustrated A B D F M6 Washer D O Spring Washer F M6 x 32 Bolt A Assembly step 2 Cm Lower pole cap Slide lower pole cap down pole and rest on base Assembly step 3 Lower guard Slide lower guard over support pole Lower Guard Support Pole Assembly step 4 Regulator Lantern Gas Hose Gas hose Using snap connector connect First fix the long gas hose the short gas hose to gas hose to lantern and secure already attached to heater Fit tightly the regulator onto the end of gas Feed the gas hose down pipe through the support pole as illustrated in the diagram Assembly step 5 To check patio heaters for leaks To be performed in a well ventilated area Lie heater down on the floor as shown below Confirm all control knobs are in the off position Open the gas control valve on the bottle or regulator Check for leaks by brushing a solution of 1 2 water and 1 2 soap over the gas system joints as shown in the hose connection and regulator connection NEVER USE AN OPEN FLAME to test for leaks at any time If bubbles form over any of the joints there is a leak Turn off gas supply and retighten all joints Repeat test If bubbles form again do not use the patio heater Please c
7. ontact your local gas dealer for assistance or the helpline stated in this manual Leak test annually and whenever the gas bottle is removed or replaced Assembly step 6 M4x6 Screw E Secure lantern to support pole with 3 screws provided Assembly step 7 Slide lower guard up pole through slots in metal lip of lantern and rotate to secure in position as shown Assembly step 8 N M6 Nut Parasol B Place parasol into position aligning the three holes in the parasol with the three bolts in the burner head and secure with 3 M6 nuts Ensure lower guard wire extensions are located in parasol outer rim holes Parasol Outer Rim Wire Extensions Assembly step 9 Upper guard M6 Dome Head Nut C Place upper guard onto parasol and secure with 3 dome head nuts provided see fig a Leak Testing To be performed in a well ventilated area Confirm all control knobs are in the off position Open the gas control valve on the bottle or regulator Check the leaks by brushing a solution of 1 2 water and 1 2 soap over the gas system joints including all valve connections hose connections and regulator connections NEVER USE AN OPEN FLAME to test for leaks at any time If bubbles form over any of the joints there is a leak Turn off gas supply and retighten all joints e Repeat test If bubbles form again do not use the patio heater Please contact yo
8. s within 1 5m of any flammable structure or surface NEVER operate the heater with the top half covered burner head reflector etc DO NOT leave this product unattended when in use e Always keep the cylinder level and vertical when positioning inside the base ONLY use this appliance on a flat LEVEL non flammable surface or ground Positioning ensure the unit is a minimum of 1 5metres from flammable items or structure from all sides and above Always leak test the unit before use annually or after storage when parts are replaced serviced or if the gas cylinder is removed or replaced When storing the appliance or gas cylinder ensure they are away from flammable materials or liquids e Regularly check that the regulator seal and hose is fitted and that it is in good condition Replace parts if necessary The gas cylinder must not be stored next to this or any other appliance Always follow the care and maintenance instructions regularly maintain your appliance Always replace worn parts do not use the appliance if a leak wear or damage is found DO NOT store or cover the appliance until fully cooled e Always shut off the valve at the gas cylinder or the regulator before moving the appliance In the event of high winds particular attention must be taken Store the unit away or ensure it is ata safe distance from other items in the event that the unit is blown over e Only use with gazebo s specifically d
9. turned off at the regulator or bottle cylinder valve and there are no sources of ignition cigarettes open flame sparks etc near before proceeding e Hose which can be used with this heater must conform with BS3212 or similar Ensure that the hose bore and regulator are compatible The hose should be secured to the regulator nozzle using a jubilee clip or similar Inspect the gas hose to ensure it is free from any twisting or tension The hose should hang freely with no bends folds or kinks that could obstruct free flow of gas Always inspect the hose for cuts cracks or excessive wear before use If the hose is damaged it must be replaced with hose suitable for use with LPG and meet the national standards for the country of use N B The date on U K orange hose is the date of manufacture not the expiry date Connecting to the cylinder Confirm all control knobs are in the off position Connect the regulator to the gas bottle according to your regulator and bottle dealers instructions Use Instructions Before proceeding make sure you understand the warnings section of this manual Lighting instructions Turn on gas supply at cylinder e Push dial in and turn to position e While dial is held pressed in at position press spark button repeatedly to ignite the burner Hold dial in for at least 10 seconds to ensure heater stays lit If burner does not light after holding dial in for 20 seconds wait 1 minut
10. ur local gas dealer for assistance or the helpline stated in this manual Leak test annually and whenever the gas bottle is removed or replaced Gas and Regulator This appliance is for propane use only e See instructions supplied with regulator for correct use and attachment Propane bottles normally red coloured or patio gas green in the UK or patio gas grey in Ireland will supply gas all year round even on cold winter days We recommend a bottle size of 13kg for use with this appliance in the UK Gas bottles should never be stored on their side e Never store gas bottles indoors Suitable propane regulators must have an outlet pressure of 37mbar This appliance is supplied with a propane regulator which must only be used for propane gas NEVER use an adjustable regulator with this appliance Please consult your gas dealer for the most suitable gas bottles for your regulator Siting Instructions e This appliance is for OUTDOOR USE ONLY and should be placed in a well ventilated area A well ventilated area must have a minimum of 25 of its surface area open Surface area is defined as the total surface of the walls surface Take care that it is not placed UNDER any combustible surface The sides of the appliance should NEVER be closer than 1 5 metres from any combustible surface Keep this appliance away from any flammable materials Should you need to change the gas bottle confirm the gas supply is
Download Pdf Manuals
Related Search