HDD Enclosure 3.5 Model: DA-70570
Contents
1. HDD Enclosure 3 5 Model DA 70570 BA User Manual 1 0 Hardware Setup Make sure your drive has jumper setting in Master mode Insert the drive to the enclosure and fix it by the screws Connect the USB cable to the enclosure and then to your computer For Windows 7 Vista XP 2000 no driver setup is necessary Connect power supply into HDD Enclosure then switch on the Enclosure Please proceed to step 3 0 to format your drive For Windows 98SE ME proceed to section 2 0 to install the driver 2 0 Driver Installation ONLY necessary for Windows 98 SE ME Windows 98 SE ME please contact www Digitus info for driver download IMPORTANT Each time before unplugging the drive from your computer always stop the hardware from the system tray located at the right bottom corner of your computer screen If you directly pull out the cable without using the STOP operation it may cause data loss or hardware damage 3 0 Format your Hard Drive If the drive already appears in My Computer please skip to 3 2 3 1 For an un partitioned or un formatted new drive it normally does not automatically appear in My Computer the first time Please follow these steps Windows 98 ME 1 Click Start and choose Setting 2 Choose Control Panel 3 Double Click on System then Device Manager 4 Select Disk Drives You will find the new hard disk in the hard drive list 5 Double click on the entr2. initialize your drive Also make sure the drive has enough power by using the double USB ports Q After plugging the cable the drive is not spinning at all or making clicking noise A This usually means the drive is lack of power Try to use two USB ports from the computer to supply power by using the double USB cable Q After installing the drive why it is still recognized as Unknown device A This means the driver installation is not successful please install the driver one more time
3. y for your hard drive select Settings 6 Make sure you check Removable checkbox the default is unchecked 7 Click OK to exit Restart your computer 8 After your computer restarts your new drive will appear in My Computer as a Removable Disk 9 Follow 3 2 to format it Windows 7 Vista XP 2000 1 Right click on My Computer and choose Manage from the drop down list A Window called Computer Management will pop up 2 Click on the Disk Management All connected disk drives will be displayed in the lower right hand corner of the window Carefully locate your new external drive right click on it to initialize your drive create or delete new partitions and or format an existing partition 3 2 Go to My Computer locate the removable disk right click on it and select Format from the drop down list follow the instructions to complete the formatting process Note Using this method to format your drive will result in a single partition in largest drive capacity which is also highly recommended Note For Windows 98 and ME format your drive with FAT32 the ONLY choice For Windows 2000 XP VISTA the default choice is NTFS However you can also choose to format the drive with FAT32 ONLY IF the drive size if smaller or equal to 32GB FAQs Q I can t find the drive under my computer why A Please make sure your drive is set to Master also check section 3 0 to
Download Pdf Manuals
Related Search