Truckfone Parts - Car Communications
Contents
1. lighter moving the gear stick operating the hand break etc Do not install the Phone in front of the vehicle s air bag This restriction must be adhered to as in the case of an emergency the air bag blows up and can fail to work properly Warning e Ensure the surface on which this Phone is installed is sufficiently strong to carry the weight and pressure which would be exerted on it e When selecting the Phone s location please ensure the control cable connected to it does not interfere with the vehicle or its accessories operation e Ensure it is safe and convenient to operate the Phone and read the display from the driver s seat Installation Instructions 6 TRUCKFONE e Ensure the Phone would be protected from direct sunlight and humidity air conditioner openings e Ensure the Phone would be protected from mechanical damage by the car s accessories Installing the Swivel mount and Phone 1 Disassemble the Swivel mount joint from its two base units 2 Install one of the Swivel mount base units in the determined location in the car with 4 tin screws 3 Install the second Swivel mount base unit on the Truckfone using the 4 philips screws provided with this kit Only use the original screws provided with this kit Note 4 Connect the Swivel mount joint to the two base units Adjust the angles Use the screws to connect the Swivel mount joint to the base units and2. the Speaker Where to Locate the Speaker Reminder The speaker and microphone installed on the sun visor above the driver must face different directions Note If the speaker and microphone face each other this will cause echo Do not hide the speaker inside the dash board Note If you cover it sound quality will be lowered e Locate the speaker at the right side of the main console at the front of the console in a location where it would not bother the driver or passengers but would sound best Installing the Speaker 1 Install the speaker at the right side of the main console at the front of the console Disassemble the screws connecting the speaker to the hanger Install the hanger using the 2 tin screws Direct the speaker cable behind the mat located at the bottom of the car Ensure the cable does not interfere with the vehicle or its accessories operation on aA VN Ensure the speaker cable is not exposed to damage by the passengers Installation Instructions 9 TRUCKFONE Installing the Electrical Connections The electrical cable is provided separately from the control cable Before installation begins connect the four leads which include the 3A fuses using a red or blue crimp sleeve as appropriate Please note sharp edges or moving parts which may damage the wires Warning The value for the fuses provided with the kits must not be changed The kit
3. ONE Plan the Microphone s Position e Install the Truckfone s microphone 30 40 cm away from where the driver speaks when he she is in their normal driving position e It is recommended to install the microphone on the right side of the sun visor away from the vehicle s window and from external sources of noise e Install the microphone in a different direction than the speaker so as to avoid echo Plan the Speaker s Position i Note The speaker and microphone installed on the sun visor above the driver must face different directions i Note Do not hide the speaker inside the dash board If you cover it sound quality will be lowered e Locate the speaker at the right side of the main console at the front of the console in a location where it would not bother the driver or passengers but would sound best Installation Instructions TRUCKFONE Installing the Swivel mount and Phone Truckfone Swivel mount TRUGE FONE LD lt gt gt 7 Where to Position Reminder The best way to determine the Phone s position to the customer s full satisfaction is to locate it when the customer is beside you and obtain Note his her agreement e Please ensure the Phone s location does not interfere with the vehicle or its accessories operation it should not interfere with opening the glove compartment or ashtray should not prevent access to the
4. TRUCKFONE Truckfone Parts AN Fuses Speaker Microphone Harness Swivel cable mount 4 RF antenna Ignition VCC Mute m GND Installation Instructions TRUCKFONE Table of contents Phone Bh 0 0 en ee err eT ee eer er eT ee re 3 Preplanned Accessory Positioning 2 ceceeeeeeeeeeeeeeeteeeeeeeeeeeeeees 4 Installing the Swivel mount and Phone eeeeeeeeeeeeeeeeeeeeeeeeeeeeeeees 6 Installing the MicroPhOne cceeeeeeeeeeecceeeeeeeeeeeeeeeaeeeeeeeeeeeenneneaeeees 8 Installing the Speaker eee cceceeeeeeeeseesecceeeeeeeeeeeeeeeaaeeeeeeeeeeeeeeeneseeeees 9 Installing the Electrical Connections ssssssseeeeseessessrerrnrensserrrrreseee 10 Installing the Cellular Antenna cccceeeeeeeeeeeeeeeeeeeeeeeeeeeeeenaeeees 12 WRGUBISSH GOING ashen sat ote cad ocd chaktic once ceandnaadeacmen dea necembidmaledecndnemdacing 14 Installation Instructions TRUCKFONE Phone Layout Display Navigation button Left soft button Right soft button End button Send button for dialing answering a call Zasc DEF Suk 6Gmno Stuy 9Iwxyz Volume keys SIM USIM slot Mini USB connector Installation Instructions TRUCKFONE Preplanned Accessory Positioning Positioning of all accessories must be planned in advance before installation begins e Ensure that no wire braids go through locations where Phone accessories are to be ins
5. enna base Check proper working order of antenna cable Replace antenna cable Other party User is not heard by the other party Check speaker s proper working order Replace speaker Check microphone and contacts cannot be A Phone problem may exist Replace Phone properly heard Check speaker location Change location Tighten microphone connector to the Phone Check routing of microphone cable Change routing of microphone cable Check microphone s proper working order Replace microphone A Phone problem may exist Replace Phone Noise is heard Ask whether noise always occurs in specific geographical areas Ask whether noise occurs when window is open Explain that reception trouble sometimes occurs in transition between cove rage areas Explain that the Phone is an amplifying system that receives all environmental noise and therefore it is preferable to speak with a closed window Check whether microphone and antenna are installed on the same side If they are install microphone as per the instructions Check whether eye contact exists between speaker and microphone If it does change location accordingly Check for improper voltage connection check whether voltages are connected as per instructions Change voltage source in accordance with instructions Phone switches on and off by Phone does not switch on after switching on car Check mi
6. fix the Swivel mount joint screw Installation Instructions 7 TRUCKFONE Installing the Microphone aarp a N zm The microphone is provided with a clip which makes it possible to install it on the sun visor Where to Locate the Microphone Reminder e Install the Truckfone s microphone 30 40 cm away from where the driver speaks when he she is in their normal driving position e lt is recommended to install the microphone on the right side of the sun visor away from the vehicle s window and from external sources of noise e Install the microphone in a different direction than the speaker so as to avoid echo and ensure there is a distance of at least 1 5 meters between them Installing the Microphone 1 Using the clip install the microphone on the right side of the sun visor 2 Direct the microphone cable along the sun visor behind it so as not to be seen 3 Continue directing the microphone cable along the left beam on the driver side 4 Direct the cable under the dash board to the connection point of the cable with the control cable connected to the Phone Ensure the microphone cable and antenna cable are kept away from each other Note Ensure the microphone cable is not in contact and does not interfere with the car pedals and steering wheel stick 5 Connect the microphone cable plug to the correct port on the control cable Installation Instructions 8 TRUCKFONE Installing
7. is appropriate only for a 12V vehicle In case of converting any other kit model into this kit please change the power cable The electrical cables should be directed as follows e So as not to disturb the driver or passengers e So as not to pass near the car s sharp or moving parts The external voltage connection is located under the dash board or close to the fuse box depending on the car model Note y In new vehicles a cellular phone connection can be found near the fuse box See the car s user s manual under Info Only use the kit s original fuses 250V 3A Installation Instructions 10 TRUCKFONE Installing the Voltage Cable The following chart covers the manner by which the voltage cable should be connected to the car s electrical system Wire Color Function Must be Ensure connected to Red To provide the 12V fixed voltage Ensure a 250V 3A Truckfone with Gonnectwith rad fuse is used fixed voltage fuse case which provided to a fixed voltage source Black To provide a fixed Car body minus Ensure the minus connection point is on the car body only Use a cable shoe tin screw and springy disc Green To turn on the IGN voltage Determine the cellular phone after Connect with correct point with a ee ih green fuse case voltmeter ignition on and turn olalta which provided Ensure a 250V 3A ignition is switched fuse i
8. na base toward the window Ensure all corners of the adapter are attached to the window and the antenna rod is in a vertical position Installing the Internal Adapter and Coaxial Cable 1 2 Carefully remove the clear plastic cover protecting the internal adapter Move the adapter on the inside of the window toward the antenna base the external adapter and direct the adapter so as to fully overlap the base Carefully press the antenna adapter to the window Ensure all adapter corners are attached to the window Direct the antenna s coaxial cable along the car beam Ensure the antenna cable does not get damaged Note Do not direct the microphone cable and antenna cable together on the same beam lintel 5 When completing the cable s installation and reaching close to the control cable connected to the Phone please leave approximately 30 cm of additional wire and cut off the unnecessary extra cable Press a UHF mini connector at the end of the cable Use the original plug and pressers only Examine the antenna and cable s proper working order with an efficiency meter Installation Instructions 13 TRUCKFONE Trouble Shooting Symptom No reception What to Check Check whether connector is correctly connected to the cable use an efficiency meter What to Do Replace connector Check if internal and external antenna base is correctly attached Attach ant
9. nus connection Black wire connect minus to car body Check fuse Check connection to voltage source green cable itself Check voltage contacts Tighten loose contacts Replace fuse Tighten connection to voltage source Ensure a 250V 3A fuse is used Phone does not switch off after switching off car Check connection to power source green cable Tighten connection to power source Phone does not switch on Check connection to power source Check fuse red cable Replace fuse Tighten connection to power source Installation Instructions 14
10. s used off Orange To mute the stereo Installation not Ensure the system when required connection is made accepting a call or only by an dialing authorized car stereo installation technician Installation Instructions TRUCKFONE Installing the Cellular Antenna Where to Locate the Cellular Antenna e The preferred location for the antenna is on the right side of the windshield e f a cell phone or other communication system is installed in the car please locate the antenna as far away as possible from the other Phone s antenna Some car models such as Renault Megan and Renault Kangoo feature a radiation filter on the windshield Therefore it is necessary to install the antenna on a side or back window Remember In vehicles with air bags on the beam where the antenna cable passes the antenna cable should be directed behind or beside the airbag Note Installation Instructions 12 TRUCKFONE Installing the Cellular Antenna Installing the External Adapter and Antenna Rod 1 Thoroughly clean the location intended for installation on both sides of window using a cloth and detergent Allow the spot to dry before you continue Carefully remove the clear plastic cover protecting the external adapter the antenna base Locate the adapter on the cleaned location Ensure the adapter is stably placed in a horizontal position parallel to the window border Carefully press the anten
11. talled e Ensure that any parts of the Truckfone will not interfere with the vehicle or its accessories operation Plan Phone and Swivel mount Positions The best way to determine the Phone s position to the customer s full satisfaction is to locate it when the customer is beside you and obtain his her approval Note e Please ensure the Phone s location does not interfere with the vehicle or its accessories operation it should not interfere with opening the glove compartment or ashtray should not prevent access to the lighter moving the gear stick operating the hand break etc Do not install the Phone in front of the vehicle s air bag This restriction must be adhered to as in the case of an emergency the air bag blows up and can fail to work properly Warning e Ensure the surface on which this Phone is installed is sufficiently strong to carry the weight and pressure which would be exerted on it e When selecting the Phone s location please ensure the control cable connected to it does not interfere with the vehicle or its accessories operation e Ensure it is safe and convenient to operate the Phone and read the display from the driver s seat e Ensure the Phone would be protected from direct sunlight and humidity air conditioner openings e Ensure the Phone would be protected from mechanical damage by the car s accessories Installation Instructions 4 TRUCKF
Download Pdf Manuals
Related Search