MH6-U USER`S MANUAL
Contents
1. installation installation A S tapes N x O a Clean t Y ee Stay bees gt A x Placeof Placeof ThA Top of the 5 steering column cover To install to the A pillar it is a necessary to drill a hole in oil and dust C Wire the A pillar _ When deciding a place for installation make sure to select a Installing to the A piller A place that does not interfere with airbags standard measure ment gauges nor gets in the line of vision XFor details about how to remove the A pillar see the maintenance guide for your model of car A z z Temporarily fasten the stays to the hood and for now fasten to With a marking Actual size of mounting side of hood the location with double sided tape pen make a mark for a wiring hole Affix double sided tape to the bottom of the stays and fasten down A pillar Please use this for making sure the installation position will 4 work properly 65 gt Compatible Gauges All PIVOT Gauges current models eie Remove the hood and tap With the stays still Open holes for the E are ohtha following size can screws fastened remove the stays and for the i Tap screw A pillar wiring wire size that were made in i 7 Drill etc Remove EN Tap screw e e9 Using the holes made in Screw the hood back As you are leadi2. METER HOOD 60 Multi Purpose Type MH6 U eSivor MH6 U As of July 2014 No 3 USER S MANUAL Thank you for purchasing PIVOT METER HOOD 60 Multi Purpose Type MH6 U ETE H D 60 Please read these instructions carefully before installing or using this device Please do not lose this user s guide as you will held liable for the cost of reissuing it Check the contents es Ss d Hood x1 Fastening Stays Tap Screws ae Cm Bolts large Nuts large Double sided Cushion Users auide Flat Black Finishing x2 x2 p ns x2 x2 tapes x2 tape g A If the hood gets dirty please wipe with a soft cloth to remove any dirt Do not use chemical cleansers such as thinner benzene or alcohol With just some double sided tape anyone can mount to Fastening the H a flat surface such as a dashboard 2 ais ome ood X Simple processing is possible to match the mounting surface of Installing with the Double sided tapes dashboard etc choice but for curved surfaces use our Processing Kit A With screws fasten the stays to With a mild detergent or alcohol remove all dirt 1 Decide the Place of Installation the holes and oil from the point of installation lay the wires down in the wire channels and fasten Make a trial installation A piller f Try to choose a flat surface ZLA On the meter hood Tap Dashboard screw down with the double sided tape Tap screw J ote Double sided
3. ng the fasten hood to the onto the stays wires replace the A pillar stays with the screws f cy lap screw Bolt large Stay Stay E Le ael m a i Tap screw Nut large A piller Z Fasten the meter Awa to the meter hood Fasten the supplied cushion tape to the meter case and fix the meter hood The tap screws will make A When cutting away at the bottom of the hood to match the A ridges as they are being shape of the installation surface please take note of the following screwed in but if closed too tightly they may not hold if this happens please use the nuts and washers provided in the kit to securely fasten Move the holes up the same amount that you have cut away N Hole Tap screw Hole Make sure not to cut If you have cut away the side of the hood Stay away too much so that make sure to reopen the screw holes for the bottom of the gauge the stays asher hits the installation point J J Cushion tape Nut small PIVOT CORPORATION 87 3 Shimookada Okada Matsumoto shi Nagano 390 0313 Japan TEL0263 46 5901 http pivotjp com
Download Pdf Manuals
Related Search