Shift-I Quick Reference Guide V1.01
Contents
1. Hysteresis Warning default Over Voltage 16 0V Off 30 Off Off 5 6 Seconds Seconds 4 ih Minimum a Delay RPM Input Off 3 4 lt gt default Seconds Seconds Refer to the Advanced Settings Manual for more information Make sure the RPM is below 2 200rpm to access the functions and the correct calibration value has been used Copyright Ecliptech Innovations Pty Ltd2. chose the setting to change Start here Shift I Quick Reference Guide V1 01 FEATURES Calibration Value Press and hold both buttons turn ignition on Setting Shift Points Press and hold top button for upper set point Press and hold bottom button for lower set point Display Mode Press up or down to cycle through modes Brightness Adjustment Press both buttons all lights turn on then use buttons to increase or decrease brightness RPM Set Point Interval Press and hold top button turn ignition on Running in Battery Mode Press and hold bottom button turn ignition on Press and hold bottom button turn ignition on To add a0 1V Battery Voltage Calibration offset press amp hold the up button until you see a quick flash of the lights To subtract 0 1V use the bottom button Press and hold both buttons turn ignition on keeping buttons System Reset pressed A few seconds later the lights will flash rapidly indicating reset and you can release the buttons Refer to the Shift I User Manual for more information ADVANCED SETTINGS Advanced Settings Menu gt Press and hold both buttons turn ignition on then press and hold top button Change setting value AN OC Ge i i Mal Shift Sequence Battery Shift q then then Sequence Shift Battery Sequence default q 45 Sea 90 Seconds Seconds Seconds Seconds default Startup Display Auto 350rpm or 25 default
Download Pdf Manuals
Related Search