PAC8000 8102-HO-IP Analog Output Module with HART, FW
Contents
1. PAC8000 8102 HO IP Analog Output Module GFK 2662A Eight Channel 4 20mA with HART August 2011 Firmware release 2 28 resolves the issues listed below Product Documentation 8000 System Specification Data Sheet PAC8000 SafetyNet Data Sheet 8000 I O 2 2 I O Modules General Purpose and 2 2 Applications Including SafetyNet Instruction Manual INM8100 8000 I O 2x I O Modules 2 1 applications Instruction Manual INM8200 System Specifier s Guide SSG8002 Product documentation can be downloaded from http support ge ip com Release Information Replaces Release 2 26 Updates Modules cannot be field upgraded If the problems listed below are observed in earlier versions of the module contact Customer Service Compatibility PAC8000 Controller firmware version 2 06 or later is recommended for use with the 8102 HO IP Problems Resolved by Release 2 28 Subject Description Channel LEDs not functioning properly If the module is not configured all channels are in deactivated state With the in unconfigured 8102 8104 module module firmware 2 26 the module did not turn OFF channel LEDs for deactivated channels with open circuits Module firmware is updated to turn OFF LEDs for deactivated channels with open circuits An 8102 HO IP module with HART In the presence of noise and when HART communication is enabled the connected may go into fail state module may go to fail mode with log showing CRC er2. ror in configuration Release 2 28 version of the firmware fixes the failures caused by CRC error in configuration HART communication fixes The 2 28 version of firmware detects and handles the responses from the field to indicate busy HART device Also this version of firmware correctly handles the invalid lengths of responses from field device for commands 3 and 33 2 PAC8000 8102 HO IP Analog Output Module GFK 2662A Compliance Information For detailed installation and operating procedures refer to the user manual for the 8102 HO IP module Hazardous Locations Factory Mutual Class 1 Div 2 Groups A B C D hazardous locations with Temperature Code T4 Refer to Control Drawings SCI 701 and SCI 845 ATEX II 3 G Ex nL IIC T4 CSA Class 1 Div 2 Groups A B C D hazardous locations with Non Incendive field terminals Temperature Code T4 Refer to Control Drawings SCI 702 and SCI 846 Applicable Standards FM Approvals Standards FM 3600 FM 3611 FM 3810 ATEX Approvals Standards EN 60079 15 2005 CSA Approvals Standards C22 2 No 0 M91 R 2006 C22 2 No 142 M1987 R 2004 C22 2 No 213 M1987 R 2008
Download Pdf Manuals
Related Search