Manual
Contents
1. INSTRUCTIONS FOR USE Pro Ject Head Box SE ll Dear music lover thank you for purchasing a PRO JECT AUDIO headphone amplifier With this unit you can connect up to two headphones to your amplifier and adjust their volume individually In order to achieve maximum performance and reliability you should study these instructions for use carefully V Warning of a hazard for the user the unit or possible misuse neg Important notice Connection to the amplifier recorder Connect the TAPE OUT RCA phono sockets from your amplitier to the In RCA phono sockets of the headphone amplifier The Out RCA phono sockets of the headphone amplifier can be connected to the input sockets of your recorder Take care to connect the left and right channels correctly The right channel is usually marked red the left channel black or white fa gt Right Left Out 16V Out Power C In In Connecting the headphones Connect the headphones to the 1 4 jack socket marked Phones 1 or Phones 2 on the front of the headphone amplifier Use the Volumel and Volume2 control knobs to adjust the level to the required volume Two sets of headphones may be used in parallel di Project Head Box SE II O O 4 0 Volume 1 Phones 1 Phones 2 Volume 2 lt _ Turn the volume level to minimum before connecting the headphones Minimum impedance of the head phone both head phones 30ohms Headphone replay Use2. te or identify despite the above information please contact your dealer for further advice Only when the problem cannot be resolved there should the unit be sent to the responsible distributor in your country Warranty The manufacturer accepts no responsibility for damage caused by not adhering to these instructions for use Modification or change to any part of the product by unauthorized persons release the manufacturer from any liability over and above the lawtul rights of the customer PRO JECT is a Registered Trademark of H Lichtenegger The information was correct at the time of going to a press The manufacturer reserves the right to make This guide was produced by Audio Trade GmbH changes to the technical specification without prior Copyright 2007 All rights reserved notice as deemed necessary to uphold the ongoing process of technical development Audio Trade GmbH Pro Ject Head Box SE Il Revision 1 4 07 1 4 07 3
3. the input selector of the amplifier to choose the source you wish to hear 2 Audio Trade GmbH Pro Ject Head Box SE Il Revision 1 4 07 1 4 07 Mains power connection The headphone amplifier is supplied with a power supply suitable for your country s mains supply Check the label before connecting to ensure compliance with the mains rating in your house Connect the low voltage plug from the power supply to the socket Power 16V before connecting the power supply to the mains Technical specifications Pro Ject Head Box SE Il Power output 700mW 300hms 110mW 3000hms Headphone connection gt 300hms Signal to noise 110dB 115dB A weighted at full output Frequency response 20Hz 20kHz 0 03dB THD IMD 0 003 300hms 0 007 3000hms Gain 12dB Headphone jacks 3 pole 4 6 3mm phono socket Power supply type Mains fed outboard power supply Output voltage 16V 1 000mA AC Power consumption 16V 230mA AC Dimension W x H x D 103 x 72 x 151mm Weight 1 080g without power supply Potential incorrect use and fault conditions No signal on one or both channels No connection between headphone and headphone amplifier ore amplifier This could be due to a faulty plug broken wire or solder joint or simply loose plug socket connection Headphone does not work Headphone volume control is at minimum Amplifier Tape Monitor circuit is not activated Service Should you encounter a problem which you are not able to allevia
Download Pdf Manuals
Related Search