Panel Heater User Manual - Hygiene Supplies Direct Limited
Contents
1. REMOVE ALL PACKAGING MATERIALS FROM THIS PRODUCT BEFORE USING IT TECHNICAL CHARACTERISTICS Models covered by this instruction guide LEVPHS5OOT 500W c w thermostat amp timer Suggested room size 7 9m Dimensions 388 x 294 x 52mm LEVPH1500T 1500W c w thermostat amp timer Suggested room size 17 20m Dimensions 963 x 294 x 52mm LEVPH1000T 1000W c w thermostat amp timer Suggested room size 12 14m Dimensions 677 x 294 x 52mm e LEVPH2000T 2000W c w thermostat amp timer Suggested room size 20 28m Dimensions 1308 x 294 x 52mm Voltage 240V 50Hz IMPORTANT Read these instructions fully before using the heater Please retain these instructions for future reference Make sure that the voltage stated above corresponds with the voltage in your home This quality product has been tested and certified to meet all applicable UK electrical and safety standards For safety reasons this panel heater must not be used until it has been properly installed If in any doubt please consult a qualified electrician INSTALLATION Carefully select a suitable mounting position on a wall near to a main power outlet allowing sufficient free space around the heater as per fig 4 fig 1 fig 2 Clip oo0oo0oo0000000 oOo0oo0oo0000000 oo0oo0oo0oo000000 Mounting Bracket Fix the mounting bracket to the wall via the four fixing holes using wall plugs amp screws Remove the mounting bracket from the h2. Using the Timer Control Turn the clock dial clockwise until the correct time aligns with the pointer Raise the time segments for the required on off times and set the control switch to timer controlled CARE CLEANING amp REPAIRS Care amp Cleaning Make sure that the heater is unplugged from the mains and is cool before you attempt to clean it Wipe with a dry cloth to remove dust or with a damp not wet cloth to clean stains Ensure that no moisture gets into the heater Do not use abrasive cleaning powder metal polish or furniture polish on any part of the heater Do e Do read the instructions carefully e Do disconnect the heater from the mains supply when not in use or being cleaned e Do position close to but not directly beneath a suitable mains outlet e Do store in a cool and dry place when not in use Don t e Do not use outdoors for indoor use only e Do not position immediately below a fixed socket outlet e Do not position close to furniture or curtains where it might create a fire hazard e Do not position in the immediate surrounding of a bath shower or swimming pool e Do not cover or restrict the air inlet or heat outlet vents e Do not position the heater closer than 500mm to any overhanging surface e Do not strain the mains lead e Do not position the mains lead where it will cause anybody to trip over it e Do not use the heater lying on its back front or sides e Do not run the mains lead und
3. ature above freezing
4. eater by pressing inwards on the two clips then pulling the bracket down and away from the heater WARNING DO NOT COVER THIS PRODUCT AS IT MAY OVERHEAT fig 3 fig 4 N N 1 5m N N N N N N 1 0m 2 0m lt lt ge IN 5 Dh N 8 QS N N i Triangular 0 05m N P mark 8 Z N ri IT UMsssdshssdssiddisshsdd 7 Reattach the heater onto the mounting bracket Ensure the bottom hooks are aligned with the slots beneath the two triangular marks Push the heater so the slots lock onto the bracket clips HEATER OPERATION Heater Power Thermostat Timer Control 20 minute Time Segments Outwards Off Inwards On I Temperature Indicator Max Mark Temp l Off On Min Temp Off On Timer Constant Controlled Thermostat Control The convector heater can be adjusted to maintain a constant room temperature by using the thermostat Rotate the control clockwise to turn on and increase the room temperature Use along with the timer control setected to on or timer controlled When the room has reached the required temperature the light on the front of the heater will turn off Please note that if the indicator light is not lit when the heater is switched on a Turn the thermostat control clockwise to a higher setting b Ensure that the override switch on the timer is set to the on position Frost Protection Turn the thermostat to the MIN setting for the heater to maintain a temper
5. er carpeting e Do not use with an extension lead as it may overheat e Do not use where excessive moisture is present e Do not allow water to get into the interior of the heater e Do not insert or allow any foreign objects to enter the heater e Do not use in areas where petrol paint or flammable liquids are used or stored e Do not use in workshops or rooms where there are excessive amounts of dust e Do not fit the heater to the walls in rooms where children or invalids may be left unattended Repairs Do not attempt to repair this product yourself Repairs can only be made by qualified service personnel Repairs by unqualified persons will invalidate the guarantee but more importantly could result in accident or injury If this product fails to work properly please return It to your nearest Levant stockist SAFETY OVERHEAT PROTECTION A thermal cut out will switch off the heater if for any reason It overheats if the cut out operates determine the reason for overheating an correct it The cut out resets automatically when the heater cools down This could take 10 20 minutes IF IN DOUBT CONTACT A QUALIFIED ELECTRICIAN CEF0723 October 2008 Issue 1 Levante a al Panel Heater User Manual TA i s eet ra a D a LEVPH500T LEVPH1000T LEVPH1500T 240V 50Hz LEVPH2000T CAUTION PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THIS PRODUCT
Download Pdf Manuals
Related Search