INSTRUCTION MANUAL Water Dispenser
Contents
1. is not set correctly The water dispenser does not have the correct clearances Vibrations The water dispenser seems to make too much The rattling noise may come from the flow of the noise refrigerant which is normal As each cycle ends you may hear gurgling sounds caused by the flow of refrigerant in your water dispenser Contraction and expansion of the inside walls may cause popping and crackling noises The water dispenser is not level until air is released into the bottle Water is boiling in the hot tank and bubbling up into the bottle Press the hot dispenser button until water flows to remove air from the hot tank WIRING DIAGRAM 88 C Heater 4 Red Cooling Thermostat Overload Protector Be 17 l Compressor JS 95 c2. INSTRUCTION MANUAL Water Dispenser HLM 109B BEFORE USE PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS Important Safety Instructions MN WARNING Y To reduce the risk of fire electrical shock or injury when using your appliance follow these basic precautions Read all instructions before using the water dispenser Never clean parts with flammable fluids The fumes can create a fire hazard or explosion Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or any other water dispenser The fumes can create a fire hazard or explosion To avoid a hazard due to instability of the appliance it must be fixed in according with the structions INSTALLATION GUIDELINES Remove the exterior and interior packing Place your appliance on a floor that is strong enough to support the dispenser when it is fully loaded The unit is provided with four plastic feet if it does not sit level on the floor adjust the front feet to level the unit well to the floor Locate the appliance away from direct sunlight and sources of heat stove heater radiator etc Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption Extreme cold ambient temperatures may also cause the appliance not to perform properly Allow 2 inches of space between the water dispenser and the wall which allows for proper air circulation to cool the compressor
3. This water dispenser is not recommended for outdoor use Do not locate the dispenser in area where the temperature may fall below freezing 32 F Keep area around dispenser free of dust and dirt Keep the reserve supply of water bottles away from excessive heat and light Never unplug the water cooler except for maintenance OPERATION INSTRUCTIONS Before Using Your Water Dispenser Before connecting the appliance to the power source let it stand upright for approximately 2 hours This will reduce the possibility of a malfunction in the cooling system from handling during transportation The water dispenser is pre cleaned at the factory but the reservoir and water lines must be flushed with fresh water before use as follows Keep the unit unplugged Fill water tank with tap water full to capacity Wait for 5 minutes until water settles Slide child safety button then push the hot water faucet until water comes out then stop Plug the dispenser into the electrical outlet We are ready to complete the first cycle In order to do that wait for the hot water to reach temperature in approximately 10 minutes and then wait for the cold to reach temperature another 40 minutes approximately Unplug the dispenser from the electrical outlet Proceed to drain the water from the faucets one at a time until no more water remains Note To facilitate this operation use a large container Then drain any water left in the tanks by opening
4. its service agent or similarly qualified persons in order toavoid a hazard MAINTENANCE O Remove power plug or disconnect from the mains before performing any maintenance or servicing the product Never use detergent or chemicals harmful to health to clean the water tanks Do not directly spray water on the surface of the product Wipe the front and back of the product with water soaked soft cloth If dust of other exterior substance has accumulated on the condenser wipe off with water soaked soft cloth After cleaning the product completely dry it Fill the water to the tanks until waters comes out of the hot water faucet then connect the electric power plug If the surface of the electric heater in the hot water tank is deposited by water deposition heating capacity will decrease Fill hot water tank with aqueous solution of 2 aitric acid and keep for about two hours then cleaning If the problems can not be solved contact your dealer or the Service Center of our company TROUBLESHOOTING GUIDE Water dispenser does not operate Not plugged in The circuit breaker tripped or a blown fuse Water cooler is not cold enough Check to be sure the cold switch on the back is ON The water dispenser does not have the correct clearances Water dispenser hot water is not hot enough Check to be sure the hot switch on the back is ON Compressor turns on and off frequently The room temperature is hotter than normal The temperature control
5. n 4 full cups of water to insure the water flows properly and the water reservoir is at the proper level TAKING DISPENSER OUT OR SERVICE Ifthe water dispenser will not be used for a long period of time unplug the power supply cord e Turn off the hot water Drain the water through the faucets O Drain the water from tanks by drainage hole from the back of the dispenser CAUTION e Do not use the bottle with any crack leakage or holes O The back of the product should be put in shady places and kept away from wall and high temperature elements Please also put the product away from TV video or other valuables Do not turn on heating switch until water comes out of hot water faucet to prevent any damage on the heating tube Do not turn on and off the cooling switch in three minutes to protect the compressor and extend the compressor usage life During operation keep it beyond the children to avoid scald Never turn on the heating switch when there is no water When carrying it the angle of inclination should be less than 45 Adopt the ground wire to avoid any electric shock In the process of using check the water receptacle frequently If the water receptacle is full please pour the water out in time This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or i
6. nstruction concerning use of the appliance by a person responsible for their safety WARNING Do not use mechanical devices or other means to accelerate the defrosting process other than those recommended by the manufacturer WARNING Do not damage the refrigerant circuit WARNING Do not use electrical appliances inside the food storage compartments of appliance unless they are ofthe type recommended by the manufacturer WARNING To avoid a hazard due to instability of the appliance it must be fixed in accordance with the instructions INSTALLATION INSTRUCTIONS I UL II 11111 H H H H 1 2 3 In order to ensure the water dispenser with enough stability users should follow below instructions to fix the unit 1 Remove one of the body rear s screw upper right corner or upper left corner Picture 1 2 Install a bracket where you have removed the screw already fix the bracket tightening the removed screw on the right location Picture 2 3 Fix the bracket on the wall side or similar object 1f the wall side is too rigidity you can make a hole by electric drill then using expanded screw tightening the bracket Picture 3 4 Children should be supervised to ensure that they do not play with the appliance 5 Household used only 6 Do not store explosive substances such as aerosol cans with flammable propellant in this appliance e 7 Ifthe supply cord is damaged it must be replaced by the manufacturer
7. the drain plug located on the back until it drains completely Proceed to close the drain cap Remove the cap from the 5 gallon bottle and use a clean cloth to wipe off the neck of the bottle Place the 5 gallon bottle of water on the water intake allow water to stand for approximately one minute Push water faucet buttons to insure water flows from both faucets Plug dispenser back into the electrical outlet Now you are ready to use your water dispenser NOTE Your water dispenser has been cleaned and sanitized before leaving the factory but in case a taste problem develops place two tablespoons of baking soda and add tap water Fill water tank again and repeat basic operations previously outlined except turn hot water function OFF to avoid leaving residues in hot water tank ATTENTION If you do not plan to use the water heating function for more than three days we recommend that you turn off the hot water function OPERATING YOUR WATER DISPENSER Steps To Replace Water Bottles Remove cap Use a clean cloth to wipe off neck of bottle Carefully lift bottle approx 40 Ibs using your legs and not your back Do not place hands on opening of bottle while placing in reservoir Insert the water bottle on the water intake over reservoir opening so it settles properly on it Wipe off any water which may have splashed on dispenser top When a new bottle is installed you must open the hot water faucet and remove no less tha
Download Pdf Manuals
Related Search