IMPORTANT SAFEGUARDS CONSIGN
Contents
1. 9 Set the Fabric Select Dial to MIN unplug the iron and allow it to cool 1 Year Limited Warranty Sunbeam Products Inc doing business as Jarden Consumer Solutions or if in Canada Sunbeam Corporation Canada Limited doing business as Jarden Consumer Solutions collectively JCS warrants that for a period of one year from the date of purchase this product will be free from defects in material and workmanship JCS at its option will repair or replace this product or any component of the product found to be defective during the warranty period Replacement will be made with a new or remanufactured product or component If the product is no longer available replacement may be made with a similar product of equal or greater value This is your exclusive warranty Do NOT attempt to repair or adjust any electrical or mechanical functions on this product Doing so will void this warranty This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable Keep the original sales receipt Proof of purchase is required to obtain warranty performance JCS dealers service centers or retail stores selling JCS products do not have the right to alter modify or any way change the terms and conditions of this warranty This warranty does not cover normal wear of parts or damage resulting from any of the following negligent use or misuse of the product use on improper voltage or current use2. 2012 Sunbeam Products Inc faisant affaire sous le nom de Jarden Consumer Solutions Tous droits r serv s Import et distribu par Sunbeam Corporation Canada Limited faisant affaire sous le nom de Jarden Consumer Solutions 20 B Hereford Street Brampton Ontario L6Y 0M1 Printed in China Imprim en Chine GCSBBV212_12EFM1 GCDS SUN26922 ZZ
3. 20 Volt AC outlet 3 Turn the large Fabric Select Dial to the fabric setting you desire Allow the iron to heat for 2 minutes While the iron is heating make sure it is sitting on its heel rest on a stable protected surface NOTE While the Steam Dial is turned to the Dry setting you may still use the Shot of Steam or Spray Mist feature as long as the Fabric Select Dial is set to wool cotton or linen Please make sure the water reservoir is approximately 1 4 full of water STEAM IRONING 1 Follow the instructions for Filling the Water Reservoir 2 Plug the cord into a 120 Volt AC outlet 3 Turn the Fabric Select Dial to the fabric setting you desire Allow the iron to heat for 2 minutes While the iron is heating make sure it is sitting on its heel rest on a stable protected surface IMPORTANT When not ironing always set the Steam Lever to Dry and the Fabric Select Dial to MIN USING THE IRON s SPECIAL FEATURES SPRAY Mist FEATURE is a powerful water spray mist that dampens the fabric to aid in removing wrinkles from heavy fabrics and for setting creases TO USE THE SPRAY MUST FEATURE Press the Spray Mist button firmly SHOT OF STEAM FEATURE provides an extra burst of steam for deep penetration of stubborn wrinkles You can use this feature while Dry or Steam ironing as long as the Fabric Select Dial is set to wool cotton or linen The water reservoir must be approximately 4 full of water TO USE THE
4. SHOT OF STEAM FEATURE Place the iron on top of the wrinkle and press the Shot of Steam button each time you would like an extra burst of steam The Shot of Steam feature may be used continuously in approximately 3 second intervals VERTICAL STEAM allows your iron to function as a garment steamer TIP When using vertical steam on clothing hang the clothing on a clothes hanger for best results Hanging curtains and drapes may also be steamed To USE VERTICAL STEAM 1 Make sure that the iron has heated up 2 minutes 2 Hold the iron in a vertical position with the iron close to but not touching the fabric you want to steam 3 With your other hand pull the fabric tight 4 Press the Shot of Steam button in approximately 3 second intervals as you move the iron across the wrinkled area WARNING To prevent the risk of burns keep your hand away from the area being steamed WARNING DO NOT steam garments while wearing them this may result in injuries MOTION SMART AUTO OFF FEATURE When the iron is plugged in the Power Indicator will light steadily indicating that there is power to the iron IF YOU LEAVE THE IRON e in a horizontal position without moving it or accidentally tip the iron over it will automatically stop heating after 30 seconds The Power Indicator will blink to let you know that the iron has stopped heating e in a vertical position on its heel rest without moving it the iron will automatically
5. afety feature SAVE THESE INSTRUCTIONS FEATURES OF YOUR CLASSIC IRON 1 Spray Mist Release 2 Covered Water Fill Hole 3 Steam Dial 4 Spray Mist Button 5 Shot of Steam Button 6 Power Indicator Light 7 360 Tangle Free Swivel Cord 8 Fabric Select Dial 9 Maximum Fill Line 10 Self Clean Button 11 See Through Water Reservoir 12 Soleplate Visit www sunbeam ca for an Ironing Guide and Ironing Tips Voyez le guide et les conseils de repassage au www sunbeam ca CARACTERISTIQUES DU FER CLASSIQUE 1 Orifice d atomisation 2 Orifice de remplissage a volet 3 Variateur de vapeur 4 Bouton d atomisation 5 Bouton de survapeur Shot of Steam 6 Voyant d alimentation 7 Cordon articul 360 non emm lant 8 Cadran de s lection des textiles 9 Rep re de remplissage maximal 10 Bouton d autonettoyage 11 R servoir translucide 12 Semelle To FILL THE WATER RESERVOIR use tap water 1 Make sure the iron is unplugged Set the Steam Dial to 4 Dry and the Fabric Select Dial to MIN 2 Lift the Water Fill Hole Cover 3 Fill an easy pour measuring cup with tap water and pour water into iron water reservoir Do not fill water reservoir beyond maximum fill level WARNING To prevent the risk of burns be careful when filling a hot iron with water Hot metal parts hot water and steam can cause injuries Dry IRONING 1 Make sure the Steam Dial is turned to the Dry setting 2 Plug the cord into a 1
6. contrary to the operating instructions disassembly repair or alteration by anyone other than JCS or an authorized JCS service center Further the warranty does not cover Acts of God such as fire flood hurricanes and tornadoes What are the limits on JCS s Liability JCS shall not be liable for any incidental or consequential damages caused by the breach of any express implied or statutory warranty or condition Except to the extent prohibited by applicable law any implied warranty or condition of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty JCS disclaims all other warranties conditions or representations express implied statutory or otherwise JCS shall not be liable for any damages of any kind resulting from the purchase use or misuse of or inability to use the product including incidental special consequential or similar damages or loss of profits or for any breach of contract fundamental or otherwise or for any claim brought against purchaser by any other party Some provinces states or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts so the above limitations or exclusion may not apply to you This warranty gives you specific legal rights and you may also have other rights that vary from province to province state to state or jurisdiction to jurisdict
7. dren Do not leave the iron unattended while the iron is connected or on an ironing board e Burns can occur from touching hot metal parts hot water or steam Use caution when you turn a STEAM IRON upside down there might be hot water in the reservoir e In the event the iron is not operating properly disconnect the iron from the electrical outlet and have the iron serviced by qualified service personnel e This iron must not be left unattended while it is connected to the supply mains e The iron must be used and rested on a stable surface e The iron is not to be used if it has been dropped if there are visible signs of damage or if it is leaking e To reduce the risk of contact with hot water emitting from steam vents check appliance before each use by holding it away from body and operating steam button e To avoid a circuit overload do not operate another high wattage appliance on the same circuit e If an extension cord is absolutely necessary a 15 ampere cord should be used Cords rated for less amperage may overheat Care should be taken to arrange the extension cord so that it cannot be pulled or tripped over To reduce the risk of electrical shock this appliance has a polarized plug one blade is wider than the other This plug fits a polarized outlet only one way if the plug does not fit fully into the outlet reverse the plug If it still does not fit contact a qualified electrician Do not attempt to defeat this s
8. ion How to Obtain Warranty Service In the U S A If you have any question regarding this warranty or would like to obtain warranty service please call 1 800 458 8407 and a convenient service center address will be provided to you In Canada If you have any question regarding this warranty or would like to obtain warranty service please call 1 800 667 8623 and a convenient service center address will be provided to you In the U S A this warranty is offered by Sunbeam Products Inc doing business as Jarden Consumer Solutions located in Boca Raton Florida 33431 In Canada this warranty is offered by Sunbeam Corporation Canada Limited doing business as Jarden Consumer Solutions located at 20 B Hereford Street Brampton Ontario L6Y 0M1 If you have any other problem or claim in connection with this product please write our Consumer Service Department PLEASE DO NOT RETURN THIS PRODUCT TO ANY OF THESE ADDRESSES OR TO THE PLACE OF PURCHASE For product questions Sunbeam Consumer Service USA 1 800 458 8407 Canada 1 800 667 8623 www sunbeam ca 2012 Sunbeam Products Inc doing business as Jarden Consumer Solutions All rights reserved Imported and distributed by Sunbeam Corporation Canada Limited doing business as Jarden Consumer Solutions 20 B Hereford Street Brampton Ontario L6Y 0M1 Pour les questions de produit Sunbeam Consumer Service Canada 1 800 667 8623 Etats Unis 1 800 458 8407 www sunbeam ca
9. ions above Clean the soleplate if starch or other residue accumulate TO CLEAN THE SOLEPLATE allow the iron to cool and then wipe it with a soft damp cloth WARNING DO NOT use abrasive cleansers scouring pads or vinegar to clean the soleplate This will damage the finish Run the iron over an all cotton cloth to remove any residue USING THE SELF CLEANING FEATURE You should use the Self Cleaning feature once a month to maintain the optimal performance of your iron TO USE THE SELF CLEANING FEATURE Turn off iron following instructions above 1 Fill the water reservoir with tap water to the MAX line 2 Plug in the iron set the Fabric Select Dial to Linen and allow the iron to heat for 2 minutes 3 Unplug the iron 4 Hold the iron over a sink in a horizontal position WARNING Be careful not to touch the iron s hot surfaces 5 Press the Self clean Button and hold Water will begin dripping from the steam vents Slowly rock the iron side to side and front to back for 30 seconds When rocking the iron dip the nose of the iron slightly below the rear of the iron to make certain the water circulates completely Release the Self clean Button after one minute 6 Open the fill cap turn the iron upside down and allow the remaining water to flow out of the fill hole 7 Dry the soleplate with a towel 8 Plug in the iron and set the Fabric Select Dial to Linen Let the iron heat for 2 minutes to dry out the iron completely
10. turn off after 15 minutes The Power Indicator will blink to let you know that the iron has stopped heating IMPORTANT The Power Indicator will continue to blink until the iron is unplugged or reset TO RESET THE IRON Move the iron back and forth and allow it to reheat for 2 minutes The indicator will stop blinking and the iron will start heating again WARNING Motion Smart Auto Off is a safety feature not a recommended means for turning your iron off See Caring for Your Iron After Use for information on turning off your iron and storing it safely between use CARING FOR YOUR IRON AFTER USE TURNING OFF YOUR IRON Turn the Steam Dial to Dry and Fabric Select Dial to MIN and unplug the iron from the power source WARNING NEVER yank the power cord when unplugging the iron This can damage the cord STORING YOUR IRON 1 Turn off iron following instructions above Allow the iron to cool 2 If you do not use your iron on a daily basis empty the water reservoir after each use for a longer iron life To do so unplug the iron turn the iron upside down open the fill hole cover and allow water to flow from the fill hole Shake the iron gently to remove trapped water drops 3 Loosely loop the power cord around the heel rest and store the iron on its heel rest IMPORTANT Wrapping the cord around the iron too tightly can damage the cord MAINTAINING YOUR CLASSIC IRON CLEANING THE SOLEPLATE turn off iron following instruct
11. unbeam Instruction Manual Classic Iron Notice d emploi Fer repasser classique MODEL www sunbeam ca P N 162773 IMPORTANT SAFEGUARDS When using electrical appliances basic safety precautions should always be followed including the following READ ALL INSTRUCTIONS BEFORE USE e Only use an iron for its intended use e To avoid the risk of electric shock do not immerse the iron in water or other liquids e Always turn the iron to Off before plugging or unplugging the iron from the electrical outlet Never pull on the cord to disconnect the iron from the electrical outlet instead grasp the plug and pull on the plug to disconnect the iron e Do not let the cord touch hot surfaces Let the iron cool completely before putting the iron away Coil the cord loosely around the iron when storing e Always disconnect the iron from the electrical outlet before filling the iron with water emptying the water from the iron and when the iron is not in use e Do not operate the iron with a damaged cord or in the event the iron has been dropped or damaged To avoid the risk of electric shock do not disassemble or attempt to repair the iron Take it to a qualified service center for examination and repair Incorrect assembly or repair might result in a risk of electric shock a risk of fire or injury to person when the iron is used after reassembly or repair e Close supervision is required for any appliance used by or near chil
Download Pdf Manuals
Related Search