23914-01a - Tanning Bed Parts
Contents
1. secure it to the canopy To remove the Silk screened Profile pull it back from the bottom like when you remove the acrylic so it swings open Use the flat tool to pry the profile away from the aluminum frame from the top as shown in the lower picture at right As the top is pulled away the profile will fall off of the frame Now take the new Silk screened Profile that indi cates SPEED 205 lamps and look at it from the end You will notice it has a hook and an S shape see illustration below Slip the hook into the slot in the aluminum frame and press the S shape over the ridge until it snaps tight Snap the profile back over the acrylic Reattach the handle Press the trim profile back into place ALUMINUM FRAME PROFILE2. extends to the ballasts located in your sunbed The ballasts labeled SPEED 175 system are fully compatible with the new lamps The labeling provided on the updated profile has been reproduced on the back of this letter to satisfy the requirements set out in 21 CFR 1040 20 e i This upgrade is voluntary and may be performed if the sunbed owner desires If you choose not to upgrade your eguipment rest assured that it is still fully FDA compliant as originally manufactured Office of Regulatory Affairs Spectrum Products Inc Common to all units RECOMMENDED EXPOSURE TIMES IN MINUTES MAXIMUM EXPOSURE TIME IS 20 MINUTES Level 1 Week 1 Subsequent Skin Type 1st 3rd sessions Level 2 Level 3 Level 4 Maximum I Sensitive Skin Bums easily and severely and does not tan NOT RECOMMENDED FOR TANNING H Light Bums easily and severely and tans minimally 4 8 12 16 20 III Normal Bums moderately and tans average 6 10 15 20 20 IV Dark Bums minimally tans easily and above average 8 12 16 20 20 for models using wire grid in place Untanned persons should not tan on consecutive days during their first week of tanning Never tan more than once a day Tanning normally appears after the first few sessions and maximizes after approximately four weeks Tan once or twice per week thereafter to maintain appear ance Persons already having a base tan may begin atadvanced levels corresponding to the extent of their base tan WARNING Read t
3. 3045 SolarMax IFT facial unit lamps THIS PRODUCT IS IN CONFORMITY WITH PERFORMANCE STANDARDS FOR SUN LAMP PRODUCTS UNDER 21 CFR PART 1040 20 SunStar ZX30 3F SPEED system SunStar ZX32 3F SPEED system DANG E Ultraviolet radiation Follow instructions Avoid overexposure As with natural sunlight overexpo sure can cause eye and skin injury and allergic reactions Repeated exposure may Cause premature aging of the skin and skin cancer WEAR PROTECTIVE EYEWEAR FAILURE TO MAY RESULT IN SEVERE BURNS OR LONG TERM INJ URY TO THE EYES Medications or cosmetics may increase your sensitivity to the ultravio let radiation Consult physician before using sunlamp if you are using medications or have a history of skin problems or believe yourself especially sensitive to sunlight If you do not tan in the sun you are unlikely to tan from the use of this product To use lie down under the canopy and pull down as far as adjustment will allow Minimum use distance from face tanner If Equipped is Linch or 2 5 centimeters Minimum use distance elsewhere is touching the clear plastic panels Do not use without clear plastic panels or wire grid Replacing the Silk screened Profile is a fairly simple operation You will need a flat blunt tool a putty knife works great and a Phillips screwdriver First pry the front trim profile off of the sunbed canopy as shown at right Next remove the han dle by unscrewing the three Phillips screws that
4. Official SPEED 205 Re certification Notice 23914 01A October 12 2000 Re Re certification of the SUNSTAR ZX30 and ZX32 SPEED system sunbeds Dear Salon Owner Thank you for purchasing the SPEED lamp upgrade kit This letter will serve as the official re certification notice from the manufacturer of your sunbed Please retain this letter keeping it with your sunbed s original user manual State or local inspectors may ask to see it All SunStar ZX30 and SunStar ZX32 series SPEED system sunbeds have been re certified to allow the use of the SPEED 205 Wolff Model SPD71 T 12 205 Bi Pin lamp in the sunbed s canopy Included with this letter you will find a new white Quick Clip profile that has the new certification wording silk screened onto it Please remove the existing profile from your sunbed following the instructions attached and replace it with the new one provided The sunbeds included in the re certification were originally labeled SUNSTAR ZX30 SPEED system SUNSTAR ZX30 SPEED 175 system SUNSTAR ZX30 3F SPEED system SUNSTAR ZX30 3F SPEED 175 system SUNSTAR ZX32 SPEED system SUNSTAR ZX32 SPEED 175 system SUNSTAR ZX32T SPEED system SUNSTAR ZX32T SPEED 175 system SUNSTAR ZX32 3F SPEED system SUNSTAR ZX32 3F SPEED 175 system Please note that the notation SPEED 175 system has been changed to SPEED system to allow for the lamp upgrade This notation change
5. he instructions booklet before using this sunlamp product All persons in the room should wear protective eyewear when lamps are on Recommended eyewear Provided eyeshields Lucas Products Super Sunnies or Intrexco No 5635 1 or equivalent eyewear as defined under 21 CFR 1040 20 Other types of eyewear may not pro vide adequate protection Disconnect power cord before attempting to clean relamp or engage in the maintenance of this product ONLY THE FOLLOWING LAMPS HAVE BEEN CERTIFIED FOR USE IN THIS EQUIPMENT SPEED 175 Wolff Model SPD75 T12 Bi Pin Bench Only SPEED 205 Wolff Model SPD71 T12 205 Bi Pin canopy Only SunStar ZX30 SPEED system SunStar ZX32 SPEED system THIS PRODUCT IS IN CONFORMITY WITH PERFORMANCE STANDARDS FOR SUN LAMP PRODUCTS UNDER 21 CFR PART 1040 20 ONLY THE FOLLOWING LAMPS HAVE BEEN CERTIFIED FOR USE IN THIS EQUIPMENT SPEED 175 Wolff Model SPD75 T12 Bi Pin Bench Only SPEED 205 Wolff Model SPD71 T12 205 Bi Pin canopy Only Turbo Sun S Wolff Model F8 T5 LOW turbo Face Lamps SunStar ZX32T SPEED system THIS PRODUCT IS IN CONFORMITY WITH PERFORMANCE STANDARDS FOR SUN LAMP PRODUCTS UNDER 21 CFR PART 1040 20 ONLY THE FOLLOWING LAMPS HAVE BEEN CERTIFIED FOR USE IN THIS EQUIPMENT SPEED 175 Wolff Model SPD75 T12 PREHEAT BIPIN Bench lamps SPEED 205 Wolff Model SPD71 T12 205 BIPIN canopy lamps Heraeus E400 HPT Philips Model HPA 400 30s or CosmoTech Model 2
Download Pdf Manuals
Related Search