instructions - Russell Hobbs
Contents
1. button you may have to press it 2 or 3 times to pump water through the system SHOT OF STEAM 24 This works with dry or steam ironing as long as there s water in the reservoir and the temperature is above amp 25 Lift the iron off the fabric then press the amp button 26 It may need 2 or 3 presses to pump water through the system 27 Leave 4 seconds between shots to let the temperature build up DRY IRONING 28 If you re going to be dry ironing for 20 minutes or more empty the reservoir first to avoid spontaneous bursts of steam 29 Set the steam control to amp 30 Wait till the light goes out then start ironing VERTICAL STEAMING 31 Iron hanging clothes hanging curtains and furnishing fabrics 32 Check that there s adequate ventilation behind the fabric otherwise moisture may build up causing mildew 33 Check that there s nothing behind the fabric that may be damaged by the steam 34 Check that pockets turn ups and cuffs are empty 35 Set the temperature control to max set the steam control to amp 36 Hold the iron just off the fabric then press the amp button 37 It may need 2 or 3 presses to pump water through the system 38 Leave 4 seconds between shots to let the temperature build up AFTER USE 39 Set the temperature control to set the steam control to amp 40 Unplug the iron 41 Press the 3 button in fully and hold it in to open the filling2. it to Customer Service Spectrum Brands UK Ltd Fir Street Failsworth Manchester M35 OHS email service russellhobbs com telephone 0845 658 9700 local rate number GUARANTEE Defects affecting product functionality appearing within two years of first retail purchase will be corrected by replacement or repair provided the product is used and maintained in accordance with the instructions Your statutory rights are not affected Documentation packaging and product specifications may change without notice ONLINE www russellhobbs co uk for more products 8 551 170
3. Russell Hobbs h z Russell Hobbs instructions high steam amp button temperature no steam 3 amp y button 3 button control steam control light 7N water inlet eservoir amp QS Se nozzle soleplate steamVents calf Clean Read the instructions keep them safe pass them on if you pass the iron on Remove all packaging before use IMPORTANT SAFEGUARDS Follow basic safety precautions including 1 This appliance must only be used by or under the supervision of a responsible adult Use and store it out of reach of children 2 Don t put the iron in liquid don t use it in a bathroom near water or outdoors amp 3 Route the cable so it can t be tripped over or caught 4 Don t iron clothing while it s being worn you ll scald the wearer 5 Don t touch the soleplate keep away from the steam it emits 6 Don t use the iron in the vicinity of children 7 Use the iron or set it on its heel on a stable level heat resistant surface preferably an ironing board 8 Don t leave the iron unattended while plugged in or while it s standing on the ironing board It could be knocked over 9 Unplug the iron before filling before cleaning and after use 10 Don t fill the iron directly from the tap use the jug 11 Sit the iron upright when you re not ironing while it s cooling and when you store it away 12 Don t fit an attachment or accessory unless we supply it 13 Don t use the iron for any purpose
4. ale agent WIRING INSTRUCTIONS UK plugs only The product must be earthed Earth green yellow It has a 13A BS1362 fuse in a 13A BS1363 plug To replace the plug fit the green yellow wire to or E the blue wire to N and the brown wire to L Fit the cord grip If in doubt call an electrician Don t use a non rewireable plug unless the fuse cover is in place If you Neutral remove the plug dispose of it blue 7 amp ENVIRONMENTAL PROTECTION To avoid environmental and health problems due to hazardous substances in electrical and electronic goods appliances marked with this symbol mustn t be disposed of with unsorted municipal waste but recovered reused or recycled Y SERVICE If you ring Customer Service please have the Model No to hand as we won t be able to help you without it It s on the rating plate usually underneath the product The product isn t user serviceable If it s not working read the instructions check the plug fuse and main fuse circuit breaker If it s still not working consult your retailer If that doesn t solve the problem ring Customer Service they may be able to offer technical advice If they advise you to return the product to us pack it carefully include a note with your name address day phone number and what s wrong If under guarantee say where and when purchased and include proof of purchase till receipt Send
5. other than those described in these instructions 14 Don t scratch the soleplate avoid buttons zips etc 15 The iron has a thermal fuse which will blow if it overheats If this happens the iron won t work and must be returned for repair 16 Don t use the iron if it s dropped or damaged or if it malfunctions or leaks 17 If the cable is damaged return the iron to avoid hazard household use only BEFORE USING FOR THE FIRST TIME e The iron may smoke a bit at first it ll stop as the element cures e Iron an old piece of cotton fabric to clean the soleplate e Press the 5 and buttons 3 or 4 times to check them out 3 PREPARATION 1 Check for textile care symbols BA A EAA 2 Iron fabrics at low temperatures A first then medium temperatures A and finish with high temperatures ZA FILLING 3 You may use tap water but if you live in a hard water area use distilled water not chemically descaled or softened water 4 If you buy distilled water check that it s marketed as suitable for use in irons 5 Unplug the iron 6 Set the steam control to amp 7 Press the amp button and hold it in this opens the filling valve 8 Pour water into the heel till it starts to back up 9 Let the amp button go to close the valve and seal the reservoir 10 Tip excess water out of the heel into the sink or the filling jug 11 Wipe up any spillage SWITCH ON 12 Set the temperature con
6. trol to set the steam control to amp 13 Sit the iron on its heel 14 Put the plug into a power socket switch the socket on 15 Turn the temperature control to bring the setting you want next to the mark the light will come on 16 When the iron reaches the temperature you set the light will go off It ll then cycle on and off as the thermostat operates to maintain the temperature TEMPERATURE SETTING GUIDE label marking dot setting ZA cool nylon acrylics polyester ZA warm wool polyester mixtures eo ZA hot cotton linen denim e max ZX donotiron 3 If the instructions on the fabric label differ from this guide follow the instructions on the label REDUCING TEMPERATURE 17 This takes a bit longer as the iron has to lose the heat it has built up so be patient It s best to organise your ironing so that you don t need to reduce the temperature STEAM IRONING 18 Set the temperature control to amp or above otherwise you ll get water on your clothes not steam 19 Set the steam control to the level you want amp no steam high steam 20 Wait till the light goes out then start ironing 7A SPRAY 3 Water spotting affects some fabrics Test it on a hidden part of the fabric 21 The spray works with dry or steam ironing as long as there s water in the reservoir 22 Lift the iron off the fabric and aim the spray nozzle at the fabric 23 Press the
7. valve 42 Empty the reservoir via the heel into the sink 43 Release the amp button to close the valve and seal the reservoir 44 Sit the iron on its heel and leave it to cool down completely 45 Wipe off any moisture 46 Store the iron on its heel to avoid corrosion or soleplate damage ZA SELF CLEAN 47 To avoid scale build up self clean at least monthly in normal water areas more often in hard water areas 48 You ll need a basin or bowl to set below the soleplate 49 Fill the reservoir to the max mark 50 Set the temperature control to max set the steam control to amp 51 Sit the iron on its heel 52 Power the iron up and wait till the light goes out 53 Unplug the iron 54 Now hold the iron over the basin bowl with the soleplate down fro over the basin or bowl caution keep clear of the escaping water and steam 6 56 Water and steam will wash scale and dust through the soleplate and into the sink 58 Unplug the iron and sit it on its heel to cool 59 When it s cold wipe off any moisture CLEANING 60Unplug the iron and let it cool down fully 61 Wipe outer surfaces with a damp cloth 62 Remove spots from the soleplate with a dab of vinegar don t scratch it 63 Don t use harsh or abrasive cleaning agents or solvents ANTI SCALE 64 The anti scale agent incorporated in the iron helps prevent the build up of scale 65 Don t use a descaling solution or you ll destroy the anti sc
Download Pdf Manuals
Related Search