quadrapaddle signal twin female receiver contact replacement
Contents
1. of 1 5 in lbs sides of the module simultaneously or contacts could be damaged 0 16 Nm 9 Align the square elas sll snr w dite I n NOTE The process shown here uses standard 90 series modules ne MOQUE INEN MENCOMAC TING ME DONT NAFO IHE maUIe The same process is used for modules from other series Figure C i ia i 1 denih NOTE If you are using a hybrid module you may need to 6 Use oe umo OF a TOV nOn MeMmAg SUTE 10 Press le end orme reference the User s Manual for the other contact type for contact into the module extraction instructions 4 2 For more information visit voc com 12 20 122. the pin to fall out CONTACT INSTALLATION INSTRUCTIONS l Remove the module from the receiver frame NOTE For more information concerning the process of removing the module from the receiver frame see module installation and removal instructions in Section 5 of this User s Manual T MODULE MOUNTING SCREW MODULE MOUNTING SCREW T ge 2 56 SCREW 2 56 SCREW Figure A The module is designed with a polarizing feature to make sure the cap is properly aligned TWEEZERS CONTACT BEING REMOVED Figure B Take care to avoid damaging contacts surround ing the one to be removed CONTACT BEING REPLACED 2 Use a Phillips head screwdriver to remove the two 2 56 screws located at the top and bottom of the module Figure A Figure C Ensure the square portion of the contact is aligned with the square opening in the module 3 Insert the el blade pineal the of er eta and ie If an Adapter Pin Part 610 138 117 118 needs to be ie end OF ine MOQUE USING A ee ae ee ee nee installed place the pin into the protruding portion of the is indicated Repeat on the opposite end of the module Figure A contact Part 410 138 100 4 a ei moane ia a anes ac eae Replace the module cap using both hands to push the a et eer ee tle slits pve ie TAREE th separated halves together Replace and tighten the MARU AA une baa ONCE lise Ueto Ope ine module retaining screws to a maximum torque
3. QUADRAPADDLE SIGNAL CONTACTS AND MODULES USER S MANUAL SECTION 4 VIRGINIA PANEL CORPORATION QUADRAPADDLE SIGNAL TWIN FEMALE RECEIVER CONTACT REPLACEMENT PART 610 138 100 610 138 200 TOOLS REQUIRED Phillios Head Screwdriver Flat Blade Screwdriver Tweezers or Needlenose Pliers CONTACT REMOVAL INSTRUCTIONS le Remove the module from the receiver frame NOTE For more information concerning the process of removing the module from the receiver frame see module installation and removal instructions in Section 5 of this User s Manual Use a Phillios head screwdriver to remove the two 2 56 screws located at the top and bottom of the module Figure A Insert the flat blade screwdriver into the slot of the module and pry the end of the module using a twisting motion until visible separation is indicated Repeat on the opposite end of the module Figure A Grasp the module halves and apply force in opposite directions rocking the ends of the module while slightly pulling the top of the module away from the mating bottom section Be sure to open both sides of the module simultaneously or contacts could be damaged Use a pair of tweezers or a small pair of needlenose pliers to grasp the contact Pull the contact out of the module taking care to avoid damaging surrounding contacts Figure B If an Adapter Pin Part 610 138 117 118 needs to be removed it can be taken out at this point by turning the module over allowing
Download Pdf Manuals
Related Search